Compliance with Rules and Regulations PFPC undertakes to comply with all applicable requirements of the Securities Laws and any laws, rules and regulations of governmental authorities having jurisdiction with respect to the duties to be performed by PFPC hereunder. Except as specifically set forth herein, PFPC assumes no responsibility for such compliance by the Fund or any other entity.
Compliance with Laws, Rules and Regulations Tenant, at its sole cost and expense, shall comply with all laws, ordinances, orders, rules and regulations of state, federal, municipal, or other agencies or bodies having jurisdiction over use, condition, and occupancy of the Leased Premises. Tenant must use and maintain the Leased Premises in a clean, careful, safe, and proper manner and in compliance with all Applicable Laws, including Applicable Laws pertaining to health, safety, disabled persons, and the environment; provided, however, that Tenant shall not be required to make any structural changes or repairs to the Leased Premises unless the need for such structural changes or repairs is caused by Tenant, its agents, employees, invitees, or others for whom Tenant is responsible pursuant to the terms and provisions of this Lease. Notwithstanding anything to the contrary contained elsewhere in this section, it is expressly agreed and understood that Tenant’s obligation to comply with all Applicable Laws does not apply to any violations of Applicable Laws that (a) were in effect and (b) were being violated or with which the Leased Premises was not in compliance immediately prior to the time Tenant accepted the Leased Premises, including without limitation any existing environmental contamination. Tenant will comply with the rules and regulations of the Leased Premises adopted by Landlord in its reasonable discretion. All such rules and regulations and changes and amendments thereto will be sent by Landlord to Tenant in writing and shall thereafter be carried out and observed by Tenant.
Compliance with Standards Although the standards for workmanship, material, and equipment have been selected in these specifications as a basis of reference, standards and specifications of the other bank member countries and recommendations of standards international organizations will be acceptable provided they are substantially equivalent to the designated standards and provided furthermore that the contractor submits for approval detailed specifications which he proposes to use. Reference to brand names or catalog numbers if any in these specifications have been made only for that equipment for which it has been determined that a degree of standardization is necessary to maintain certain essential features. And in certain cases such references have also been made for purposes of convenience to specify the requirements, in either case offers of alternative goods, which have similar characteristics and provide performance and quality at lease equal to those specified are acceptable. If the contractor offers materials, equipment, design calculations or tests, which conform to standards other than those specified, full details of the differences between the proposed standards and that specified in so far as they affect the design or purpose of the equipment, are to be supplied by the contractor if called upon to do so by the engineer, where required by the engineer for approval purposes, the contractor shall supply, without charge, duplicate copies of the proposed standards with English translations of the relevant portions. The contractor shall have available in his place of business (or in his supplier’s works) the relevant copies of standards or codes used for the use of the Engineer.
COMPLIANCE WITH FEDERAL LAWS AND REGULATIONS Contractor, to the extent applicable to this Agreement, shall comply with the following Federal laws and regulations as set forth in 24 CFR §§570.600-612:
Compliance with Accessibility Standards All parties to this Agreement shall ensure that the plans for and the construction of all projects subject to this Agreement are in compliance with standards issued or approved by the Texas Department of Licensing and Regulation (TDLR) as meeting or consistent with minimum accessibility requirements of the Americans with Disabilities Act (P.L. 101-336) (ADA).
Compliance with Rules To comply with, and to require the Contractors to comply with, all rules, regulations, ordinances and laws bearing on the conduct of the work on the Improvements, including the requirements of any insurer issuing coverage on the Project and the requirements of any applicable supervising boards of fire underwriters.
Compliance with Federal Requirements Federal money will be used or may potentially be used to pay for all or part of the goods, construction or services under the Contract. The Contractor is responsible for compliance with all federal requirements imposed on the funds and accepts full financial responsibility for any requirements imposed by the Contractor’s failure to comply with federal requirements. Certification regarding Debarment, Suspension, Ineligibility, and Voluntary Exclusion. Federal money will be used or may potentially be used to pay for all or part of the work under the Contract, therefore Contractor certifies that it is in compliance with federal requirements on debarment, suspension, ineligibility and voluntary exclusion specified in the solicitation document implementing Executive Order 12549. Contractor’s certification is a material representation upon which the Contract award was based. Contingency Fees Prohibited.
Compliance with Statutes The Borrower and its Subsidiaries are in compliance in all material respects with all applicable statutes, regulations and orders of, and all applicable restrictions imposed by, all governmental bodies and have all necessary permits, licenses and other necessary authorizations with respect to the conduct of their businesses and the ownership and operation of their properties except where the failure to so comply or hold such permits, licenses or other authorizations could not reasonably be expected to have a Material Adverse Effect.
Compliance with Terms and Conditions Registrar shall comply with each of the following requirements, and further shall include in its registration agreement with each Registered Name Holder, as applicable, an obligation for such Registered Name Holder to comply with each of the following requirements:
Compliance with Applicable Laws and Regulations (a) The Company shall not be required to issue or deliver any Shares pursuant to this Agreement pending compliance with all applicable federal and state securities and other laws (including any registration requirements or tax withholding requirements) and compliance with the rules and practices of any stock exchange upon which the Company’s Shares are listed.
