SKILLED PERSONNEL AND CONSULTANTS. The parties shall make available suitably skilled personnel and consultants to conduct the Acceptance Test Procedures on the System as stipulated in Schedule 5 for each milestone of the XXXXX Chart.
SKILLED PERSONNEL AND CONSULTANTS Sample Clauses
Related to SKILLED PERSONNEL AND CONSULTANTS
Sub-Consultants All sub-consultants shall comply with each and every insurance provision of this Section 3.
Subconsultants Whichever of the following is marked applies to this Approved Service Order: The Consultant can not use any subconsultants. The Consultant can use the following subconsultants to assist in providing the required services and deliverables: 2. 3.
Employees and Consultants Pubco does not have any employees or consultants, except as disclosed in the Pubco SEC Documents.
Personnel Provide, without remuneration from or other cost to the Trust, the services of individuals competent to perform the administrative functions which are not performed by employees or other agents engaged by the Trust or by the Adviser acting in some other capacity pursuant to a separate agreement or arrangement with the Trust.
B4 Key Personnel The Contractor acknowledges that the Key Personnel are essential to the proper provision of the Services to the Authority.
Architects, Consultants and Contractors Landlord and Tenant hereby acknowledge and agree that: (i) the general contractor and any subcontractors for the Tenant Improvements shall be selected by Landlord, subject to Tenant’s approval, which approval shall not be unreasonably withheld, conditioned or delayed, and (ii) DGA shall be the architect (the “TI Architect”) for the Tenant Improvements.
DISCIPLINE OF EMPLOYEES Section 1: All charges preferred by the Employer against its employees for violation of its rules or other offenses must be preferred within five (5) days after any such alleged violation or offense has been made known to the official or officials of the Employer or their designees. If the charges are not preferred within the time limits set forth herein, such alleged violation or offense shall be forever barred and extinguished, provided, however, that any violation of the rules pertaining to the mishandling of fares or mis-appropriation of the Employer's funds or property shall not come within the scope of the foregoing provisions of this Section. Additionally, any discipline meted out in other than fare violations must be begun within five (5) days of notification to the employee. Section 2: If any employee is charged with an offense involving the mishandling of fares, drunkenness, possession or use of an illegal substance or the misappropriation of the Employer's funds or property, neither such charges nor discipline meted out in connection therewith shall be subject to the grievance and arbitration procedures provided for in this Agreement unless and until the grievance and/or demands for arbitration in such cases be accompanied by a signed authorization from the employee involved releasing the Employer and the Union to submit any and all information and facts pertaining to the case to whomever they may concern. Section 3: When the Employer disciplines an employee and/or places a written entry of the incident in the employee's file, the employee and Union involved shall be furnished a copy of the entry. An employee may examine and copy from his/her own employee file at any reasonable time. After thirty (30) months all materials pertaining to discipline in an employee's file will not be used for disciplinary purposes. Section 4: If, as a result of investigation or upon appeal, the discipline, suspension or dismissal of an employee is found to have been without just cause, his/her record of the alleged offense will be cleared, and if time has been lost, the employee will be paid for such loss of time by the Employer in accordance with the amount s/he would have received had s/he not been held from service.
SKILLED TRADES The Company agrees that maintenance employees are engaged to perform wholly maintenance duties, however, they may perform production duties until the set up or repair has been completed. Also, production employees may catty our minor adjustments and repairs. The Company will establish a tool allowance over the lifetime of this agreement of ($210.00 per contract year) to be used as a credit for the purchase of tools deemed necessary or as required by the Company by all Maintenance Men, Maintenance Machinists and Stationary Engineers In the event an employee eligible for a tool allowance terminates their and has exceeded their allowance of per contract year, then such excess will be withheld from their final earnings. Electronic Technician Electrician Maintenance Maintenance Maintenance Stationary Engineer (Chief) Stationary Engineer Pollution Control Operator Maintenance Trainee Oiler and Greaser Mould Cleaner Stores Roving C Remelt Pot Operator Material Handler Scrap Pickup Oxide Mill Operator Acid Tender Janitor Battery Repair Warehouser Stock Picker Circuit Tender Circuit Tender Commercial Re-Charge Operator Starting rate shall be below published job rate. Publishedjob rate to be effective no later than completion of probationary period. A premium of per hour over the published rate for employees designated as a lead hand by the Company. Base Rate Pasting Machine Operator Off-Bearer Paste Mixing Parting Machine Operator Off-Bearer Forming Room Operator Negative On-Bearedoperator Sinker Assembly Foundry Box Developing Operator Packaging Operator Floater of Jobs Element Burner Sinker Intercell Burner Stacking Operator Off-Bearer Stacking Assembly Burner Battery On-Bearer Place Covers & Mix Resin Inverter Resin Operator Saw Parting CLASSIFICATION SKILLED SEMI-SKILLED * * * Electronic Technician Electrician Maintenance Machinist Maintenance Class Maintenance Class Maintenance Trainee Oiler and Greaser * * * Pollution Control Operator Stationary Engineer Chief Stationary Engineer * Mold Cleaner Stores Machine Operator Off-Bearer Paste Mixing Operator Off-Bearer Operator Negative Ovens Circuit Tender On-Bearer Sinker Assembly SKILLED SEMI-SKILLED * * * * * * * * *
Consultants Any and all consultant(s), sub-consultant(s), subcontractor(s), or agent(s) to the Architect.
Employees and Contractors The Recipient agrees to disclose Confidential Information to any agents, affiliates, directors, officers, or any other employees, collectively known as the “Employees,” solely on a need-to-know basis and represents that such Employees have signed appropriate non-disclosure agreements or have taken appropriate measures imposing on such Employees a duty to third parties: i.) To hold any third-party proprietary information received by such Employees in the strictest confidence; ii.) Not to disclose such third-party Confidential Information to any other third party; and iii.) Not to use such Confidential Information for the benefit of anyone other than to whom it belongs, without the prior express written authorization of the Owner.
