Testing of Metering Equipment Connecting Transmission Owner shall inspect and test all of its Metering Equipment upon installation and at least once every two (2) years thereafter. If requested to do so by NYISO or Developer, Connecting Transmission Owner shall, at Developer’s expense, inspect or test Metering Equipment more frequently than every two (2) years. Connecting Transmission Owner shall give reasonable notice of the time when any inspection or test shall take place, and Developer and NYISO may have representatives present at the test or inspection. If at any time Metering Equipment is found to be inaccurate or defective, it shall be adjusted, repaired or replaced at Developer’s expense, in order to provide accurate metering, unless the inaccuracy or defect is due to Connecting Transmission Owner’s failure to maintain, then Connecting Transmission Owner shall pay. If Metering Equipment fails to register, or if the measurement made by Metering Equipment during a test varies by more than two percent from the measurement made by the standard meter used in the test, Connecting Transmission Owner shall adjust the measurements by correcting all measurements for the period during which Metering Equipment was in error by using Developer’s check meters, if installed. If no such check meters are installed or if the period cannot be reasonably ascertained, the adjustment shall be for the period immediately preceding the test of the Metering Equipment equal to one-half the time from the date of the last previous test of the Metering Equipment. The NYISO shall reserve the right to review all associated metering equipment installation on the Developer’s or Connecting Transmission Owner’s property at any time.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract.
Return of Equipment (a) At the expiration or termination of this Agreement or any Schedule, Lessee shall perform any testing and repairs required to place the units of Equipment in the same condition and appearance as when received by Lessee (reasonable wear and tear excepted) and in good working order for the original intended purpose of the Equipment. If required the units of Equipment shall be deinstalled, disassembled and crated by an authorized manufacturer's representative or such other service person as is reasonably satisfactory to Lessor. Lessee shall remove installed markings that are not necessary for the operation, maintenance or repair of the Equipment. All Equipment will be cleaned, cosmetically acceptable, and in such condition as to be immediately installed into use in a similar environment for which the Equipment was originally intended to be used. All waste material and fluid must be removed from the Equipment and disposed of in accordance with then current waste disposal laws. Lessee shall return the units of Equipment to a location within the continental United States as Lessor shall direct. Lessee shall obtain and pay for a policy of transit insurance for the redelivery period in an amount equal to the replacement value of the Equipment. The transit insurance must name Lessor as the loss payee. The Lessee shall pay for all costs to comply with this section (a).
