RabbitMQ Server Sample Clauses

RabbitMQ Server. No additional configuration is necessary during the installation process according to the official guideline. Afterwards, the management plugin needs to be activated, which is described in 4.2.7. When the management plugin is enabled, login to the server using one of the mentioned remote access program, make sure that the RabbitMQ Server is started and navigate with a web browser to xxxx://xxxxxxxxx:00000 and login with the default user:password pair guest:guest. Note that this login is only available, when the server is accessed locally! Next, add a new user with the user:pass pair miraculouslife:miraculouslife, give it administrator privileges and access to the default virtual host “/”. Note that since RabbitMQ is only used in a local network environment, the RabbitMQ server must not be accessible from the internet. Therefore it is suggested to block the ports 15672 and 5672 in your firewall for the internet connection.

RabbitMQ Server. No additional configuration is necessary during the installation process according to the official guideline. After successful installation, a user miraculouslife (with password miraculouslife) and two virtual hosts must be created for the RabbitMQ server. This can be done by using the management plugin for RabbitMQ. To do so, open the command line (cmd) and navigate to the folder where rabbitmq-plugins.bat file is located (by default it is in “C:\Program Files (x86)\RabbitMQ Server\rabbitmq_server-3.5.1\sbin”). Then execute this command: rabbitmq-plugins enable rabbitmq_management If it is executed successfully, messages saying that some of the plugins are enabled/activated will be displayed. Then, open the following address on the browser: localhost:15672. If it does not show anything, try the troubleshooting below. Troubleshooting: If the localhost:15672 does not open, try to restart the rabbitmq-server: rabbitmqctl stop rabbitmq-server start Then try to open the address again on the browser. Once the address opens successfully, login to the web interface (username: guest, password: guest). Click on Admin tab and select Users from the menu on the right side. Under the “Add user” section, add a new user as shown in figure below: Username: miraculouslife Password: miraculouslife Tags: admin (administrator) Figure 2: Adding a new user at the RabbitMQ server Then click on “Virtual Hosts” from the menu on the right side. And add two virtual hosts: 1 and 2.