We use cookies on our site to analyze traffic, enhance your experience, and provide you with tailored content.

For more information visit our privacy policy.

In length Sample Clauses

In length. At the front of the vehicle. This requirement shall be deemed to be satisfied if the light emitted does not cause discomfort to the driver either directly or indirectly through the devices for indirect vision and/or other reflecting surfaces of the vehicle.
In length. All lighting units of an AFS shall be mounted at the front. This requirement is deemed to be satisfied if the light emitted does not cause discomfort to the driver either directly or indirectly through the devices for indirect vision and/or other reflecting surfaces of the vehicle.
In length. The rear of the vehicle.
In length the forward distance between the centre reference of the rear indicators and the transverse plane which constitutes the rearmost limit of the vehicle's over-all length shall not exceed 300 mm.
In length. For S1 or S2 categories devices: at the rear of the vehicle. For S3 or S4 categories devices: no special requirement.
In length. Such that the device illuminates the site of the registration plate according to the type-approval documentation of the device."
In lengthIn the case of the installation of more than one manoeuvring lamp, lamps shall be mounted as symmetrically as practicable along each side of the vehicle. The distance between two adjacent manoeuvring lamps on the same side shall not be less than 0.5 m." Insert a new paragraph 6.27., to read:
In lengthIn accordance with the individual specifications applicable to the specific lamp used for the answer-back signal.
In length. All pipe fabrication for specialty units, service facilities, or heating or air conditioning equipment used in building facilities or manufacturing establishments, which has been normally and traditionally done by employees in the bargaining unit covered by this Agreement shall continue to be performed by them.
In length. Dispatchers must remain within the immediate vicinity of their work area in order to continuously perform the full range of their duties. The middle break may be taken away from the work area.