Relation to Board Policy. (See Second Amendment to CBA Sample Clauses

Relation to Board Policy. (See Second Amendment to CBA for changes effective August 1, 2017) This fund and the planning time contemplated are in addition to, and are separate and apart from, the time provided in Board Policy GCL which sets minimum standards for planning time. To the extent possible, planning time should be in blocks not less than thirty (30) minutes in length.
AutoNDA by SimpleDocs

Related to Relation to Board Policy. (See Second Amendment to CBA

  • CFR Part 200 or Federal Provision - Xxxx Anti-Lobbying Amendment - Continued If you answered "No, Vendor does not certify - Lobbying to Report" to the above attribute question, you must download, read, execute, and upload the attachment entitled "Disclosure of Lobbying Activities - Standard Form - LLL", as instructed, to report the lobbying activities you performed or paid others to perform. 2 CFR Part 200 or Federal Provision - Federal Rule Compliance with all applicable standards, orders, or requirements issued under section 306 of the Clean Air Act (42 U.S.C. 1857(h)), section 508 of the Clean Water Act (33 U.S.C. 1368), Executive Order 11738, and Environmental Protection Agency regulations (40 CFR part 15). (Contracts, subcontracts, and subgrants of amounts in excess of $100,000) Pursuant to the above, when federal funds are expended by ESC Region 8 and TIPS Members, ESC Region 8 and TIPS Members requires the proposer certify that in performance of the contracts, subcontracts, and subgrants of amounts in excess of $250,000, the vendor will be in compliance with all applicable standards, orders, or requirements issued under section 306 of the Clean Air Act (42 U.S.C. 1857(h)), section 508 of the Clean Water Act (33 U.S.C. 1368), Executive Order 11738, and Environmental Protection Agency regulations (40 CFR part 15). Does vendor certify compliance? Yes

  • AMENDMENTS TO APPLICATION AND AGREEMENT; WAIVERS A. This Agreement may not be modified or amended except by an instrument or instruments in writing signed by all of the Parties and after completing the requirements of Section

  • CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.

  • MODIFICATION BY SUBSEQUENT AGREEMENT This Agreement may be modified by subsequent agreement of the Couple only by an instrument in writing signed by both of them, an oral agreement to the extent that the Couple executes it, or an in-court oral agreement made into an order by a court of competent jurisdiction.

  • Amendments to the Agreement Except to the extent permitted by the Investment Company Act or the rules or regulations thereunder or pursuant to exemptive relief granted by the SEC, this Agreement may be amended by the parties only if such amendment, if material, is specifically approved by the vote of a majority of the outstanding voting securities of the Portfolio (unless such approval is not required by Section 15 of the Investment Company Act as interpreted by the SEC or its staff or unless the SEC has granted an exemption from such approval requirement) and by the vote of a majority of the Independent Trustees cast in person at a meeting called for the purpose of voting on such approval. The required shareholder approval shall be effective with respect to the Portfolio if a majority of the outstanding voting securities of the Portfolio vote to approve the amendment, notwithstanding that the amendment may not have been approved by a majority of the outstanding voting securities of any other Portfolio affected by the amendment or all the Portfolios of the Trust.

  • Modification to Article IV, Section 7 of the DPA Article IV, Section 7 of the DPA (Advertising Limitations) is amended by deleting the stricken text as follows: Provider is prohibited from using, disclosing, or selling Student Data to (a) inform, influence, or enable Targeted Advertising; or (b) develop a profile of a student, family member/guardian or group, for any purpose other than providing the Service to LEA. This section does not prohibit Provider from using Student Data (i) for adaptive learning or customized student learning (including generating personalized learning recommendations); or (ii) to make product recommendations to teachers or LEA employees; or (iii) to notify account holders about new education product updates, features, or services or from otherwise using Student Data as permitted in this DPA and its accompanying exhibits. [SIGNATURES BELOW]

  • PROVISIONS OF THIS AGREEMENT APPLICABLE ON ALLOTTEE / SUBSEQUENT ALLOTTEES It is clearly understood and so agreed by and between the Parties hereto that all the provisions contained herein and the obligations arising hereunder in respect of the Project shall equally be applicable to and enforceable against any subsequent Allottees of the [Apartment/Plot], in case of a transfer, as the said obligations go along with the [Apartment/Plot] for all intents and purposes.

  • Modifications to the Agreement This Agreement constitutes the entire understanding of the parties on the subjects covered. The Employee expressly warrants that he or she is not executing this Agreement in reliance on any promises, representations, or inducements other than those contained herein. Modifications to this Agreement or the Plan can be made only in an express written contract executed by a duly authorized officer of the Company.

  • XXXX ANTI-LOBBYING AMENDMENT Xxxx Anti-Lobbying Amendment (31U.S.C. 1352) – Contractors that apply or bid for an award exceeding ,000 must file the required anti-lobbying certification. Each tier must certify to the tier above that it will not and has not used Federal appropriated funds to pay any person or organization for influencing or attempting to influence an officer or employee of any agency, a member of Congress, officer or employee of Congress, or an employee of a member of Congress in connection with obtaining any Federal contract, grant or any other award covered by 31 U.S.C. 1352. Each tier must also disclose any lobbying with non-Federal funds that takes place in connection with obtaining any Federal award. Such disclosures are forwarded from tier to tier up to the Customer. As applicable, Contractor agrees to file all certifications and disclosures required by, and otherwise comply with, the Xxxx Anti-Lobbying Amendment (31 USC 1352).Contractor certifies that it is currently in compliance with all applicable provisions of the Xxxx Anti-Lobbying Amendment (31 U.S.C. 1352) and will continue to be in compliance throughout the term of the Contract and further certifies that:

  • XXXXX-XXXXX AND RELATED ACT PROVISIONS This section is applicable to all Federal-aid construction projects exceeding $2,000 and to all related subcontracts and lower-tier subcontracts (regardless of subcontract size). The requirements apply to all projects located within the right-of- way of a roadway that is functionally classified as Federal-aid highway. This excludes roadways functionally classified as local roads or rural minor collectors, which are exempt. Contracting agencies may elect to apply these requirements to other projects. The following provisions are from the U.S. Department of Labor regulations in 29 CFR 5.5 “Contract provisions and related matters” with minor revisions to conform to the FHWA- 1273 format and FHWA program requirements.

Time is Money Join Law Insider Premium to draft better contracts faster.