FAITH-BASED ORGANIZATIONS A. Contractor agrees and acknowledges that County may make funds available for programs or services affiliated with religious organizations under the following conditions: (a) the funds are made available on an equal basis as for programs or services affiliated with non-religious organizations; (b) the program funded does not have the substantial effect of supporting religious activities; (c) the funding is indirect, remote, or incidental to the religious purpose of the organization; and (d) the organization complies with the terms and conditions of this Contract.
REPAIRED OR REPLACED PARTS / COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including Warranties, as set forth in the Additional Warranties Clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturer’s installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.
Wholly Obtained or Produced Goods For purposes of Article 3.1.1(a), the following goods are wholly obtained or produced entirely in the territory of one or both of the Parties: (a) live animals born and raised in the territory of Korea or Peru; (b) goods obtained from live animals born and raised in the territory of Korea or Peru; (c) goods obtained by hunting, trapping, fishing, or aquaculture in the territory of Korea or Peru1; (d) goods of sea-fishing and other goods taken from the sea outside the territory of a Party by vessels registered or recorded with a Party and flying its flag; (e) goods produced on board factory ships, exclusively from the goods referred to in subparagraph (d), provided that such factory ships are registered or recorded with a Party and fly its flag; (f)
REPAIRED OR REPLACED PRODUCTS, PARTS, OR COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including warranties, as set forth in the Warranties clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturers’ installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.
Preference for Domestically Manufactured Goods The provisions of paragraphs 2.54 and 2.55 of the Guidelines and Appendix 2 thereto shall apply to goods manufactured in the territory of the Borrower.
Sale or License of Custom Products Involving Tax Exempt Financing (i.e., Certificates of Participation - COPS) The Authorized User’s sale or other transfer of Custom Products which were acquired by the Authorized User using third party, tax-exempt financing may not occur until such Custom Products are, or become, useable. In the event that the Contractor wishes to obtain ownership rights to Custom Product(s), the sale or other transfer shall be at fair market value determined at the time of such sale or other transfer, and must be pursuant to a separate written agreement in a form acceptable to the Authorized User which complies with the terms of this paragraph.
Insured or Guaranteed Loans If any Loans being transferred pursuant to this Agreement, including the Shared-Loss Agreements, are insured or guaranteed by any department or agency of any governmental unit, federal, state or local, Assuming Institution represents that Assuming Institution has been approved by such agency and is an approved lender or mortgagee, as appropriate, if such approval is required. Assuming Institution further assumes full responsibility for determining whether or not such insurance or guarantees are in full force and effect on the date of this Agreement and with respect to those Loans whose insurance or guaranty is in full force and effect on the date of this Agreement, Assuming Institution assumes full responsibility for doing all things necessary to insure such insurance or guarantees remain in full force and effect. Assuming Institution agrees to assume all of the obligations under the contract(s) of insurance or guaranty, agrees to cooperate with the Receiver where necessary to complete forms required by the insuring or guaranteeing department or agency to effect or complete the transfer to Assuming Institution.
Tandem Transit Traffic 12.1 As used in this Section, Tandem Transit Traffic is Telephone Exchange Service traffic that originates on CBB's network, and is transported through Verizon’s Tandem to the subtending End Office or its equivalent of another carrier (CLEC, ILEC other than Verizon, Commercial Mobile Radio Service (CMRS) carrier, or other LEC (“Other Carrier”). Neither the originating nor terminating customer is a Customer of Verizon. Subtending End Offices shall be determined in accordance with and as identified in the Local Exchange Routing Guide (LERG). Switched Exchange Access Service traffic is not Tandem Transit Traffic.
Proceed Order The Proceed Order is a written notice from the Owner that includes a specified date (i.e. the Proceed Order Date) upon which the Contractor is authorized to commence physical work on the Site. Unless the Proceed Order states otherwise, the Proceed Order Date shall be the date upon which the Proceed Order is actually signed and dated by the Owner’s authorized representative. A Proceed Order is a condition precedent to the execution of any Work on the site by the Contractor. The Proceed Order was formerly referred to as the “Notice to Proceed.”
AUDIT OF LICENSED PRODUCT USAGE Contractor shall have the right to periodically audit, no more than annually, at Contractor’s expense, use of licensed Product at any site where a copy of the Product resides provided that: (i) Contractor gives Licensee(s) at least thirty (30) days advance written notice, (ii) such audit is conducted during such party’s normal business hours, (iii) the audit is conducted by an independent auditor chosen on mutual agreement of the parties. Contractor shall recommend a minimum of three (3) auditing/accounting firms from which the Licensee will select one (1). In no case shall the Business Software Alliance (BSA), Software Publishers Association (SPA), Software and Industry Information Association (SIIA) or Federation Against Software Theft (FAST) be used directly or indirectly to conduct audits, or be recommended by Contractor; (iv) Contractor and Licensee are each entitled to designate a representative who shall be entitled to participate, and who shall mutually agree on audit format, and simultaneously review all information obtained by the audit. Such representatives also shall be entitled to copies of all reports, data or information obtained from the audit; and (v) if the audit shows that such party is not in compliance, Licensee shall be required to purchase additional licenses or capacities necessary to bring it into compliance and shall pay for the unlicensed capacity at the NYS Net Price in effect at time of audit, or if none, then at the Contractor’s U.S. Commercial list price. Once such additional licenses or capacities are purchased, Licensee shall be deemed to have been in compliance retroactively, and Licensee shall have no further liability of any kind for the unauthorized use of the software.