Temperature continuously Sample Clauses

Temperature continuously. To the extent the Interconnected Party can demonstrate to First Gas with reasonable supporting evidence (including by reference to the design and operation of the relevant gas production and processing facility) that: none of the characteristics or components in the above table can exceed; or one or more of the components (e) to (h) in the above table does not occur at all, or occurs only at a much lower concentration compared to, the relevant limit set out in the Gas Specification, the Interconnected Party may with First Gas’ written approval (not to be unreasonably withheld or delayed) measure and/or determine that characteristic or component less frequently than stipulated in the above table, provided always that its monitoring is sufficient to demonstrate compliance with the Gas Specification. First Gas may disclose any exceptions to the testing frequencies set out in section 6.10 to any other person, including by publishing that information on ▇▇▇▇▇. Where it also produces the gas it injects, the Interconnected Party shall at its cost test for each of the components (e) to (h) in section 6.10 following any material change in the source or composition of its gas, including in the proportions of gas obtained from any new reservoir and/or production zones in any reservoir. The Interconnected Party shall determine the values of the characteristics or components (d) to (i) in section 6.10 by direct measurement or testing. When so doing the Interconnected Party shall use only: industry standard equipment and facilities and suitably qualified and competent persons; and either the relevant test method specified in the Gas Specification or such other method as will produce results that are no less accurate or reproducible. The Interconnected Party may determine the value of characteristic (c) in section 6.10 by calculation from the composition of gas injected, provided that: it obtains First Gas’ approval (not to be unreasonably withheld); and the method it uses is sufficiently accurate to meet the requirements of the Gas Specification. No Contaminants During both normal operations and when pigging or otherwise cleaning its Pipeline, the Interconnected Party shall ensure that all gas it injects at a Receipt Point is free of dust and other solid and liquid matter, including hydrocarbon liquids, wax, gums, compressor oil and unsaturated hydrocarbons, that might cause damage to or interfere with First Gas Equipment or First Gas’ Pipeline through which it flows, e...