INSTALLATION AND REMOVAL Show Management reserves the right to fix the time for the installation of a booth prior to the Show opening and for its removal after the conclusion of the Show. Installation of all exhibits must be fully completed by the opening time of the exposition. Any space not claimed and occupied three hours prior to opening, may be resold or reassigned without refund. No exhibitor will be allowed to dismantle or repack any part of his exhibit until after the closing of the Show. 6.
Installation and Use You may install and use the Software only for the number of licenses acquired by you. In order to exercise your rights to the Software under this Agreement, you must activate your copy of the Software in the manner described during the launch sequence.
Delivery and Installation Delivery
Fixtures and Alterations After taking occupancy of the Designated Space, AGENCY shall not, without the COUNTY’S prior written consent, attach any fixtures in or to the Designated Space or change, alter, or make additions to the Designated Space, nor attach or affix any article hereto, nor permit any annoying sound device, overload any floor, or deface the Designated Space. Such prior written consent shall not be unreasonably withheld. Where the COUNTY has approved AGENCY’S modifications to the Designated Space, the AGENCY shall only be required to remove its modifications and restore the Designated Space to its original condition upon the AGENCY’S vacating of the Designated Space should the COUNTY’S approval make such restoration a requirement of its approval. If, however, AGENCY elects to remove its modifications upon vacating the Designated Space, then AGENCY, at its expense, shall restore the Designated Space to its original condition, ordinary wear and tear excepted.
Installations 2.1. This test shall be conducted with either the complete REESS or with a related REESS subsystem(s) including the cells and their electrical connections. If the manufacturer chooses to test with related subsystem(s), the manufacturer shall demonstrate that the test result can reasonably represent the performance of the complete REESS with respect to its safety performance under the same conditions. If the electronic management unit for the REESS is not integrated in the casing enclosing the cells, then the electronic management unit may be omitted from installation on the Tested-Device if so requested by the manufacturer.
Installation and Use Rights You may install and use any number of copies of the software on your devices.
Electrical Installations 3.1 Wiring and accessories for lighting of Common Areas.
Changes and Alterations (a) All matters in this agreement not specified in Subsection 10(b) below are non-substantive matters which may be changed or altered without a public hearing, but with the written consent of Town Council, provided that Town Council determines that the changes do not significantly alter the intended effect of this agreement.
No alterations No alterations or additions may be made to the premises nor may any fixtures be installed or placards, decorations or other articles be attached in any way to any part of the premises without the prior written approval of the Village Hall Secretary. Any alteration, fixture or fitting or attachment so approved shall at the discretion of the Village Hall remain in the premises at the end of the hiring. It will become the property of the Village Hall unless removed by the Hirer who must make good to the satisfaction of the Village Hall any damage caused to the premises by such removal.
Licenses for Permanent Installation The contractor must comply with all State mandatory licensing requirements prior to installation. Questions on licensing requirements should be directed to the State Licensing Board. Contractor must furnish and install all furniture and materials in compliance with all applicable codes, whether local, state, or federal; and that all permits or licenses required for installation will be obtained without cost to the State.
