Licensed Products Lessee will obtain no title to Licensed Products which will at all times remain the property of the owner of the Licensed Products. A license from the owner may be required and it is Lessee's responsibility to obtain any required license before the use of the Licensed Products. Lessee agrees to treat the Licensed Products as confidential information of the owner, to observe all copyright restrictions, and not to reproduce or sell the Licensed Products.
Marking of Licensed Products To the extent commercially feasible and consistent with prevailing business practices, Company shall xxxx, and shall cause its Affiliates and Sublicensees to xxxx, all Licensed Products that are manufactured or sold under this Agreement with the number of each issued patent under the Patent Rights that applies to such Licensed Product.
AUDIT OF LICENSED PRODUCT USAGE Contractor shall have the right to periodically audit, no more than annually, at Contractor’s expense, use of licensed Product at any site where a copy of the Product resides provided that: (i) Contractor gives Licensee(s) at least thirty (30) days advance written notice, (ii) such audit is conducted during such party’s normal business hours, (iii) the audit is conducted by an independent auditor chosen on mutual agreement of the parties. Contractor shall recommend a minimum of three (3) auditing/accounting firms from which the Licensee will select one (1). In no case shall the Business Software Alliance (BSA), Software Publishers Association (SPA), Software and Industry Information Association (SIIA) or Federation Against Software Theft (FAST) be used directly or indirectly to conduct audits, or be recommended by Contractor; (iv) Contractor and Licensee are each entitled to designate a representative who shall be entitled to participate, and who shall mutually agree on audit format, and simultaneously review all information obtained by the audit. Such representatives also shall be entitled to copies of all reports, data or information obtained from the audit; and (v) if the audit shows that such party is not in compliance, Licensee shall be required to purchase additional licenses or capacities necessary to bring it into compliance and shall pay for the unlicensed capacity at the NYS Net Price in effect at time of audit, or if none, then at the Contractor’s U.S. Commercial list price. Once such additional licenses or capacities are purchased, Licensee shall be deemed to have been in compliance retroactively, and Licensee shall have no further liability of any kind for the unauthorized use of the software.
Licensed Product The term “Licensed Product” shall mean any product (a) the manufacture, use, importation, sale or offer for sale of which would, in the absence of the license granted by this Agreement, infringe a Valid Claim of any of the Licensed Patent Rights, or (b) that is comprised of, utilizes or incorporates Licensed Biological Materials, or (c) that is discovered, developed or made using a Licensed Process.
Commercialization License Subject to the terms of this Agreement, including without limitation Section 2.2 and Theravance's Co-Promotion rights in Section 5.3.2, Theravance hereby grants to GSK, and GSK accepts, an exclusive license under the Theravance Patents and Theravance Know-How to make, have made, use, sell, offer for sale and import Alliance Products in the Territory.
Sublicense Fees Licensee will pay Sublicense Fees indicated in Section 3.1(e) of the Patent & Technology License Agreement on or before the Quarterly Payment Deadline for the Contract Quarter.
Sublicensees Licensee shall have the right (but not the obligation) to sublicense those rights granted to it under Section 2.1 only as set forth in, and subject to the terms and conditions of, Section 2.5 and this Section 2.3.2, to (a) any Person (other than a Specified Person) with the prior written consent of Lxxxx, which consent will not be unreasonably withheld, conditioned or delayed; provided that Licensee may contract in the ordinary course of business with any Third Party contract research organization (“CRO”) or contract development and manufacturing organization (“CMO”) to handle certain clinical Development or Manufacturing activities, in Licensee’s reasonable discretion, without requiring Lilly’s consent; provided further that such CRO or CMO are working on Licensee’s behalf, (b) any of its Affiliates (only for so long as they remain Affiliates), provided that Licensee provides prior written notice (at least 20 Business Days in advance) to Lilly of any sublicenses to be granted to any Affiliate or its request for approval of any sublicense to be granted to any other Person, which shall include in each case a description of the rights to be granted and the purpose therefor, the identity of the proposed Sublicensee and the countries involved, or (c) a Specified Person. Each Affiliate or other Person to which any such sublicense is granted is referred to herein as a “Sublicensee.” Licensee shall remain responsible for the performance by each of its Sublicensees and shall cause each of its Sublicensees to comply with the applicable provisions of this Agreement, and Licensee shall be liable for the acts or omissions of its Sublicensees under or in connection with this Agreement (as if such acts or omission were those of Licensee). Without limiting the foregoing, Licensee shall: (x) ensure that each of its Sublicensees accepts in writing all applicable terms and conditions of this Agreement, including the non-compete, reporting, audit, inspection and confidentiality provisions hereunder; (y) under the agreements between Licensee and each of its Sublicensees, include a provision pursuant to which either (a) Lilly is named as a third-party beneficiary or (b) a mechanism (for example, a power of attorney) is implemented for Lxxxx to enforce all applicable terms and conditions of this Agreement against the Sublicensee in a manner reasonably satisfactory to Lilly, provided that, in each case, Lxxxx shall not proceed against any Sublicensee unless Lxxxx has first provided Licensee with written notice of the Sublicensee’s breach and Licensee has not, within 90 days after receipt of such notice, caused the Sublicensee to cease the breaching activity or otherwise cure the breach, in each case, to the reasonable satisfaction of Lxxxx; and (z) terminate all relevant agreements with any such Sublicensee in the case of any breach of such terms and conditions by such Sublicensee. A Sublicensee shall have the right to grant further sublicenses, subject to complying with the terms of this Section 2.3.2 with respect to further Sublicensees. For the avoidance of doubt, (i) Licensee will remain directly responsible for all amounts owed to Lilly under this Agreement, and (ii) each Sublicensee is subject to the negative and restrictive covenants set forth in Sections 2.2.1 and 2.4, respectively. Licensee hereby expressly waives any requirement that Lxxxx exhaust any right, power or remedy, or proceed against a subcontractor, for any obligation or performance hereunder prior to proceeding directly against Licensee. Notwithstanding anything to the contrary, (A) all sublicenses granted hereunder shall automatically terminate upon expiration or termination of this Agreement for any reason and (B) if the Parties enter into an agreement pursuant to Section 2.5 with respect to the Product, then as of the effective date of such agreement all sublicenses granted with respect to the Product shall automatically terminate, except as otherwise mutually agreed by the Parties in writing (and in no event shall any negotiations for any such agreement pursuant to Section 2.5 be conditioned on or otherwise affected by whether Lxxxx agrees to allow any such sublicenses to continue).
SOURCE CODE ESCROW FOR LICENSED PRODUCT If Source Code or Source Code escrow is offered by either Contractor or Product manufacturer or developer to any other commercial customers, Contractor shall either: (i) provide Licensee with the Source Code for the Product; or (ii) place the Source Code in a third party escrow arrangement with a designated escrow agent who shall be named and identified to the State, and who shall be directed to release the deposited Source Code in accordance with a standard escrow agreement acceptable to the State; or (iii) will certify to the State that the Product manufacturer/developer has named the State, acting by and through the Authorized User, and the Licensee, as a named beneficiary of an established escrow arrangement with its designated escrow agent who shall be named and identified to the State and Licensee, and who shall be directed to release the deposited Source Code in accordance with the terms of escrow. Source Code, as well as any corrections or enhancements to such source code, shall be updated for each new release of the Product in the same manner as provided above and such updating of escrow shall be certified to the State in writing. Contractor shall identify the escrow agent upon commencement of the Contract term and shall certify annually that the escrow remains in effect in compliance with the terms of this clause. The State may release the Source Code to Licensees under this Contract who have licensed Product or obtained services, who may use such copy of the Source Code to maintain the Product.
New Products You agree to comply with NASD Notice to Members 5-26 recommending best practices for reviewing new products.
Combination Products If a LICENSED PRODUCT is sold to any third party in combination with other products, devices, components or materials that are capable of being sold separately and are not subject to royalties hereunder (“OTHER PRODUCTS,” with the combination of products being referred to as “COMBINATION PRODUCTS” and the Other Product and Licensed Product in such Combination Product being referred to as the “COMPONENTS”), the NET SALES of such LICENSED PRODUCT included in such COMBINATION PRODUCT shall be calculated by multiplying the NET SALES of the COMBINATION PRODUCT by the fraction A/(A+B), where A is the average NET SALES price of such LICENSED PRODUCT in the relevant country, as sold separately, and B is the total average NET SALES price of all OTHER PRODUCTS in the COMBINATION PRODUCT in the relevant country, as sold separately. If, in any country, any COMPONENT is not sold separately, NET SALES for royalty determination shall be determined by the formula [C / (C+D)], where C is the aggregate average fully absorbed cost of the Licensed Product components during the prior Royalty Period and D is the aggregate average fully absorbed cost of the other essential functional components during the prior Royalty Period, with such costs being determined in accordance with generally accepted accounting principles. To the extent that any SUBLICENSE INCOME relates to a COMBINATION PRODUCT or is otherwise calculated based on the value of one or more licenses or intellectual property rights held by the COMPANY, an AFFILIATE or SUBLICENSEE, COMPANY shall determine in good faith and report to THE PARTIES the share of such payments reasonably attributable to COMPANY’s or such AFFILIATE’s sublicense of the rights granted hereunder, based upon their relative importance and proprietary protection, which portion shall be the SUBLICENSE INCOME. THE PARTIES shall have the right to dispute such sharing determination in accordance with the dispute provisions of the AGREEMENT.
