Release Conditions As used in this Agreement, "Release Conditions" shall mean the following:
Conditions for Advance and Conditions to Closing Section 7.1.
Service Conditions Customer acknowledges that in the event of a service issue, Customer is responsible for on-site cooperative testing with LightEdge Technical Support to assist in the diagnosis of the trouble. Customer agrees to be bound to current terms of LightEdge Acceptable Use Policy. Terms of the Acceptable Use Policy are subject to change without notice. Current Acceptable Use Policy can be found here: xxxx://xxx.xxxxxxxxx.xxx/legal Customer agrees that any service complaints including concerns regarding level of support, products, service reliability, or any other concerns related to LightEdge or Services being provided by LIghtEdge will be communicated to LightEdge by sending an email to xx@xxxxxxxxx.xxx.
Buyer’s Conditions for Closing Unless otherwise waived in writing, and without prejudice to Buyer’s right to terminate this Contract during the Review Period, the duties and obligations of Buyer to proceed to Closing under the terms and provisions of this Contract are and shall be expressly subject to strict compliance with, and satisfaction or waiver of, each of the conditions and contingencies set forth in this Section 9.1, each of which shall be deemed material to this Contract. In the event of the failure of any of the conditions set forth in this Section 9.1 or of any other condition to Buyer’s obligations provided for in this Contract, which condition is not waived in writing by Buyer, Buyer shall have the right at its option to terminate this Contract, in which case the Xxxxxxx Money Deposit shall be immediately returned to Buyer and each of the parties shall be relieved from further liability to the other, except as otherwise expressly provided herein, with respect to this Contract. (a) All of Seller’s representations and warranties contained in or made pursuant to this Contract shall be true and correct in all material respects as if made again on the Closing Date. (b) Buyer shall have received all of the instruments and conveyances listed in Section 10.2. (c) Seller shall have performed, observed and complied in all material respects with all of the covenants, agreements, closing requirements and conditions required by this Contract to be performed, observed and complied with by Seller, as and when required hereunder. (d) Third Party Consents in form and substance reasonably satisfactory to Buyer shall have been obtained and furnished to Buyer. (e) The Existing Franchise Agreement shall have been terminated. (f) The Existing Management Agreement shall have been terminated and Buyer and the Manager shall have executed and delivered the New Management Agreement consistent with the form attached hereto as Exhibit E. (g) Buyer and Franchisor shall have executed (or Franchisor has unconditionally committed to execute) the New Franchise Agreement. (h) Seller shall have complied, in all material respects, with its obligations under the thirteen (13) other purchase contracts (“Other Contracts”), each of even date herewith and all of which are more particularly described on Exhibit K hereto; and Seller shall be unconditionally prepared to close on the sale of the hotel properties described in the Other Contracts (“Other Properties”) simultaneously with Closing on the Property.
Conditions for Closing The Lender shall not be obligated to disburse the Bridge Loan until the Borrower shall have fulfilled and/or furnished to the Lender, at the Borrower’s own cost and expense, the following conditions (unless waived in writing by Lender): (a) The Loan Documents duly executed by the Borrower and each Guarantor (as applicable) along with evidence that all financing statements and other filings contemplated thereby have been made and the Security Documents to be placed of record or filed shall have been duly executed and recorded and filed in all appropriate offices and shall constitute a first and prior Lien on the Collateral, subject only to those matters set forth in Section 6.01 of this Agreement and all taxes, fees and charges in connection therewith shall have been paid. (b) Evidence, in form and substance satisfactory to the Lender, that the Aircraft, business and all assets of the Borrower are adequately insured as required by Section 5.04. (c) Payment of the Origination Fee and all reimbursable costs and expenses pursuant to the Loan Documents, together with evidence of payment to other parties of all fees and costs which Borrower is required under the Loan Documents to pay by the Closing Date. (d) Lien searches (including Uniform Commercial Code, judgments, bankruptcy and taxes) with respect to the Borrower and each Guarantor (at the state and county level) from the jurisdiction of its organization and each other jurisdiction in which it maintains an office, including the home airport of the Aircraft, (i) showing no existing Liens on the Collateral pledged by such Persons except as permitted hereunder or (ii) accompanied by necessary termination statements, release statements and any other types of release in connection with any impermissible Liens disclosed by such searches that have been filed or for which satisfactory arrangements have been made for such filing on the Closing Date. (e) With respect to the Aircraft, (i) an FAA and International Registry lien and title search acceptable to the Lender, (ii) a copy of Aircraft Registration Certificate, (iii) lien and title searches of the applicable Canadian government authorities, including without limitation under the Personal Property Security Act, in form acceptable to the Lender, (iv) evidence that the Borrower has become a Transaction User Entity (as defined in the International Registry) and appointed an administrator and a professional registry user entity, in form and substance satisfactory to the Lender, (v) reasonable evidence that the Aircraft is eligible for prompt issuance of a U.S. Certificate of Airworthiness following the Aircraft’s transfer of title to Borrower, (vi) Completed Customs and Border Protection Forms 7501 and 3461 evidencing importation into the U.S., and (vii) a copy of the airframe, engine, and avionics maintenance programs. (f) Copies of all of the Aircraft Contracts in effect as of the Closing Date, in form and substance reasonably acceptable to the Lender. (g) A copy of the Borrower’s and each Guarantor’s organizational documents, in form and substance satisfactory to the Lender. (h) A certificate of existence, authorization, good standing certificate, or its equivalent of each of the Borrower and the Guarantor from the Secretary of State of such Person’s jurisdiction of incorporation/formation/organization and the Secretary of State of each other jurisdiction in which such Person is qualified to do business as a foreign corporation/company/partnership, if any. (i) A certificate in form and substance satisfactory to Lender from the Borrower and each Guarantor, dated the Closing Date and signed on behalf of such Person by an authorized member/manager/officer of such Person certifying as to (i) true copies of the organizational documents of such Person and any amendments thereto, (ii) the resolutions of the directors/managers and/or shareholders/members (as the case may be) of such Person authorizing the execution and delivery of this Agreement and the other Loan Documents to which it is a party and (iii) the names, true signatures and incumbency of the members/managers/officers of such Person authorized to execute and deliver the Loan Documents to which it is a party. The Lender may conclusively rely on such certification unless and until a later certificate revising the prior certificate has been furnished to the Lender. (j) A certification regarding the beneficial ownership of the Borrower, as required by the Bank Secrecy Act (31 C.F.R. §1010.230 et. seq.), as amended from time to time, the regulations promulgated thereunder, and any successor statute, in form and substance satisfactory to the Lender. (k) Evidence, in form and substance acceptable to the Lender, that the Borrower has a tangible balance sheet equity of at least twenty percent (20%) on the Closing Date. (l) An opinion of counsel on behalf of the Borrower and the Guarantor, dated the Closing Date, in form and substance satisfactory to the Lender in absolute discretion. (m) An opinion of special FAA counsel, including an International Registry Priority Search Certificate, each dated the Closing Date, in form and substance satisfactory to the Lender in absolute discretion. (n) Listing of furniture, fixtures and equipment owned by the Borrower or a certification that the Borrower does not own any, satisfactory in form and content to the Lender, indicating that the estimated value of such furniture, fixtures and equipment. (o) An inventory of all Warranties (including copies all documentation with respect thereto) relating to the Aircraft. (p) The Borrower shall have executed and delivered all forms, documentation and information necessary for the establishment of the Cash Collateral Account at Lender, and shall have funded the Cash Collateral into the Cash Collateral Account (either prior to the Closing Date or contemporaneously therewith). (q) Such other instruments, documents, certificates, assurances and opinions as may be set forth in the preliminary closing checklist delivered to the Borrower in connection with this Agreement or as the Lender shall reasonably require to evidence and secure the Loan, to comply with the provisions hereof and the requirements of regulatory authorities to which the Lender is subject, all of which, including those referred to above in this Section 4.01 shall be satisfactory in form, content and substance to the Lender.
Conditions to Obligation to Close (a) Conditions to Obligation of the Purchaser. The obligation of the Purchaser to consummate the transactions to be performed by it in connection with the Closing is subject to satisfaction of the following conditions: (i) the representations and warranties set forth in Section 3 above that are qualified as to their materiality or to the Knowledge of the Seller shall be true and correct and any such representations and warranties that are not so qualified shall be true and correct in all material respects at and as of the Closing Date (as though made then and as though the Closing Date were substituted for the date of this Agreement); (ii) the Seller and the Company shall have performed and complied with all of their respective covenants hereunder in all material respects through the Closing; (iii) there shall not be any injunction, judgment, order, decree, ruling or charge in effect preventing consummation of any of the transactions contemplated by this Agreement, and no action, suit, claim or proceeding shall be pending before any Authority which seeks to prohibit or enjoin the consummation of the transactions contemplated by this Agreement; (iv) the Seller shall have delivered to the Purchaser a certificate to the effect that the conditions specified above in Section 9(a)(i) and (ii), as they pertain to the Seller, have been satisfied in all respects; (v) the Seller shall have delivered to the Purchaser a certificate to the effect that the conditions specified above in Section 9(a)(i) and (ii), as they pertain to the Company, have been satisfied in all respects; (vi) the Seller shall have delivered to the Purchaser all of the items under Section 2(f) herein; and (vii) there shall be no payables or receivables between the Seller and the Company or between Affiliates of the Seller and the Company. (viii) the Purchaser shall have obtained financing to implement the transactions provided for in this Agreement and to provide sufficient working capital on such terms and conditions as are acceptable to the Purchaser, and the Purchaser shall have satisfied all of the conditions precedent to acquisitions under WinsLoew Furniture, Inc.'s line of credit with Fleet. (ix) all consents, waivers, exemptions, governmental approvals, regulatory approvals and other actions that are necessary in connection with the consummation of the transactions contemplated by this Agreement, shall be in full force and effect on the Closing Date. (x) the Purchaser shall have received from Seller all information available to Seller that is requested by the Purchaser promptly after the date hereof, and the Purchaser, upon review of such matters related to Seller, its assets, liabilities, financial condition, business, prospects or relations with third parties as it shall deem necessary or appropriate (in which review Seller shall cooperate), shall not have learned of any fact or matter that, in the good faith determination of Purchaser, causes Purchaser to be dissatisfied in any material respect with the transactions contemplated by this Agreement. The Purchaser may waive any condition specified in this Section 9(a) if it executes a writing so stating at or prior to the Closing.
CONDITIONS PRECEDENT TO THE BUYER’S OBLIGATION TO PURCHASE The obligation of the Buyer hereunder to purchase the Note at the Closing is subject to the satisfaction, at or before the Closing Date of each of the following conditions, provided that these conditions are for the Buyer’s sole benefit and may be waived by the Buyer at any time in its sole discretion: a. The Company shall have executed this Agreement and delivered the same to the Buyer. b. The Company shall have delivered to the Buyer duly executed Note (in such denominations as the Buyer shall request) in accordance with Section 1(b) above. c. The representations and warranties of the Company shall be true and correct in all material respects as of the date when made and as of the Closing Date as though made at such time (except for representations and warranties that speak as of a specific date) and the Company shall have performed, satisfied and complied in all material respects with the covenants, agreements and conditions required by this Agreement to be performed, satisfied or complied with by the Company at or prior to the Closing Date. The Buyer shall have received a certificate or certificates, executed by the chief executive officer of the Company, dated as of the Closing Date, to the foregoing effect and as to such other matters as may be reasonably requested by the Buyer including, but not limited to certificates with respect to the Company’s Certificate of Incorporation, By-laws and Board of Directors’ resolutions relating to the transactions contemplated hereby. d. No litigation, statute, rule, regulation, executive order, decree, ruling or injunction shall have been enacted, entered, promulgated or endorsed by or in any court or governmental authority of competent jurisdiction or any self-regulatory organization having authority over the matters contemplated hereby which prohibits the consummation of any of the transactions contemplated by this Agreement. e. No event shall have occurred which could reasonably be expected to have a Material Adverse Effect on the Company including but not limited to a change in the 1934 Act reporting status of the Company or the failure of the Company to be timely in its 1934 Act reporting obligations. f. The Conversion Shares shall have been authorized for quotation on the OTCBB, OTCQB or any similar quotation system and trading in the Common Stock on the OTCBB, OTCQB or any similar quotation system shall not have been suspended by the SEC or the OTCBB, OTCQB or any similar quotation system. g. The Buyer shall have received an officer’s certificate described in Section 3(c) above, dated as of the Closing Date.
Termination Conditions Such license shall not be terminated or its exploitation enjoined, until and unless: (i) Hitachi has committed a material breach of its obligations under this IP License Agreement, Opto-Device has given written notice of such breach to Hitachi and such breach remains uncured after the Cure Period, or, in the case of a breach, which cannot be cured within such Cure Period, Hitachi has not instituted within such Cure Period steps necessary to remedy the default and/or thereafter has not diligently pursued the same to completion; or (ii) such a material breach is incurable. In the event the breach is a curable breach that cannot be cured within the Cure Period but with respect to which Hitachi has instituted steps necessary to remedy the default and is thereafter diligently pursuing such cure, both parties shall negotiate to determine whether further pursuit of such cure is reasonable. If the parties cannot agree on a resolution in such negotiations, then this issue shall be referred to arbitration pursuant to the arbitration procedures set forth in Exhibit B hereto to decide whether such breach can be cured or any other alternative remedy should be adopted. In the event the breach is an incurable breach, the parties agree that the matter shall be referred to arbitration pursuant to the arbitration procedures set forth in Exhibit B hereto to determine the appropriate remedy. In the event that either party submits the dispute to arbitration, both parties shall cooperate in such binding arbitration in accordance with Exhibit B.
CONDITIONS PRECEDENT TO PURCHASER'S OBLIGATION TO CLOSE Purchaser's obligation to purchase the Shares and to take the other actions required to be taken by Purchaser at the Closing is subject to the satisfaction, at or prior to the Closing, of each of the following conditions (any of which may be waived by Purchaser, in whole or in part):
CONDITIONS PRECEDENT TO BUYER'S OBLIGATION TO CLOSE Buyer's obligation to purchase the Shares and to take the other actions required to be taken by Buyer at the Closing is subject to the satisfaction, at or prior to the Closing, of each of the following conditions (any of which may be waived by Buyer, in whole or in part):
