Rate Redetermination for Market Change In the event of delay or interruption, exceeding 90 days, under B8.33, Contracting Officer shall make an appraisal to determine for each species the difference between the appraised unit value of Included Timber immediately prior to the delay or interruption and the appraised unit value of Included Timber immediately after the delay or interruption. The appraisal shall be done after any rate redetermination done pursuant to B3.31, using remaining volumes. Tentative Rates and Flat Rates in effect at the time of delay or interruption or established pursuant to B3.31 will be reduced, if appraised rates declined during the delay or interruption, to become Current Contract Rates. Increases in rates will not be considered. Accordingly, Base Rates shall be adjusted to correspond to the redetermined rates if redetermined rates are less than the original Base Rates, subject to a new Base Rate limitation of the cost of essential reforestation or 25 cents per hundred cubic feet or equivalent, whichever is larger. However, existing Base Indices shall not be changed under this Subsection. Redetermined rates shall be considered established under B3.1 for timber Scaled subsequent to the delay or interruption.
Penalty Determination H&SC section 39619.7 requires CARB to provide information on the basis for the penalties it seeks. This Agreement includes this information, which is also summarized here. The provision of law the penalty is being assessed under and why that provision is most appropriate for that violation. The penalty provision being applied in this case is H&SC section 42402 et seq. because IIT sold, supplied, offered for sale, consumer products for commerce in California in violation of the Consumer Products Regulations (17 CCR section 94507 et seq.). The penalty provisions of H&SC section 42402 et seq. apply to violations of the Consumer Products Regulations because the regulations were adopted under authority of H&SC section 41712, which is in Part 4 of Division 26. The manner in which the penalty amount was determined, including aggravating and mitigating factors and per unit or per vehicle basis for the penalty. H&SC section 42402 et seq. provides strict liability penalties of up to $10,000 per day for violations of the Consumer Product Regulations with each day being a separate violation. In cases like this, involving unintentional violations of the Consumer Products Regulations where the violator cooperates with the investigation, CARB has obtained penalties for selling uncertified charcoal lighter material in California. In this case, the total penalty is $7,500 for selling uncertified charcoal lighter material in California. The penalty in this case was reduced because this was a strict liability first-time violation and IIT made diligent efforts to cooperate with the investigation. To come into compliance, IIT no longer offers Safegel BBQ & Fireplace Lighting Gel Fire Starter for commerce in California. Final penalties were determined based on the unique circumstances of this matter, considered together with the need to remove any economic benefit from noncompliance, the goal of deterring future violations and obtaining swift compliance, the consideration of past penalties in similar negotiated cases, and the potential cost and risk associated with litigating these particular violations. The penalty reflects violations extending over a number of days resulting in quantifiable harm to the environment considered together with the complete circumstances of this case. Penalties in future cases might be smaller or larger on a per ton basis. The final penalty in this case was based in part on confidential financial information or confidential business information provided by IIT that is not retained by CARB in the ordinary course of business. The penalty in this case was also based on confidential settlement communications between CARB and IIT that CARB does not retain in the ordinary course of business. The penalty also reflects CARB’s assessment of the relative strength of its case against IIT, the desire to avoid the uncertainty, burden and expense of litigation, obtain swift compliance with the law and remove any unfair advantage that IIT may have secured from its actions. Is the penalty being assessed under a provision of law that prohibits the emission of pollution at a specified level, and, if so a quantification of excess emissions, if it is practicable to do so. The Consumer Product Regulations do not prohibit emissions above a specified level, but they do limit the concentration of VOCs in regulated products. In this case, a quantification of the excess emissions attributable to the violations was not practicable.
Determination of Fair Market Value For purposes of this Section 10.2, “fair market value” of a share of Common Stock as of a particular date (the “Determination Date”) shall mean:
Non pre-priced Adjustment Factor To be applied to Work deemed not to be included in the CTC but within the general scope of the work:
Cost of Additional Review The Design Professional shall be responsible for an initial and one subsequent review of the Submittal. Where the subsequent Submittal is not accepted due to noncompliance with the Contract Documents, the Contractor shall be responsible for payment for the additional time required by the Design Professional to complete the Submittal review.
Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) 1/10th) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine Xxxxxxxx mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.
Change in pension value This is the change in present value of defined benefit and actuarial pension plans.
Rate Redetermination for Environmental Modification In the event of a contract modification under B8.33 or partial termination under B8.34, Contracting Officer shall make an appraisal to determine for each species the difference between the appraised unit value of Included Timber remaining immediately prior to the revision and the appraised unit value of Included Timber to be cut under the modification. The appraisal shall consider the estimated cost of any construction work listed in the Schedule of Items that was performed and abandoned. Tentative Rates and Flat Rates in effect at the time of the revision will be adjusted by said differences to become Current Contract Rates. Accordingly, Base Rates shall be adjusted to correspond to the redetermined rates if redetermined rates are less than the original Base Rates, subject to a new Base Rate limitation of the cost of essential reforestation or 25 cents per hundred cubic feet or equivalent, whichever is larger. However, existing Base Indices shall not be changed under this Subsection. Redetermined rates, or differences for rates subject to B3.2, and Required Deposits shall be considered established under B3.1 for timber Scaled subsequent to the contract revision.
Price Adjustment Civil works contracts of long duration (more than 18 months) shall contain an appropriate price adjustment clause.
Determination of One-Month LIBOR Pursuant to the terms of the Global Agency Agreement, the Global Agent shall calculate the Class Coupons for the applicable Classes of Notes (including MAC Notes on which the Exchange Administrator has directed the Global Agent to make payments) for each Accrual Period (after the first Accrual Period) on the applicable LIBOR Adjustment Date. “One-Month LIBOR” will be determined by using the “Interest Settlement Rate” for U.S. dollar deposits with a maturity of one month set by ICE Benchmark Administration Limited (“ICE”) as of 11:00 a.m. (London time) on the LIBOR Adjustment Date (the “ICE Method”). ICE’s Interest Settlement Rates are currently displayed on Bloomberg L.P.’s page “BBAM.” That page, or any other page that may replace page BBAM on that service or any other service that ICE nominates as the information vendor to display the ICE’s Interest Settlement Rates for deposits in U.S. dollars, is a “Designated Page.” ICE’s Interest Settlement Rates currently are rounded to five decimal places. If ICE’s Interest Settlement Rate does not appear on the Designated Page as of 11:00 a.m. (London time) on a LIBOR Adjustment Date, or if the Designated Page is not then available, One-Month LIBOR for that date will be the most recently published Interest Settlement Rate. If ICE no longer sets an Interest Settlement Rate, Freddie Mac will designate an alternative index that has performed, or that Freddie Mac (or its agent) expects to perform, in a manner substantially similar to ICE’s Interest Settlement Rate.
