Unbundled Network Terminating Wire (UNTW) 2.8.3.1 UNTW is unshielded twisted copper wiring that is used to extend circuits from an intra-building network cable terminal or from a building entrance terminal to an individual End User’s point of demarcation. It is the final portion of the Loop that in multi-subscriber configurations represents the point at which the network branches out to serve individual subscribers. 2.8.3.2 This element will be provided in MDUs and/or Multi-Tenants Units (MTUs) where either Party owns wiring all the way to the End User’s premises. Neither Party will provide this element in locations where the property owner provides its own wiring to the End User’s premises, where a third party owns the wiring to the End User’s premises.
Agreement not to Participate in Company’s Competitors During Executive’s employment with the Company, Executive agrees not to acquire, assume or participate in, directly or indirectly, any position, investment or interest known by Executive to be adverse or antagonistic to the Company, its business, or prospects, financial or otherwise, or in any company, person, or entity that is, directly or indirectly, in competition with the business of the Company or any of its Affiliates (as defined below). Ownership by Executive, in professionally managed funds over which the Executive does not have control or discretion in investment decisions, or as a passive investment, of less than two percent (2%) of the outstanding shares of capital stock of any corporation with one or more classes of its capital stock listed on a national securities exchange or publicly traded on a national securities exchange or in the over-the-counter market shall not constitute a breach of this Section. For purposes of this Agreement, “Affiliate,” means, with respect to any specific entity, any other entity that, directly or indirectly, through one or more intermediaries, controls, is controlled by or is under common control with such specified entity.
AT&T-21STATE made an offer (the “Offer”) to all Telecommunications carriers to exchange Section 251(b)(5) Traffic, Non-toll VoIP-PSTN Traffic and ISP-Bound Traffic pursuant to the terms and conditions of the FCC’s interim ISP terminating compensation plan of the FCC’s Order on Remand and Report and Order, In the Matter of Implementation of the Local Competition Provisions in the Telecommunications Act of 1996, Intercarrier Compensation for ISP-Bound Traffic, FCC 01-131, CC Docket Nos. 96-98, 99-68 (rel. April 27, 2001)) (“FCC ISP Compensation Order”) which was remanded but not vacated in WorldCom, Inc. v. FCC, No. 01-1218 (D.C. Cir. 2002).
Unbundled Network Element Combinations 5.1. Unbundled Network Element Combinations shall include: 1) Enhanced Extended Links (EELs); 2) UNE Loops/Special Access Combinations; 3) Loop/Port Combinations; and 4)
OPTIONAL TWELVE-MONTH PAY PLAN 1. Where the Previous Collective Agreement does not contain a provision that allows an employee the option of receiving partial payment of annual salary in July and August, the following shall become and remain part of the Collective Agreement. 2. A continuing employee, or an employee hired to a temporary contract of employment no later than September 30 that extends to June 30, may elect to participate in an Optional Twelve-Month Pay Plan (the Plan) administered by the employer. 3. An employee electing to participate in the Plan in the subsequent year must inform the employer, in writing, on or before June 15. An employee hired after that date must inform the employer of their intention to participate in the Plan by September 30th. It is understood, that an employee appointed after June 15 in the previous school year and up to September 30 of the subsequent school year, who elects to participate in the Plan, will have deductions from net monthly pay, in the same amount as other employees enrolled in the Plan, pursuant to Article B.8.5. 4. An employee electing to withdraw from the Plan must inform the employer, in writing, on or before June 15 of the preceding year. 5. Employees electing to participate in the Plan shall receive their annual salary over 10 (ten) months; September to June. The employer shall deduct, from the net monthly pay, in each twice-monthly pay period, an amount agreed to by the local and the employer. This amount will be paid into the Plan by the employer. 6. Interest to March 31 is calculated on the Plan and added to the individual employee’s accumulation in the Plan. 7. An employee’s accumulation in the Plan including their interest accumulation to March 31st shall be paid in equal installments on July 15 and August 15. 8. Interest earned by the Plan in the months of April through August shall be retained by the employer. 9. The employer shall inform employees of the Plan at the time of hire. 10. Nothing in this Article shall be taken to mean that an employee has any obligation to perform work beyond the regular school year.
AT&T-12STATE acknowledges that CLEC may have an embedded base of one-way trunks ordered and installed prior to the Effective Date of this Agreement that were used for termination of CLEC’s Section 251(b)(5)/IntraLATA Toll Traffic to AT&T-12STATE (Embedded Base). To the extent that CLEC has such an Embedded Base, CLEC shall only augment trunk groups in the Embedded Base with the mutual agreement of the Parties. CLEC shall not order any new one-way trunk groups following the Effective Date of this Agreement. Moreover, the Parties agree that the Embedded Base will be converted to two-way trunk groups under the following circumstances: 4.2.1.1 With reasonable notification from AT&T-12STATE and upon AT&T-12STATE’s request, CLEC shall convert all of its Embedded Base to two-way trunks. 4.2.1.2 At any time an Embedded Base trunk group (either originating or terminating) requires augmentation, AT&T-12STATE can require the associated originating and terminating trunks to be converted to a single two-way trunk group prior to the augmentation. 4.2.1.3 When any network changes are to be performed on a project basis (i.e., central office conversions, tandem re-homes, etc.), upon request and reasonable notice by AT&T-12STATE, CLEC will convert all of its Embedded Base affected by the project within the intervals and due dates required by the project parameters. 4.2.1.4 In addition to the foregoing, CLEC may choose, at any time, to convert its Embedded Base to two-way trunk groups. 4.2.1.5 The Parties will coordinate any trunk group migration, trunk group prioritization and implementation schedule. AT&T-12STATE agrees to develop a cutover plan within thirty (30) days of notification to CLEC of the need to convert pursuant to Section 4.2.1.1 above and Section 4.2.1.3 above.
Software Ownership If Contractor develops or pays to have developed computer software exclusively with funds or proceeds from the Contract to perform its obligations under the Contract, or to perform computerized tasks that it was not previously performing to meet its obligations under the Contract, the computer software shall be exclusively owned by or licensed to the Department. If Contractor develops or pays to have developed computer software which is an addition to existing software owned by or licensed exclusively with funds or proceeds from the Contract, or to modify software to perform computerized tasks in a manner different than previously performed, to meet its obligations under the Contract, the addition shall be exclusively owned by or licensed to the Department. In the case of software owned by the Department, the Department grants to Contractor a nontransferable, nonexclusive license to use the software in the performance of the Contract. In the case of software licensed to the Department, the Department grants to Contractor permission to use the software in the performance of the Contract. This license or permission, as the case may be, terminates when Contractor has completed its work under the Contract. If Contractor uses computer software licensed to it which it does not modify or program to handle the specific tasks required by the Contract, then to the extent allowed by the license agreement between Contractor and the owner of the software, Contractor grants to the Department a continuing, nonexclusive license for either the Department or a different contractor to use the software in order to perform work substantially identical to the work performed by Contractor under the Contract. If Contractor cannot grant the license as required by this section, then Contractor shall reveal the input screens, report formats, data structures, linkages, and relations used in performing its obligations under the contract in such a manner to allow the Department or another contractor to continue the work performed by contractor under the Contract.
Unbundled Network Elements 35.4.1. The charges that CLEC shall pay to Sprint for Unbundled Network Elements are set forth in Table One of this Agreement. 35.5. Collocation 35.5.1. The charges that CLEC shall pay to Sprint for Collocation are set forth in Table Two of this Agreement. 35.6. Call Related Databases 6.1. The charges that CLEC shall pay to Sprint for Call Related Databases purchased pursuant to Part J are set forth in Table One of this Agreement.
Unbundled Sub-Loop Feeder 2.8.4.1 Unbundled Sub-Loop Feeder (USLF) provides connectivity between BellSouth's central office and cross-box (or other access point) that serves an end user location. 2.8.4.2 USLF utilized for voice traffic can be configured as 2-wire voice (USLF-2W/V) or 4-wire voice (USLF-4W/V). 2.8.4.3 USLF utilized for digital traffic can be configured as 2-wire ISDN (USLF-2W/I); 2-wire Copper (USLF-2W/C); 4-wire Copper (USLF-4W/C); 4-wire DS0 level loop (USLF-4W/D0); or 4-wire DS1 and ISDN (USLF-4W/DI). 2.8.4.4 USLF will provide access to both the equipment and the features in the BellSouth central office and BellSouth cross box necessary to provide a 2W or 4W communications pathway from the BellSouth central office to the BellSouth cross- box. This element will allow for the connection of Lightyear’s loop distribution elements onto BellSouth's feeder system.
Contract Supremacy In the case of a conflict between the express terms of this Agreement and the terms of the ISO Agreement, the express terms of this Agreement shall prevail.
