Repair or Replacement (i) In the event of a Casualty or Taking between the Effective Date and the Closing Date, Seller shall elect, at its option, to either (A) repair or replace or make adequate provision for the repair or replacement of the Damaged Portion of the Purchased Assets at Seller’s cost prior to the Closing, in which case Buyer’s obligation to effect the Closing shall not be affected, but the Closing Date (and the End Date, if necessary) shall be deferred until three (3) Business Days after repairs 38 or replacement have been completed and the Damaged Portion of the Purchased Assets is fully repaired or restored to the condition thereof immediately prior to such Casualty or Taking in accordance with applicable Laws or Orders, or (B) negotiate with Buyer to reduce the Purchase Price to reflect the cost to repair or replace the Damaged Portion of the Purchased Assets and the post-Closing loss of net income associated with such business interruption (such repair or replacement costs and loss of net income, the “Repair Costs”). Notwithstanding the foregoing, Seller’s election in clause (A) of this Section 8.5(b)(i) shall be unavailable and clause (B) of this Section 8.5(b)(i) shall apply if the Damaged Portion of the Purchased Assets cannot reasonably be expected to be fully repaired or restored to the condition thereof immediately prior to such Casualty or Taking in accordance with applicable Laws or Orders on or before the date that is 180 days following the occurrence of the Casualty or Taking (the “Casualty Event Termination Date”)
(ii) If Seller and Buyer agree on the Repair Costs within fifteen (15) days of Buyer’s receipt of Seller’s notice of the Casualty or Taking (the “Repair Negotiation Period”), Buyer’s obligation to effect the Closing shall not be affected, but the Purchase Price shall be reduced by the Repair Costs so agreed.
(iii) If Seller and Buyer do not agree on the Repair Costs within the Repair Negotiation Period (a “Repair Cost Dispute”), Buyer or Seller may request an engineering company (and/or other appropriate specialist) that shall be mutually agreed to by Buyer and Seller to evaluate the Damaged Portion of the Purchased Assets and the loss of net income associated with such business interruption and deliver to Buyer and Seller its written estimate of the Repair Costs (the “Third-Party Estimate”) within fifteen (15) days after the end of the Repair Negotiation Period. If the Third-Party Estimate is less than the Buyer Casualty Threshold (or greater than the Buyer Casualty Threshold or Seller Casualty Threshold, as applicable, and neither party terminates the Agreement as permitted pursuant to Section 8.5(b)(iv)), Buyer’s obligation to effect the Closing shall not be affected and Buyer and Seller shall mutually resolve the Repair Cost Dispute after the Closing in accordance with the provisions of Section 2.3 (and, for the avoidance of doubt, the engineering company or other appropriate specialist shall be deemed to be the Inspector for purposes of Section 2.3), with a post-Closing adjustment to the Purchase Price equal to the finally-determined Repair Costs.
(iv) Notwithstanding the foregoing, and subject to Section 8.5(f), if the Repair Costs as agreed to by Buyer and Seller or the Third-Party Estimate, as applicable, (A) is equal to or greater than the Buyer Casualty Threshold, Buyer may elect, by giving Seller written notice of election within fifteen (15) days of receipt of the Third-Party Estimate, or (B) is equal to or greater than the Seller Casualty Threshold, Seller may elect, by giving Buyer written notice of election within fifteen (15) days of receipt of the Third Party Estimate, to terminate this Agreement without further obligation hereunder, except as provided in Section 11.2.
Capital Equipment Collaborator’s commitment, if any, to provide ICD with capital equipment to enable the research and development activities under the Research Plan appears in Appendix B. If Collaborator transfers to ICD the capital equipment or provides funds for ICD to purchase it, then ICD will own the equipment. If Collaborator loans capital equipment to ICD for use during the CRADA, Collaborator will be responsible for paying all costs and fees associated with the transport, installation, maintenance, repair, removal, or disposal of the equipment, and ICD will not be liable for any damage to the equipment.
Repair Concessionaire shall, prior to the commencement of the Concession Operation under this Agreement, provide to Department a type-written concession equipment maintenance plan for the State-owned equipment located on the Concession Premises, together with a schedule for preventative maintenance and a report on maintenance completion and equipment condition. Failure to comply with this preventative maintenance schedule shall result in Concessionaire being responsible for all repairs and/or replacement of equipment. The review and Department inspection of the Concession Premises and its equipment will be conducted during routine inspection of the Concession Premises and as a part of the Mandatory Compliance and Performance Evaluation Meetings.
Tooling Unless otherwise specified in this Agreement, all tooling and/or all other articles required for the performance hereof shall be furnished by Seller, maintained in good condition and replaced when necessary at Seller's expense. If NETAPP agrees to pay Seller for special tooling or other items either separately or as a stated part of the unit price of Goods purchased herein, title to same shall be and remain in NETAPP upon payment therefore.
Maintenance, Alteration and Repair (a) Resident is responsible for and agrees to take good care of the premises, fixtures and all common areas. Resident may not remove any of Owner’s property and will not perform any repairs, upgrades, painting, wallpapering, electric changes or other alterations of the premises without prior written consent from Owner. Resident will be responsible for damage from waste stoppages caused by foreign or improper objects or improper use in lines serving bathrooms, damage to fixtures, appliances, doors, windows, screens, damage from water faucets left on or from doors left open, and repairs or replacements to alarm devices necessitated by misuse or damage by Resident and/or guests. Extraordinary appliances or furnishings such as satellite dishes, hot tubs, pool tables, water beds or high utility- consuming devices may not be installed or placed on the premises or anywhere at the Property without Owner’s prior written consent, in its sole discretion.
(b) In the case of a malfunction of any utilities or damage by fire, water or similar cause, or any water leak, suspected mold or microbial growth, electrical problem, broken glass, broken lock or any other condition that Resident reasonably believes poses a hazard to health and safety, Resident must promptly notify Owner in writing. Owner will act with reasonable time and diligence in making repairs and reconnections; Resident may not withhold or reduce payment of rent or other charges during such time. Maintenance and repair requested by Resident will generally be performed between 8am and 8pm, unless the work is considered an emergency, in which case work may take place at any time. Owner may temporarily disconnect equipment or utilities to avoid property damage and/or to perform repairs requiring such interruption, in Owner’s sole discretion. Owner will not be liable for any inconvenience, discomfort, disruption or interference with Resident use of the premises because of ongoing repairs, alterations or improvements to the Property or any apartment.
(c) Following move-in, Resident is responsible for providing and changing all light bulbs and batteries (for smoke detectors and remote controls) in the assigned apartment. A written maintenance report requesting assistance in changing these items may be submitted for maintenance staff assistance, with extra charges payable by Resident as applicable per Owner’s published rates. From time to time, maintenance staff may enter the assigned apartment with or without notice to inspect and change furnace filters and to provide pest control.
REPAIRED OR REPLACED PARTS / COMPONENTS Where the Contractor is required to repair, replace or substitute Product or parts or components of the Product under the Contract, the repaired, replaced or substituted Products shall be subject to all terms and conditions for new parts and components set forth in the Contract including Warranties, as set forth in the Additional Warranties Clause herein. Replaced or repaired Product or parts and components of such Product shall be new and shall, if available, be replaced by the original manufacturer’s component or part. Remanufactured parts or components meeting new Product standards may be permitted by the Commissioner or Authorized User. Before installation, all proposed substitutes for the original manufacturer’s installed parts or components must be approved by the Authorized User. The part or component shall be equal to or of better quality than the original part or component being replaced.
New Equipment Where new types of equipment and/or operations, for which rates of pay are not established by this Agreement, are put into use after the ratification date of this Agreement within operations covered by this Agreement, rates governing such operations shall be subject to negotiations between the parties. This paragraph shall apply to all new types of equipment including office and clerical equipment. In the event an agreement cannot be reached within sixty (60) days after the date such equipment is put into use, the matter may shall be submitted to the National Grievance Committee for final disposition. Rates agreed upon or awarded shall be effective as of the date equipment is put to use
Software Installation The AGENCY shall request approval in writing from the COUNTY prior to installation of any software on COUNTY computer equipment. All software installations must be supervised by COUNTY technical support staff and proof of licensing is required. Upon completion, the AGENCY is responsible for reconfiguring the computers back to the original state.
Painting All exterior surfaces and materials requiring paint shall be prime coated plus 2 coats of Xxxxxxx Xxxxxxxx Pro-Mar alkyd flat exterior finish, or Xxxxxxx-Xxxxxxxx SWP exterior gloss paint.
10.1 Wall Corner Guards: Provide clear plastic guards up to 60” AFF on all outside corners to protect vinyl wall covering.
Equipment Return You may use the Leased Equipment provided under this plan only while you remain an active customer in good standing and in compliance with this Agreement (including, without limitation, the RCA). You must return all Leased Equipment in good operating condition, normal wear and tear excepted, within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment. If you acquired your Leased Equipment from a retailer, then you must return all Leased Equipment to: (A) your original retailer, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming; or (B) DISH, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs after such 30-day period. You are responsible for and shall bear all costs, expenses and risk of returning your Leased Equipment, including, without limitation, risk of loss during shipment. You are not responsible under the terms and conditions of this Agreement for the return of equipment other than your Leased Equipment. Following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment (unless you acquired your Leased Equipment from a retailer and the cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming and you returned Leased Equipment to such retailer within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment), DISH will send you one or more return labels or empty boxes (depending on your Leased Equipment) to be used by you in returning your Leased Equipment and DISH will charge you up to $20.00 for each such return label or empty box (“Box Return Fee”). The BoxReturn Fee is subject to change at any time. Unless you are a resident of a Remote Area of Alaska, you also have the option of contacting DISH by calling 000-000-XXXX (000-000-0000) to request that DISH or our designee(s) perform an in-home service call to remove your Leased Equipment at DISH’s then-current in-home service call rate, which rate is subject to change at any time. Leased Equipment will not be deemed returned until received by DISH. DISH Protect is an optional service program currently priced as set forth in the table below. DISH Protect is offered in two (2) plans: Dish Protect and Plus. The services offered in each plan can be viewed at xxxxxx.xxx/xxxxxxxxxxx. If you enroll in a DISH Protect plan, you will receive an initial six (6) month trial offer of DISH Protect if you are eligible and if such plans are otherwise available to you at the time you sign this Agreement. During the trial offer period, you will be charged the monthly Trial Offer Price set forth below. By signing above, you are accepting the terms of this trial offer and understand that you may cancel or change your DISH Protect plan at any time by calling 000- 000-XXXX (3474) or by emailing xxxxxxxxxxxxxxxxxxxxxxxx@xxxx.xxx. You also agree that if you do not cancel your DISH Protect plan during the initial six (6) month trial offer period, DISH will automatically begin billing you the then-current monthly Regular Price of your DISH Protect plan upon the expiration of the six (6) month trial offer period until you cancel your DISH Protect plan. Not all DISH Protect plans are available to all customers. DISH Protect is not available to residents of Remote Areas of Alaska and/or residents of some Shared Dish MDU Properties. If you reside in a Shared Dish MDU Property and you are not sure if you qualify for DISH Protect, then please call 000-000-0000 to determine if you qualify. DISH Protect $11.99 $0.00 DISH Protect Plus $11.99 $0.00