Dark Fiber Transport Dark Fiber Transport is defined as Dedicated Transport that consists of unactivated optical interoffice transmission facilities without attached signal regeneration, multiplexing, aggregation or other electronics. Except as set forth in Section 6.9.1 below, BellSouth shall not be required to provide access to Dark Fiber Transport Entrance Facilities pursuant to this Agreement.
Signaling Link Transport 9.2.1 Signaling Link Transport is a set of two or four dedicated 56 kbps transmission paths between Global Connection-designated Signaling Points of Interconnection that provide appropriate physical diversity.
Unbundled Copper Loop – Non-Designed (UCL-ND 2.4.3.1 The UCL–ND is provisioned as a dedicated 2-wire metallic transmission facility from BellSouth’s Main Distribution Frame to a customer’s premises (including the NID). The UCL-ND will be a “dry copper” facility in that it will not have any intervening equipment such as load coils, repeaters, or digital access main lines (“DAMLs”), and may have up to 6,000 feet of bridged tap between the end user’s premises and the serving wire center. The UCL-ND typically will be 1300 Ohms resistance and in most cases will not exceed 18,000 feet in length, although the UCL-ND will not have a specific length limitation. For loops less than 18,000 feet and with less than 1300 Ohms resistance, the loop will provide a voice grade transmission channel suitable for loop start signaling and the transport of analog voice grade signals. The UCL-ND will not be designed and will not be provisioned with either a DLR or a test point. 2.4.3.2 The UCL-ND facilities may be mechanically assigned using BellSouth’s assignment systems. Therefore, the Loop Make Up process is not required to order and provision the UCL-ND. However, Lightyear can request Loop Make Up for which additional charges would apply. 2.4.3.3 At an additional charge, BellSouth also will make available Loop Testing so that Lightyear may request further testing on the UCL-ND. Rates for Loop Testing are as set forth in Exhibit B of this Attachment. 2.4.3.4 UCL-ND loops are not intended to support any particular service and may be utilized by Lightyear to provide a wide-range of telecommunications services so long as those services do not adversely affect BellSouth’s network. The UCL-ND will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the loop to the customer’s inside wire. 2.4.3.5 Order Coordination (OC) will be provided as a chargeable option and may be utilized when the UCL-ND provisioning is associated with the reuse of BellSouth facilities. Order Coordination -Time Specific (OC-TS) does not apply to this product. 2.4.3.6 Lightyear may use BellSouth’s Unbundled Loop Modification (ULM) offering to remove bridge tap and/or load coils from any loop within the BellSouth network. Therefore, some loops that would not qualify as UCL-ND could be transformed into loops that do qualify, using the ULM process.
Initiating Interconnection 4.1 If ENT determines to offer Telephone Exchange Services and to interconnect with Verizon in any LATA in which Verizon also offers Telephone Exchange Services and in which the Parties are not already interconnected pursuant to this Agreement, ENT shall provide written notice to Verizon of the need to establish Interconnection in such LATA pursuant to this Agreement. 4.2 The notice provided in Section 4.1 of this Attachment shall include (a) the initial Routing Point(s); (b) the applicable technically feasible Point(s) of Interconnection on Verizon’s network to be established in the relevant LATA in accordance with this Agreement; (c) ENT’s intended Interconnection activation date; (d) a forecast of ENT’s trunking requirements conforming to Section 14.2 of this Attachment; and (e) such other information as Verizon shall reasonably request in order to facilitate Interconnection. 4.3 The interconnection activation date in the new LATA shall be mutually agreed to by the Parties after receipt by Verizon of all necessary information as indicated above. Within ten (10) Business Days of Verizon’s receipt of ENT’s notice provided for in Section 4.1of this Attachment, Verizon and ENT shall confirm the technically feasible Point of Interconnection on Verizon’s network in the new LATA and the mutually agreed upon Interconnection activation date for the new LATA.
Cost Responsibility for Interconnection Facilities and Distribution Upgrades 4.1 Interconnection Facilities 4.2 Distribution Upgrades
Joint Funded Project with the Ohio Department of Transportation In the event that the Recipient does not have contracting authority over project engineering, construction, or right-of-way, the Recipient and the OPWC hereby assign certain responsibilities to the Ohio Department of Transportation, an authorized representative of the State of Ohio. Notwithstanding Sections 4, 6(a), 6(b), 6(c), and 7 of the Project Agreement, Recipient hereby acknowledges that upon notification by the Ohio Department of Transportation, all payments for eligible project costs will be disbursed by the Grantor directly to the Ohio Department of Transportation. A Memorandum of Funds issued by the Ohio Department of Transportation shall be used to certify the estimated project costs. Upon receipt of a Memorandum of Funds from the Ohio Department of Transportation, the OPWC shall transfer funds directly to the Ohio Department of Transportation via an Intra- State Transfer Voucher. The amount or amounts transferred shall be determined by applying the Participation Percentages defined in Appendix D to those eligible project costs within the Memorandum of Funds. In the event that the Project Scope is for right-of-way only, notwithstanding Appendix D, the OPWC shall pay for 100% of the right-of-way costs not to exceed the total financial assistance provided in Appendix C.
Unbundled Copper Loop – Designed (UCL-D) 2.4.2.1 The UCL-D will be provisioned as a dry copper twisted pair (2- or 4-wire) Loop that is unencumbered by any intervening equipment (e.g., filters, load coils, range extenders, digital loop carrier, or repeaters). 2.4.2.2 A UCL-D will be 18,000 feet or less in length and is provisioned according to Resistance Design parameters, may have up to 6,000 feet of bridged tap and will have up to 1300 Ohms of resistance. 2.4.2.3 The UCL-D is a designed circuit, is provisioned with a test point, and comes standard with a DLR. OC is a chargeable option for a UCL-D; however, OC is always required on UCLs where a reuse of existing facilities has been requested by Telepak Networks. 2.4.2.4 These Loops are not intended to support any particular services and may be utilized by Telepak Networks to provide a wide-range of telecommunications services as long as those services do not adversely affect BellSouth’s network. This facility will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the Loop to the customer’s inside wire. 2.4.2.5 Upon the Effective Date of this Agreement, Unbundled Copper Loop – Long (UCL-L) elements will no longer be offered by BellSouth and no new orders for UCL-L will be accepted. Any existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement will be grandfathered at the rates set forth in the Parties’ interconnection agreement that was in effect immediately prior to the Effective Date of this Agreement. Existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement may remain connected, maintained and repaired according to BellSouth’s TR73600 and may remain connected until such time as they are disconnected by Telepak Networks or BellSouth provides ninety
Removal of a General Partner (a) Upon the occurrence of an Event of Bankruptcy as to, or the dissolution of, a General Partner, such General Partner shall be deemed to be removed automatically; provided, however, that if a General Partner is on the date of such occurrence a partnership, the withdrawal, death or dissolution of, Event of Bankruptcy as to, or removal of, a partner in, such partnership shall be deemed not to be a dissolution of the General Partner if the business of such General Partner is continued by the remaining partner or partners. The Limited Partners may not remove the General Partner, with or without cause. (b) If a General Partner has been removed pursuant to this Section 7.4 and the Partnership is continued pursuant to Section 7.3 hereof, such General Partner shall promptly transfer and assign its General Partnership Interest in the Partnership to the substitute General Partner approved by a majority in interest of the Limited Partners in accordance with Section 7.3(b) hereof and otherwise admitted to the Partnership in accordance with Section 7.2 hereof. At the time of assignment, the removed General Partner shall be entitled to receive from the substitute General Partner the fair market value of the General Partnership Interest of such removed General Partner as reduced by any damages caused to the Partnership by such General Partner. Such fair market value shall be determined by an appraiser mutually agreed upon by the General Partner and a majority in interest of the Limited Partners within ten (10) days following the removal of the General Partner. In the event that the parties are unable to agree upon an appraiser, the removed General Partner and a majority in interest of the Limited Partners each shall select an appraiser. Each such appraiser shall complete an appraisal of the fair market value of the removed General Partner’s General Partnership Interest within thirty (30) days of the General Partner’s removal, and the fair market value of the removed General Partner’s General Partnership Interest shall be the average of the two appraisals; provided, however, that if the higher appraisal exceeds the lower appraisal by more than 20% of the amount of the lower appraisal, the two appraisers, no later than forty (40) days after the removal of the General Partner, shall select a third appraiser who shall complete an appraisal of the fair market value of the removed General Partner’s General Partnership Interest no later than sixty (60) days after the removal of the General Partner. In such case, the fair market value of the removed General Partner’s General Partnership Interest shall be the average of the two appraisals closest in value. (c) The General Partnership Interest of a removed General Partner, until transfer under Section 7.4(b), shall be converted to that of a special Limited Partner; provided, however, such removed General Partner shall not have any rights to participate in the management and affairs of the Partnership, and shall not be entitled to any portion of the income, expense, profit, gain or loss allocations or cash distributions allocable or payable, as the case may be, to the Limited Partners. Instead, such removed General Partner shall receive and be entitled only to retain distributions or allocations of such items that it would have been entitled to receive in its capacity as General Partner, until the transfer is effective pursuant to Section 7.4(b). (d) All Partners shall have given and hereby do give such consents, shall take such actions and shall execute such documents as shall be legally necessary, desirable and sufficient to effect all the foregoing provisions of this Section.
Removal of General Partner (a) Upon the occurrence of an Event of Bankruptcy as to, or the dissolution of, the General Partner, the General Partner shall be deemed to be removed automatically; provided, however, that if the General Partner is on the date of such occurrence a partnership, the withdrawal, death, dissolution, Event of Bankruptcy as to or removal of a partner in such partnership shall be deemed not to be a dissolution of the General Partner if the business of the General Partner is continued by the remaining partner or partners. The Limited Partners may not remove the General Partner, with or without cause. (b) If the General Partner has been removed pursuant to this Section 7.04 and the Partnership is continued pursuant to Section 7.03, the General Partner shall promptly transfer and assign its General Partnership Interest in the Partnership to the substitute General Partner approved by a Majority in Interest in accordance with Section 7.03(b) and otherwise be admitted to the Partnership in accordance with Section 7.02. At the time of assignment, the removed General Partner shall be entitled to receive from the substitute General Partner the fair market value of the General Partnership Interest of such removed General Partner as reduced by any damages caused to the Partnership by such General Partner. Such fair market value shall be determined by an appraiser mutually agreed upon by the General Partner and a Majority in Interest (excluding the General Partner and any Subsidiary of the General Partner) within ten days following the removal of the General Partner. In the event that the parties are unable to agree upon an appraiser, the removed General Partner and a Majority in Interest (excluding the General Partner and any Subsidiary of the General Partner) each shall select an appraiser. Each such appraiser shall complete an appraisal of the fair market value of the removed General Partner’s General Partnership Interest within 30 days of the General Partner’s removal, and the fair market value of the removed General Partner’s General Partnership Interest shall be the average of the two appraisals; provided, however, that if the higher appraisal exceeds the lower appraisal by more than 20% of the amount of the lower appraisal, the two appraisers, no later than 40 days after the removal of the General Partner, shall select a third appraiser who shall complete an appraisal of the fair market value of the removed General Partner’s General Partnership Interest no later than 60 days after the removal of the General Partner. In such case, the fair market value of the removed General Partner’s General Partnership Interest shall be the average of the two appraisals closest in value. (c) The General Partnership Interest of a removed General Partner, during the time after default until transfer under Section 7.04(b), shall be converted to that of a special Limited Partner; provided, however, such removed General Partner shall not have any rights to participate in the management and affairs of the Partnership, and shall not be entitled to any portion of the income, expense, profit, gain or loss allocations or cash distributions allocable or payable, as the case may be, to the Limited Partners. Instead, such removed General Partner shall receive and be entitled only to retain distributions or allocations of such items that it would have been entitled to receive in its capacity as General Partner, until the transfer is effective pursuant to Section 7.04(b). (d) All Partners shall have given and hereby do give such consents, shall take such actions and shall execute such documents as shall be legally necessary and sufficient to effect all the foregoing provisions of this Section 7.04.
Import/Export a) Purchase orders issued pursuant to this contract shall specify the applicable International Commercial Terms of Sale (Incoterms) and the United States importer of record for all items procured under this contract. b) In performing the obligations of this contract, both Parties will comply with all applicable export, import and sanctions laws, regulations, orders, and authorizations, as they may be amended from time to time, applicable to the export (including re-export) or import of goods, software, technology, or technical data (Items) or services, including without limitation the Export Administration Regulations (EAR), International Traffic in Arms Regulations (ITAR), and regulations and orders administered by the Treasury Department’s Office of Foreign Assets Control (collectively, Export/Import Laws). c) The Party conducting the export or import shall obtain all export or import authorizations which are required under the Export/Import Laws for said Party to execute its obligations under this contract. Each Party shall reasonably cooperate and exercise reasonable efforts at its own expense to support the other Party in obtaining any necessary licenses or authorizations required to perform its obligations under this contract. Reasonable cooperation shall include providing reasonably necessary documentation, including import, end-user and retransfer certificates. d) The Party providing Items or services under this contract shall, upon request, notify the other Party of the Items or services’ export classification (e.g., the Export Control Classification Numbers or United States Munitions List [USML] category and subcategory) as well as the export classification of any components or parts thereof if they are different from the export classification of the Item at issue. The Parties acknowledge that this representation means that an official capable of binding the Party providing such Items or services knows or has otherwise determined the proper export classification. Each Party agrees to reasonably cooperate with the other in providing, upon request of the other Party, documentation or other information that supports or confirms this representation
