Setting the Time-of-Day Sample Clauses

Setting the Time-of-Day. Press SET, then CLOCK. The display shows ‘TIME OF DAY’ followed by ‘TD:’ and then the time-of-day. Time is entered in 24 hour format (military time). If the actual time is 3:27 PM, it is entered as 15.27. Enter the correct local time using the numeric keys on the keypad. Press ENTER to save it.
Sample 1Sample 2
AutoNDA by SimpleDocs
Setting the Time-of-Day. Rotate the Main Drive Gear on the Motor Module with an upward push of the thumb until the correct hour on the black Time of Day Dial aligns with the pointed alignment xxxx on the modules. Figure 5 – 6 Paragon Program Module Paragon Program Module Replacement Removal Turn off power to control panel and meter. Check the Paragon to assure technician safety. Disconnect and xxxx wires from the switch at the top rear of the Module. The switch terminals are C, NC, and NO. Adjust the timer so all the red tabs on the Minute Dials are facing directly front of the timer. At the bottom rear of the module, pull down on the plastic latching lever and out on the bottom of the Module.
Sample 1

Related to Setting the Time-of-Day

  • Computation of Period of Days, Deadline In computing a period of days, when the ending date is not 54 specified, the first day is excluded and the last day is included, e.g., three days after MEC. If any deadline falls on a Saturday, 55 Sunday or federal or Colorado state holiday (Holiday), such deadline Will Will Not be extended to the next day that is not

  • Length of Day The total workday shall consist of not more than 7 hours and 45 minutes and shall include a scheduled duty-free lunch period as provided to employees or SUCCESS employees under Subsection 3 of this Article.

  • Program Requirements Provided At No Charge to the Judicial Council A. The Contractor shall provide the following items during the Program at no charge to the Judicial Council:

  • METHOD OF CALCULATION OF PROPORTIONATE SHARE WHEREVER REFERRED TO IN THE AGREEMENT Wherever in this Agreement it is stipulated that the Allottee has to make any payment, in common with other Allottee(s) in Project, the same shall be the proportion which the carpet area of the [Apartment/Plot] bears to the total carpet area of all the [Apartments/Plots] in the Project.

  • Number of Days In computing the number of days for purposes of this Agreement, all days shall be counted, including Saturdays, Sundays and holidays; provided, however, that if the final day of any time period falls on a Saturday, Sunday or holiday on which federal banks are or may elect to be closed, then the final day shall be deemed to be the next day which is not a Saturday, Sunday or such holiday.

  • Definition of Days A day shall mean calendar days, however, where a deadline occurs on a Saturday, Sunday or Holiday (as identified in Article 25), the deadline shall be extended to the next normal business day.

  • Terminating the Agreement With reasonable cause, either Client or Contractor may terminate this Agreement, effective immediately upon giving written notice. Reasonable cause includes: A material violation of this Agreement; Any act exposing the other party to liability to others for personal injury or property damage; or Either party terminating this Agreement at any time by giving days' written notice to the other party of the intent to terminate.

  • Sending the agenda The chairperson of a Consortium Body shall prepare and send each Member of that Consortium Body a written (original) agenda no later than the minimum number of days preceding the meeting as indicated below. General Assembly 21 calendar days, 10 calendar days for an extraordinary meeting Executive Board 7 calendar days

  • ENDING THE TENANCY 1) The tenant may end a monthly, weekly or other periodic tenancy by giving the landlord at least one month's written notice. A notice given the day before the rent is due in a given month ends the tenancy at the end of the following month. [For example, if the tenant wants to move at the end of May, the tenant must make sure the landlord receives written notice on or before April 30th.]

  • PROVISIONS REQUIRED BY LAW DEEMED INSERTED Each and every provision of law and clause required by law to be inserted in this Contract shall be deemed to be inserted herein and this Contract shall be read and enforced as though it were included therein.

Time is Money Join Law Insider Premium to draft better contracts faster.