Raising and Lowering Device Sample Clauses

Raising and Lowering Device. Each mast shall be equipped with a three-point hoisting mechanism, consisting of three 6mm diameter suspension ropes of stainless steel 7/19 construction, running over three pairs of Aluminium pulleys on the head frame of the mast running on shafts manufactured from Stainless steel. The complete pulley assembly must be enclosed with a corrosion proof top cover, fixed with a bolt incorporating a lightning arrester, to prevent ingress of water all split pins, bolts, nuts and washers shall be of stainless steel. Pulley shafts shall be positively prevented from rotating in their housings. Two Rope systems shall not be considered. The luminaire carriage shall be drawn against three inverted cones to ensure level positioning of the fittings in the operating position. The hoisting ropes, which will remain under tension at all times, shall terminate inside the mast on a clevis plate, to which the rope of the hoisting unit can be connected or to which, when in the raised position, the locking device can be attached. The locking device shall be secured to a structurally sound member of the mast base. The other ends of the hoisting ropes shall be firmly secured to the luminaire carriage. Rope ends shall not be secured by Xxxxxx clamps and only "Talurit" type ferrules of compatible material shall be used. In addition, a safety chain shall be provided between the clevis plate and a structurally sound member of the mast base. All fasteners connected with the raising and lowering device shall be secured by Nylok type nuts or stainless steel split pins. The raising and lowering gear must, in complete safety, facilitate the raising and lowering of the floodlight luminaire carriage for maintenance purposes by means of a portable winch. A 12mm diameter earthing stud must be welded to the inside casing of the mast adjacent to the cable termination box. The stud shall be provided with two washers and a nut. The top pulley assembly must have guides and docking stops designed and constructed in such a way that the luminaire ring is always in the same position after raising it to the top of the mast and that jamming of the ring is prevented. One end of the wire rope in the bottom of the mast must be attached to the rope lock bar in such a manner that accidental lowering of the luminaire ring, without the use of the winch, is not possible.
AutoNDA by SimpleDocs

Related to Raising and Lowering Device

  • Xxxxxx Limitation The Service reserves the right to refuse to pay any Xxxxxx to whom you may direct a payment. As required by applicable law, the Service will notify you promptly if it decides to refuse to pay a Xxxxxx designated by you. as set forth in Section 13 of the General Terms (Prohibited Payments) or an Exception Payment under this Agreement.

  • XXXXXXXX AND W XXXXXXX XXXXXX

  • XXXXXAS xx xxcordance xxxx Xxxx 00x-1(k) xxder the Securities Exchange Act of 1934 (the "Act"), only one statement containing the information required by Schedule 13G and any amendments thereto need be filed whenever two or more persons are required to file such a statement or any amendments thereto with respect to the same securities, provided that said persons agree in writing that such statement or any amendment thereto is filed on behalf of them.

  • Xxxxxx, Esq Anyone to whom a notice may be given under this Agreement may designate a new address by notice to that effect given to the other party in accordance with this subsection (b). Each such notice shall be deemed given upon the receipt thereof when delivered in person and on the second business day after the mailing when sent by mail as aforesaid. (c) You understand that, upon exercise of this Option, you may recognize income for tax purposes in an amount equal to the excess of the then fair market value of the Shares purchased over the Option Price for such Shares. Your employer may withhold tax from your current compensation with respect to such income or any other income which it deems you to have received in connection therewith; to the extent that your then current compensation is insufficient to satisfy the withholding tax liability, you will be required to make a cash payment to cover such liability as a condition of exercise of this Option. (d) If this Option shall be mutilated, lost, stolen or destroyed, the Company shall issue in exchange and substitution for and upon cancellation of the mutilated Option, or in lieu of and in substitution for the Option lost, stolen or destroyed, a new Option of like tenor and denomination, but only upon receipt of evidence satisfactory to the Company of such loss, theft or destruction of such Option and such indemnity and, if requested by the Company, such bond, as shall in each case be satisfactory to the Company. You must also comply with such other reasonable requirements and pay such other reasonable charges as the Company may prescribe in connection with such issuance. (e) This Option shall be governed and construed in accordance with the substantive laws of the State of New York applicable to contracts executed, delivered and to be fully performed in the State of New York, without giving effect to contrary provisions regarding conflict of laws. (f) This Agreement shall inure to the benefit of and shall be binding upon your heirs, executors, administrators and legal representatives, and shall inure to the benefit of and be binding upon the Company and its successors and assigns. You may not assign, transfer, pledge, encumber, hypothecate or otherwise dispose of this Agreement, or any of your rights hereunder except if and to the extent expressly permitted by Section 8 of this Agreement, and any such attempted prohibited delegation or disposition shall be null and void and without effect. (g) This Agreement constitutes the complete understanding between the parties with respect to the subject matter hereof, and no statement, representation, warranty or covenant has been made by either party with respect thereto except as expressly set forth herein. This Agreement shall not be altered, modified, amended or terminated except by written instrument signed by each of the parties hereto. (h) This Agreement may be executed in any number of counterparts, each of which shall be deemed an original but all of which shall constitute one and the same instrument. (i) The section headings contained herein are for the purposes of convenience only, are not intended to define or limit the contents of said sections and are not part of this Agreement. (j) By signing below, you hereby accept this Option subject to all of the terms and provisions hereof and acknowledge all of the representations, warranties and agreements set forth above. This Option shall not be effective until you have signed this Option and delivered it to the Company.

  • Xxxxxxx, Esq If to the Executive, to him at the offices of the Company with a copy to him at his home address, set forth in the records of the Company. Any person named above may designate another address or fax number by giving notice in accordance with this Section to the other persons named above.

  • XXX Hosting 10.1 XXX Hosting is not required for resale in the BellSouth region.

  • Xxxxxxxx and X X. Xxxxxxx, Free electron laser-Fourier transform ion cyclotron resonance mass spectrometry facility for obtaining infrared multiphoton dissociation spectra of gaseous ions, Rev. Sci. Instrum., 2005, 76, 023103. 39 N. C. Xxxxxx and X. Xxxxxx, Reaction products in mass spectrometry elucidated with infrared spectroscopy, Phys. Chem. Chem. Phys., 2007, 9, 3804–3817. 40 X. Xxxxxxx, X. Xxxxxx, X. X. Xxxxxxxx and X. Xxxxxx, Infrared ion spectroscopy in a modified quadrupole ion trap mass spectrometer at the XXXXX free electron laser laboratory, Rev. Sci. Instrum., 2016, 87, 103108. 41 X. Xxxxxxx, X. Xxxxxxx, X. Xxxxxx and X. Xxxxxx, Structural identification of electron transfer dissociation products in mass spectrometry using infrared ion spectroscopy, Nat. Commun., 2016, 7, 11754. 42 X. Xxxxxx, X. X. Xxxxxxxx, X. Xxxxxx and X. Xxx Xxxxxx, Gas-phase infrared multiple photon dissociation spectro- scopy of mass-selected molecular ions, Int. J. Mass Spectrom., 2006, 254, 1–19.

  • Xxxxxxx, P E. will perform as the Consultant’s principal for this Project. As principal on this Project, this person shall be the primary contact with the Utilities Director, Utilities Engineer, or another person so designated, and shall have authority to bind the Consultant. So long as the individual named above remains actively employed or retained by the Consultant, he/she shall perform the function of principal on this Project.

  • Xxxxxx, P A., special counsel for IMC, in IMC's capacity as both Seller and Servicer under the Sale and Servicing Agreement, and/or Xxxxx & Xxxxxx LLP shall have furnished to the Underwriters their written opinion or opinions, addressed to the Underwriters and the Depositor and dated the Closing Date, in form and substance satisfactory to the Underwriters, to the effect that:

  • Xxxxxxxxx and X Xxxxxxx. A

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!