GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site.
Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer.
Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations.
Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage.
Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer.
Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized.
Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel.
Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations.
Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job.
Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours.
Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement.
Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
General Conditions Costs Contractor is entitled to receive payment for the actual cost of the allowable General Conditions items incurred after receipt of a Notice to Proceed with Construction from Owner through Substantial Completion of the Project, plus 30 calendar days. Contractor is not entitled to reimbursement for General Conditions Costs incurred before receipt of the Notice to Proceed. General Conditions Costs incurred after Substantial Completion, plus 30 calendar days, must be approved in advance by Owner. Allowable General Conditions items are identified below and in Exhibit “D” attached to this Agreement. These items shall be included in the General Conditions Cost amount shown as a line item in the Guaranteed Maximum Price Proposal and as detailed on the Schedule of Values. Items not specifically included below or in Exhibit “D” will not be allowed as General Condition Costs.
Conditions to Obligation of the Company The obligation of the Company to effect the Merger is also subject to the satisfaction or waiver by the Company at or prior to the Effective Time of the following conditions:
Conditions to the Obligation of the Company The respective obligations of the Company, NewCo and Merger Sub to complete the transactions contemplated by this Agreement are subject to the satisfaction of, or compliance with, on or before the Closing Date, each of the following conditions (any of which may be waived by the Company, in whole or in part):
(a) The representations and warranties of Parent and the Purchaser in Section 7 shall be true and correct (without giving effect to any “materiality” or “material adverse effect” qualifiers contained therein) as of the date of this Agreement and as of the Closing (except to the extent any such representation or warranty speaks as of the date of this Agreement or any other specific date, in which case such representation or warranty shall have been so true and correct as of such date), except where the failure to be true and correct would not, individually or in the aggregate, have a material adverse effect on the ability of Parent and the Purchaser to consummate timely the transactions contemplated by this Agreement;
(b) All of the covenants and agreements Parent or the Purchaser are required to perform or comply with under this Agreement on or before the Closing Date shall have been duly performed and complied with in all material respects;
(c) Each of the Commercial Agreements (other than the New Company Distribution Agreements and the Acquired KO Brand Distribution Agreements) shall have been duly executed by Parent, the Purchaser or their Subsidiaries, as applicable, and shall be in full force and effect as of the Closing Date;
(d) All of the conditions to the Company’s obligations under Sections 8.1 and 8.3 (other than Section 8.3(f)) of the Asset Transfer Agreement shall have been satisfied or waived (other than those conditions that by their nature can only be satisfied at the Closing, but subject to the satisfaction or waiver of such conditions at the Closing), and the consummation of the transactions contemplated by the Asset Transfer Agreement shall occur concurrently with the Closing; provided, however, that the Company shall not have the right to assert that the foregoing condition set forth in this Section 10.3(d) has not been satisfied if the failure to satisfy such condition results primarily from the Company or NewCo’s failure to perform or comply with its obligations under the Asset Transfer Agreement; and
(e) The Company shall have received an opinion of Xxxxx Day, on the basis of certain facts, representations and assumptions set forth in such opinion, dated the Closing Date, to the effect that for U.S. federal income tax purposes the exchanges that occur pursuant to the Merger, the acquisition and issuance of the Shares and the KO Asset Transfer, taken together, shall constitute exchanges described in Section 351 of the Code. In rendering such opinion, such counsel shall be entitled to receive and rely upon representations of officers of NewCo, the Company, Parent and the Purchaser as to such matters as such counsel may reasonably request.
Additional Conditions to Obligation of the Company The obligation of the Company to effect the Merger is also subject to the following conditions:
Condition of the Contractor’s Property or Equipment The Contractor shall make the Property and/or equipment available to the Judicial Council, pursuant to the terms and conditions set forth in this Agreement. The Contractor shall immediately remedy any problem with the Property’s physical plant or equipment that impairs or diminishes the quality of the Program. The Contractor shall ensure the appropriate hot water, heating, and ventilation is provided at the Property during the Program, inclusive in the prices set forth herein.
Additional Conditions to the Obligations of the Company The obligation of the Company to consummate and effect the Merger shall be subject to the satisfaction at or prior to the Closing Date of each of the following conditions, any of which may be waived, in writing, exclusively by the Company:
Conditions to Obligations of Each Party Under This Agreement The respective obligations of each party to effect the Merger and the other transactions contemplated herein shall be subject to the satisfaction at or prior to the Effective Time of the following conditions, any or all of which may be waived, in whole or in part, to the extent permitted by applicable Law:
Additional Conditions to Obligations of the Company The obligations of the Company to consummate the Merger and the transactions contemplated by this Agreement shall be subject to the satisfaction at or prior to the Closing of each of the following conditions, any of which may be waived, in writing, exclusively by the Company:
Continued Operations Instrument Registry Operator shall comply with the terms and conditions relating to the Continued Operations Instrument set forth in Specification 8 attached hereto (“Specification 8”).
