Geographic Area and Sector Specific Allowances, Conditions and Exceptions The following allowances and conditions shall apply where relevant. Where the Employer does work which falls under the following headings, the Employer agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.
General Conditions (i) Each party will make each payment or delivery specified in each Confirmation to be made by it, subject to the other provisions of this Agreement.
(ii) Payments under this Agreement will be made on the due date for value on that date in the place of the account specified in the relevant Confirmation or otherwise pursuant to this Agreement, in freely transferable funds and in the manner customary for payments in the required currency. Where settlement is by delivery (that is, other than by payment), such delivery will be made for receipt on the due date in the manner customary for the relevant obligation unless otherwise specified in the relevant Confirmation or elsewhere in this Agreement.
(iii) Each obligation of each party under Section 2(a)(i) is subject to (1) the condition precedent that no Event of Default or Potential Event of Default with respect to the other party has occurred and is continuing, (2) the condition precedent that no Early Termination Date in respect of the relevant Transaction has occurred or been effectively designated and (3) each other applicable condition precedent specified in this Agreement.
– OTHER SPECIAL CONDITIONS I.
12.1 Exchange rate applicable for the conversion of currencies into euro Payments shall be made by the Commission in euro. The co-ordinator shall submit the payment requests in accordance with article I.5.3, including the underlying financial statements, in euro. By way of derogation from article II.16.1, any conversion of actual costs into euro shall be made by the beneficiary at the monthly accounting rate established by the Commission and published on its website applicable on the day when the cost was incurred.
Environmental Conditions A Phase I environmental site assessment (or update of a previous Phase I and or Phase II environmental site assessment) and, with respect to certain Mortgage Loans, a Phase II environmental site assessment (collectively, an “ESA”) meeting ASTM requirements conducted by a reputable environmental consultant in connection with such Mortgage Loan within 12 months prior to its origination date (or an update of a previous ESA was prepared), and such ESA (i) did not identify the existence of recognized environmental conditions (as such term is defined in ASTM E1527-13 or its successor, hereinafter “Environmental Condition”) at the related Mortgaged Property or the need for further investigation, or (ii) if the existence of an Environmental Condition or need for further investigation was indicated in any such ESA, then at least one of the following statements is true: (A) an amount reasonably estimated by a reputable environmental consultant to be sufficient to cover the estimated cost to cure any material noncompliance with applicable Environmental Laws or the Environmental Condition has been escrowed by the related Mortgagor and is held or controlled by the related Mortgagee; (B) if the only Environmental Condition relates to the presence of asbestos-containing materials, radon in indoor air, lead based paint or lead in drinking water, the only recommended action in the ESA is the institution of such a plan, an operations or maintenance plan has been required to be instituted by the related Mortgagor that can reasonably be expected to mitigate the identified risk; (C) the Environmental Condition identified in the related environmental report was remediated or abated in all material respects prior to the date hereof, and, if and as appropriate, a no further action or closure letter was obtained from the applicable governmental regulatory authority (or the environmental issue affecting the related Mortgaged Property was otherwise listed by such governmental authority as “closed” or a reputable environmental consultant has concluded that no further action is required); (D) an environmental policy or a lender’s pollution legal liability insurance policy that covers liability for the identified circumstance or condition was obtained from an insurer rated no less than “A-” (or the equivalent) by Xxxxx’x Investors Service, Inc., S&P Global Ratings, acting through Standard & Poor’s Financial Services LLC, Fitch Ratings, Inc. and/or A.M. Best Company; (E) a party not related to the Mortgagor was identified as the responsible party for such condition or circumstance and such responsible party has financial resources reasonably estimated to be adequate to address the situation; or (F) a party related to the Mortgagor having financial resources reasonably estimated to be adequate to address the situation is required to take action. To the Mortgage Loan Seller’s knowledge, except as set forth in the ESA, there is no Environmental Condition (as such term is defined in ASTM E1527-13 or its successor) at the related Mortgaged Property.
General Conditions; Definitions 1.01. The General Conditions (as defined in the Appendix to this Agreement) constitute an integral part of this Agreement.
1.02. Unless the context requires otherwise, the capitalized terms used in this Agreement have the meanings ascribed to them in the General Conditions or in the Appendix to this Agreement.
General Condition The Aircraft will:
(a) be clean by international airline standards;
(b) have installed the full complement of engines and other material equipment, parts and accessories and loose equipment required under the Agreed Maintenance Program and installed in the other Boeing/XxXxxxxxx Xxxxxxx MD-87 aircraft operated by Lessee (together with any additions and improvements thereto, or replacements thereof, effected pursuant to and in accordance with this Agreement) and be in a condition suitable for immediate operation in commercial service;
(c) be airworthy, conform to type design and be in a condition for safe operation with all equipment, components and systems operating in accordance with their intended use and within limits established by the manufacturer and approved by the Aviation Authority, and all pilot discrepancies and deferred maintenance items cleared on a terminating action basis;
(d) have a U.S. Standard Transport Category Certificate of Airworthiness issued by the FAA in accordance with FAR Part 129 (or if required by the Lessor, be eligible for a valid export certificate of airworthiness with respect to the Aircraft issued by the Aviation Authority) and unconditionally meet all FAA requirements for immediate operations under FAR Part 129;
(e) comply with the manufacturer's original specification to the extent that it so complied on the date of this Agreement and subject to any alterations made pursuant to and in accordance with this Agreement after such date;
(f) have undergone, immediately prior to redelivery, the MSG-3 equivalent of a "C" Check in accordance with the Agreed Maintenance Program so that all Airframe inspections falling due within the next 3,000 hours, 3,000 cycles or twelve months (whichever is applicable and most limiting) of operation in accordance with the Agreed Maintenance Program have been accomplished;
(g) if the Flight Hours of the Airframe remaining until the scheduled completion of the Major Checks (collectively, a "Complete Heavy Work Package") on the Expiry Date are:
(i) less than on the Delivery Date, then the Lessee shall pay to the Lessor an amount equal to the product of (a) the number of Flight Hours remaining until the scheduled completion of a Complete Heavy Work Package as of the Expiry Date that are less than the number of Flight Hours that were remaining until the scheduled completion of a Complete Heavy Work Package as of the Delivery Date (b) multiplied by US$50.00, provided, however, that no payment shall be due from -------- ------- Lessee under this clause (g)(i) if, immediately preceding the redelivery of the Aircraft, the Lessee has performed a Complete Heavy Work Package;
(ii) more than on the Delivery Date, then the Lessor shall pay to the Lessee an amount equal to the product of (a) the number of Flight Hours remaining until the scheduled completion of a Complete Heavy Work Package as of the Expiry Date that are more than the number of Flight Hours that were remaining until the scheduled completion of a Complete Heavy Work Package as of the Delivery Date (b) multiplied by US$50.00; For the avoidance of doubt, any amounts due to the Lessor pursuant to this clause (g) may be set off against any amounts due to Lessee pursuant to paragraphs (b) or (d) of Schedule 10 and a payment made for the net amount due;
(h) have complied with all airworthiness directives and mandatory orders affecting that model of Aircraft issued by the Aviation Authority (and, if different, the FAA) that are required terminating action during the Term;
(i) no special or unique manufacturer inspection or check requirements specific to the Aircraft will exist unless there is no terminating action available from any source;
(j) have installed all applicable vendor's and manufacturer's service bulletin kits received free of charge by the Lessee that are appropriate for the Aircraft and, to the extent not installed, those kits which have been received with respect to this Aircraft will be furnished free of charge to the Lessor;
(k) be free of any system-related leaks which are outside maintenance manual limitations;
(l) all fluid reservoirs (including fuel, oil, oxygen, hydraulic and water) will be full, and the waste tank serviced in accordance with the manufacturer's instructions;
(m) if required under the Approved Maintenance Program, all fuel tanks will have recently undergone an anti-fungus/biological growth contamination laboratory evaluation, and any excessive levels of contamination corrected;
(n) have an FAA-approved aging aircraft program in operation and up-to-date; and
(o) have all signs and decals clean, secure and legible.
SPECIAL CONDITIONS A submitted appeal must;
General Conditions Applicable to Option to Build If the Interconnection Customer assumes responsibility for the design, procurement and construction of the Participating TO's Interconnection Facilities and Stand Alone Network Upgrades,
(1) the Interconnection Customer shall engineer, procure equipment, and construct the Participating TO's Interconnection Facilities and Stand Alone Network Upgrades (or portions thereof) using Good Utility Practice and using standards and specifications provided in advance by the Participating TO;
(2) The Interconnection Customer’s engineering, procurement and construction of the Participating TO's Interconnection Facilities and Stand Alone Network Upgrades shall comply with all requirements of law to which the Participating TO would be subject in the engineering, procurement or construction of the Participating TO's Interconnection Facilities and Stand Alone Network Upgrades;
(3) the Participating TO shall review, and the Interconnection Customer shall obtain the Participating TO’s approval of, the engineering design, equipment acceptance tests, and the construction of the Participating TO's Interconnection Facilities and Stand Alone Network Upgrades, which approval shall not be unreasonably withheld, and the CAISO may, at its option, review the engineering design, equipment acceptance tests, and the construction of the Participating TO's Interconnection Facilities and Stand Alone Network Upgrades;
(4) prior to commencement of construction, the Interconnection Customer shall provide to the Participating TO, with a copy to the CAISO for informational purposes, a schedule for construction of the Participating TO's Interconnection Facilities and Stand Alone Network Upgrades, and shall promptly respond to requests for information from the Participating TO;
(5) at any time during construction, the Participating TO shall have the right to gain unrestricted access to the Participating TO's Interconnection Facilities and Stand Alone Network Upgrades and to conduct inspections of the same;
(6) at any time during construction, should any phase of the engineering, equipment procurement, or construction of the Participating TO's Interconnection Facilities and Stand Alone Network Upgrades not meet the standards and specifications provided by the Participating TO, the Interconnection Customer shall be obligated to remedy deficiencies in that portion of the Participating TO's Interconnection Facilities and Stand Alone Network Upgrades;
(7) the Interconnection Customer shall indemnify the CAISO and Participating TO for claims arising from the Interconnection Customer's construction of the Participating TO's Interconnection Facilities and Stand Alone Network Upgrades under the terms and procedures applicable to Article 18.1
Additional Conditions As a condition to any such assignment or subletting, whether or not Landlord’s consent is required, Landlord may require:
(i) that any assignee or subtenant agree, in writing at the time of such assignment or subletting, that if Landlord gives such party notice that Tenant is in default under this Lease, such party shall thereafter make all payments otherwise due Tenant directly to Landlord, which payments will be received by Landlord without any liability except to credit such payment against those due under the Lease, and any such third party shall agree to attorn to Landlord or its successors and assigns should this Lease be terminated for any reason; provided, however, in no event shall Landlord or its successors or assigns be obligated to accept such attornment; and
(ii) A list of Hazardous Materials, certified by the proposed assignee or sublessee to be true and correct, which the proposed assignee or sublessee intends to use, store, handle, treat, generate in or release or dispose of from the Premises, together with copies of all documents relating to such use, storage, handling, treatment, generation, release or disposal of Hazardous Materials by the proposed assignee or subtenant in the Premises or on the Project, prior to the proposed assignment or subletting, including, without limitation: permits; approvals; reports and correspondence; storage and management plans; plans relating to the installation of any storage tanks to be installed in or under the Project (provided, said installation of tanks shall only be permitted after Landlord has given its written consent to do so, which consent may be withheld in Landlord’s sole and absolute discretion); and all closure plans or any other documents required by any and all federal, state and local Governmental Authorities for any storage tanks installed in, on or under the Project for the closure of any such tanks. Neither Tenant nor any such proposed assignee or subtenant is required, however, to provide Landlord with any portion(s) of the such documents containing information of a proprietary nature which, in and of themselves, do not contain a reference to any Hazardous Materials or hazardous activities.
NON-SEXIST ENVIRONMENT 1. A non-sexist environment is defined as that in which there is no discrimination against females or males by portraying them in gender stereotyped roles or by omitting their contributions.
2. The employer does not condone and will not tolerate any written or verbal expression of sexism. In September of each school year the employer and the local shall jointly notify administrative officers and staff, in writing, of their commitment to a non-sexist environment.
3. The employer and the local shall promote a non-sexist environment through the development, integration, and implementation of non-sexist educational programs, activities, and learning resources for both staff and students.
