PROHIBITED DECKING AREAS Purchaser shall not deck right-of-way timber in the following areas: Within the grubbing limits. Within 50 feet of any stream. In locations that interfere with the construction of the road prism. In locations that impede drainage. On slopes greater than 40%. Against standing trees unless approved by the Contract Administrator.
Obligation to Notify Owner of Existing Hazardous Materials The Contractor shall immediately notify the Owner and the Design Professional, both orally and in writing, of the presence and location of any physical evidence of, or information regarding the presence of Hazardous Materials at the Site of which it becomes aware. If the Contractor encounters Hazardous Materials on the Site the Contractor shall (i) immediately stop performance of Work or that portion of the Work affected by or affecting such Hazardous Materials; (ii) secure the contaminated area against intrusion; (iii) not disturb or remove the Hazardous Materials; (iv) not proceed, or allow any subcontractor or supplier to proceed, with any Work or other activities in the area affected by such Hazardous Materials until such materials have been properly remediated and until directed in writing to do so by the Owner; and, (v) take any other steps necessary to protect life and health and the surrounding environment. The Contractor shall be entitled to adjustment of the Contract Time and the Contract Sum pursuant to Section 5, Part 2 of these General Conditions in order to compensate for the impact of any required demolition, re-work, shutdown, delay, protection of work, disruption, and start-up resulting from the encountering of such Hazardous Materials on the Site for which the Contractor is not responsible.
Certification of Meeting or Exceeding Tobacco-Free Workplace Policy Minimum Standards A. Grantee certifies that it has adopted and enforces a Tobacco-Free Workplace Policy that meets or exceeds all of the following minimum standards of:
Convicted, Discriminatory, Antitrust Violator, and Suspended Vendor Lists In accordance with sections 287.133, 287.134, and 287.137, F.S., the Contractor is hereby informed of the provisions of sections 287.133(2)(a), 287.134(2)(a), and 287.137(2)(a), F.S. For purposes of this Contract, a person or affiliate who is on the Convicted Vendor List, the Discriminatory Vendor List, or the Antitrust Violator Vendor List may not perform work as a contractor, supplier, subcontractor, or consultant under the Contract. The Contractor must notify the Department if it or any of its suppliers, subcontractors, or consultants have been placed on the Convicted Vendor List, the Discriminatory Vendor List, or the Antitrust Violator Vendor List during the term of the Contract. In accordance with section 287.1351, F.S., a vendor placed on the Suspended Vendor List may not enter into or renew a contract to provide any goods or services to an agency after its placement on the Suspended Vendor List. A firm or individual placed on the Suspended Vendor List pursuant to section 287.1351, F.S., the Convicted Vendor List pursuant to section 287.133, F.S., the Antitrust Violator Vendor List pursuant to section 287.137, F.S., or the Discriminatory Vendor List pursuant to section 287.134, F.S., is immediately disqualified from Contract eligibility.
Teaching Staff Assigned to More Than One Building Each Educator who is assigned to more than one building will be evaluated by the appropriate administrator where the individual is assigned most of the time. The principal of each building in which the Educator serves must review and sign the evaluation, and may add written comments. In cases where there is no predominate assignment, the superintendent will determine who the primary evaluator will be.
Scaling Locations, Rules, and Organizations All logs from timber sold under the terms and conditions of this contract shall be: (1) scaled at a location approved in writing by STATE; (2) scaled by a third-party scaling organization with a current agreement with STATE; and (3) scaled using the Official Log Scaling and Grading Rules (as adopted by the Northwest Log Rules Advisory Group) and STATE special service scaling instructions in effect at the time the logs are scaled. Utilization scale shall be handled in accordance with the section titled, “Utilization Scale.” PURCHASER shall enter into a written agreement with a third-party scaling organization for the scaling of logs removed from the timber sale area. PURCHASER shall furnish STATE with a copy of the scaling agreement upon request. If logs are delivered when a TPSO scaler is not present, PURCHASER must provide STATE with a method to assure protection and accountability. PURCHASER shall provide STATE with remote check scaling opportunities for logs scaled under this contract. The last two loads at each delivery point shall be continuously available for checking. They shall remain available for a minimum of 48 hours unless replaced by other STATE loads. They shall be available as originally presented for scaling; i.e., if truck scaled, they shall be presented in bunks. In the event scaling is suspended for any reason, hauling operations shall be immediately suspended until approved alternate scaling services are provided, or service by the scaling organization is resumed.
Requester and Approved User Responsibilities The Requester agrees through the submission of the DAR that the PI named has reviewed and understands the principles for responsible research use and data management of the genomic datasets as defined in the NIH Security Best Practices for Controlled-Access Data Subject to the GDS Policy. The Requester and Approved Users further acknowledge that they are responsible for ensuring that all uses of the data are consistent with national, tribal, and state laws and regulations, as appropriate, as well as relevant institutional policies and procedures for managing sensitive genomic and phenotypic data. The Requester certifies that the PI is in good standing (i.e., no known sanctions) with the institution, relevant funding agencies, and regulatory agencies and is eligible to conduct independent research (i.e., is not a postdoctoral fellow, student, or trainee). The Requester and any Approved Users may use the dataset(s) only in accordance with the parameters described on the study page and in the 1 If contractor services are to be utilized, PI requesting the data must provide a brief description of the services that the contractor will perform for the PI (e.g., data cleaning services) in the research use statement of the DAR. Additionally, the Key Personnel section of the DAR must include the name of the contractor’s employee(s) who will conduct the work. These requirements apply whether the contractor carries out the work at the PI’s facility or at the contractor’s facility. In addition, the PI is expected to include in any contract agreement requirements to ensure that any of the contractor’s employees who have access to the data adhere to the NIH GDS Policy, this Data Use Certification Agreement, and the NIH Security Best Practices for Controlled-Access Data Subject to the GDS Policy. Note that any scientific collaborators, including contractors, who are not at the Requester must submit their own DAR. Addendum to this Agreement for the appropriate research use, as well as any limitations on such use, of the dataset(s), as described in the DAR, and as required by law. Through the submission of this DAR, the Requester and Approved Users acknowledge receiving and reviewing a copy of the Addendum which includes Data Use Limitation(s) for each dataset requested. The Requester and Approved Users agree to comply with the terms listed in the Addendum. Through submission of the DAR, the PI and Requester agree to submit a Project Renewal or Project Close-out prior to the expiration date of the one (1) year data access period. The PI also agrees to submit an annual Progress Update prior to the one (1) year anniversary2 of the project, as described under Research Use Reporting (Term 10) below. By approving and submitting the attached DAR, the Institutional Signing Official provides assurance that relevant institutional policies and applicable local, state, tribal, and federal laws and regulations, as applicable, have been followed, including IRB approval, if required. Approved Users may be required to have IRB approval if they have access to personal identifying information for research participants in the original study at their institution, or through their collaborators. The Institutional Signing Official also assures, through the approval of the DAR, that other institutional departments with relevant authorities (e.g., those overseeing human subjects research, information technology, technology transfer) have reviewed the relevant sections of the NIH GDS Policy and the associated procedures and are in agreement with the principles defined. The Requester acknowledges that controlled-access datasets subject to the NIH GDS Policy may be updated to exclude or include additional information. Unless otherwise indicated, all statements herein are presumed to be true and applicable to the access and use of all versions of these datasets.
GEOGRAPHIC AREA AND SECTOR SPECIFIC ALLOWANCES, CONDITIONS AND EXCEPTIONS The following allowances and conditions shall apply where relevant: Where the company does work which falls under the following headings, the company agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.
Staffing Levels to deal with Potential Violence The Employer agrees that, where there is a risk of violence, an adequate level of trained employees should be present. The Employer recognizes that workloads can lead to fatigue and a diminished ability both to identify and to subsequently deal with potentially violent situations.
Prohibition Against Selecting and Installing Products Containing Hazardous Materials The Contractor shall not select, install or otherwise incorporate any products or materials containing Hazardous Materials within the boundaries of the Site. Should the Contractor or any Subcontractors have knowledge that, or believe that, an item, component, material, substance, or accessory within a product or assembly selected by the Contractor or any Subcontractor may contain Hazardous Materials it is the Contractor’s responsibility to secure a written certification from the manufacturer of any suspected material which identifies the specific Hazardous Material(s) contained, together with the Material Safety Data Sheets (MSDS) for such materials which shall be submitted to the Owner and Design Professional.
