Quantities to be measured Sample Clauses

Quantities to be measured. These refer to the mechanical load magnitudes, WT operational as well as the wind inflow parameters (Table 3-1). In the standard it is recognized that some of the wind turbine operational parameters might be provided by the control system of the wind turbine, provided that they comply with the accuracy specifications outlined in the standard. The document is not restrictive but sets the fundamental load magnitudes to be the blade root, rotor and tower loads. Furthermore, depending to the criticality of the safe operation of the WT, to be judged by the certification body or the manufacturer, the load magnitudes to be measured should be extended, accordingly. It must be noted that there are magnitudes that are recommended to be measured (i.e. wind shear or temperature gradient) in order to characterize the specific campaign, without proposing any specific processing procedure, based on these parameters. Judging from the above, if one wants to classify the load measurements performed for the validation of the sub-components addressed within the PROTEST project, these could be set as follows:
Sample 1
AutoNDA by SimpleDocs

Related to Quantities to be measured

  • Packaging Materials and Containers for Retail Sale Packaging materials and containers in which a good is packaged for retail sale shall, if classified with the good, be disregarded in determining whether all the non-originating materials used in the production of the good undergo the applicable change in tariff classification set out in Annex 4, and, if the good is subject to a regional value-content requirement, the value of such packaging materials and containers shall be taken into account as originating or non-originating materials, as the case may be, in calculating the regional value content of the good.

  • Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.

  • Standard Service Features Ethernet Access allows Customer to terminate single and/or multiple Ethernet Virtual Circuits (EVCs) from Customer equipment onto a single Ethernet Access UNI.

  • Usage Measurement Usage measurement for calls shall begin when answer supervision or equivalent Signaling System 7 (SS7) message is received from the terminating office and shall end at the time of call disconnect by the calling or called subscriber, whichever occurs first.

  • Corrective Measures If the Participating Generator fails to meet or maintain the requirements set forth in this Agreement and/or the CAISO Tariff, the CAISO shall be permitted to take any of the measures, contained or referenced in the CAISO Tariff, which the CAISO deems to be necessary to correct the situation.

  • Method of Measurement The harmonics emission on AC power lines generated by the vehicle representative of its type shall be measured using the method described in Annex 11. The method of measurement shall be defined by the vehicle manufacturer in accordance with the Technical Service.

  • Escorting Visitors Visitors to areas where PHI COUNTY discloses to 4 CONTRACTOR or CONTRACTOR creates, receives, maintains, or transmits on behalf of COUNTY is 5 contained shall be escorted and such PHI shall be kept out of sight while visitors are in the area.

  • System for Award Management (XXX) Requirement Alongside a signed copy of this Agreement, Grantee will provide Florida Housing with a XXX.xxx proof of registration and Commercial and Government Entity (CAGE) number. Grantee will continue to maintain an active XXX registration with current information at all times during which it has an active award under this Agreement.

  • Safety Measures Awarded vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Awarded vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage.

  • CORRECTIVE MEASURE The contractor shall repair any deficiencies in excess of the performance guideline.

Time is Money Join Law Insider Premium to draft better contracts faster.