Service Descriptions Available services for Transitional and Enhanced Supervision Services a. One (1) one-to-one meeting with the Contractor per week for case management services.
Site Description 2.5.1 If reasonably requested by the A/E as necessary for the Project, the Owner shall furnish a legal description and a certified land survey of the Site, giving, as applicable, grades and lines of streets, alleys, pavements and adjoining property; rights-of-way, restrictions, easements, encroachments, zoning, deed restrictions, boundaries and contours of the Site; locations, dimensions, and complete data pertaining to existing buildings, other improvements, and trees; and full information concerning available service and utility lines, both public and private, above and below grade, including inverts and depths.
Service Description The Parties will provide Common Channel Signaling (CCS) to one another via Signaling System 7 (SS7) network Interconnection, in accordance with prevailing industry standards. Use of a third party provider of SS7 trunks is permitted.
Task Description This task includes activities associated with permit-required monitoring conducted in accordance with the conditions specified by state or federal regulatory agencies. All monitoring tasks must be located within or adjacent to the Project area and follow the Department’s Regional Coastal Monitoring Program and FWC's marine turtle and shorebird monitoring programs. Guidance for monitoring of nearshore resources is available in the Department's Standard Operation Procedures For Nearshore Hardbottom Monitoring Of Beach Nourishment Projects. The Local Sponsor must submit work products directly to the appropriate state or federal regulatory agencies in accordance with permit conditions to be eligible for reimbursement under this task, unless otherwise directed.
Changes to Scope of Work The City of Nashua may, at any time, by written order, make changes to the general scope, character, or cost of this contract and in the services or work to be performed, either increasing or decreasing the scope, character, or cost of Independent Contractor's performance under the contract. Independent Contractor shall provide to the City of Nashua within 10 calendar days, a written proposal for accomplishing the change. The proposal for a change shall provide enough detail, including personnel hours for each sub-task and cost breakdowns of tasks, for the City of Nashua to be able to adequately analyze the proposal. The City of Nashua will then determine in writing if Independent Contractor should proceed with any or all of the proposed change. If the change causes an increase or a decrease in Independent Contractor's cost or time required for performance of the contract as a whole, an equitable adjustment shall be made and the contract accordingly modified in writing. Any claim of Independent Contractor for adjustment under this clause shall be asserted in writing within 30 days of the date the City of Nashua notified Independent Contractor of the change. When Independent Contractor seeks changes, Independent Contractor shall, before any work commences, estimate their effect on the cost of the contract and on its schedule and notify the City of Nashua in writing of the estimate. The proposal for a change shall provide enough detail, including personnel hours for each sub-task and cost breakdowns of tasks, for the City of Nashua to be able to adequately analyze the proposal. The City of Nashua will then determine in writing if Independent Contractor should proceed with any or all of the proposed change. Except as provided in this paragraph, Independent Contractor shall implement no change unless the City of Nashua in writing approves the change. Unless otherwise agreed to in writing, the provisions of this contract shall apply to all changes. The City of Nashua may provide verbal approval of a change when the City of Nashua, in its sole discretion, determines that time is critical or public health and safety are of concern. Any verbal approval shall be confirmed in writing as soon as practicable. Any change undertaken without prior City of Nashua approval shall not be compensated and is, at the City of Nashua's election, sufficient reason for contract termination.
System Description The DLCS is a network consisting of devices which are remotely controlled over RF transmission equipment by the PowerCAMPTM Software or equivalent. CL&P shall have access to the PowerCAMP™ LMS (as defined below) via the web interface. The PowerCAMPTM LMS shall include the software and hardware necessary to manage the Control Devices installed at the End-use Equipment at Participating Facilities. The PowerCAMPTM LMS includes AER’s PowerCAMPTM Server and PowerCAMPTM Suite, networking equipment, and third party software. PowerCAMPTM LMS Hardware
Work Description T-804 Opening Roads - Removal of closure devices, cleaning ditches, removing berms, and blading the traveled-way T-811 Closing Roads - Entrance treatment for 150' cross-rip; debris block (slash, earth, berm, rocks, etc.) + seed + water bar T-811 Closing Roads - Water bar frequency per BMPs for remainder of road T-811 Closing Roads - Engineering Rep. or Construction Inspector must be notified prior to performing closeout NFSR Road No. Lane Width & Maintenance Level Mile Marker Begin End 76L Single Lane / Level 2 76 0.00 Ending 0.48
Topic Description Licensee Responsibilities Licensee must: Take appropriate steps to ensure the security, integrity, and confidentiality of Confidential Information and must comply with all relevant applicable laws and regulations, including laws protecting borrower privacy. Not disclose Confidential Information to third parties, without Xxxxxx Mae’s prior written approval, except on a need‐to‐know basis to Licensee’s partners, Topic Description affiliates, officers, employees, directors, contractors, counsels, agents or representatives, provided they are subject to confidentiality obligations at least as stringent as those set forth in this Section A3. Not use Confidential Information in any way that could be viewed as a conflict of interest, a breach of confidentiality or privacy, or the gaining of an unfair advantage from the relationship with Xxxxxx Xxx. Implement commercially reasonable measures meeting or exceeding industry standards to ensure the security, integrity, and confidentiality of Confidential Information, including using industry‐standard encryption for data in transit and virus checking programs designed to prevent the transmission and receipt of viruses and other malicious code, implementing appropriate disaster recovery and back‐up procedures, implementing appropriate procedures to prevent disclosure of data and other materials to a party other than the intended recipient, and employing methods for securely disposing or destroying such information. These measures must meet, at least, the same level of protection that the Receiving Party seeks for its own information of a similar nature. Licensee must collaborate with Xxxxxx Mae in assessing the sufficiency of these measures and Licensee’s information security program, upon reasonable request. Instruct its Related Parties who may receive Confidential Information about the requirements of this Section A3, and the processes and procedures necessary to comply with them. Comply with all reasonable security policies and procedures required by Xxxxxx Xxx related to the access and use of Xxxxxx Mae’s systems or any Licensed Materials. Not transmit to Xxxxxx Mae’s systems any materials that contain bugs, viruses, worms or other functions, routines, devices or instructions which may create any unauthorized access or damage to, or interruption in the functioning of, the Licensed Application or Xxxxxx Mae’s systems. Restrictive Legends Licensee must abide by and reproduce and include any restrictive legend or proprietary rights notice that appears in or on any Confidential Information of Xxxxxx Xxx or any Third‐Party Licensor (or other third‐party owner) that it is authorized to reproduce. Licensee also agrees that it will not remove, alter, cover or distort any trademark, trade name, copyright or other proprietary rights notices, legends, symbols or labels appearing on or in any Confidential Information of Xxxxxx Mae or any Third‐Party Licensor (or other third‐party owner). Required Actions in Case of Data Breach Licensee must address any Data Breach with prompt and effective corrective action, including cooperation with Xxxxxx Xxx in the investigation and remediation of such Data Breach, as well as prompt disclosure and notification where legally required; and Licensee must promptly notify Xxxxxx Mae of any Data Breach in writing ‐‐ at xxxxxxx_xxxxxxxxxxxx@xxxxxxxxx.xxx ‐‐ and must take all steps reasonably requested by Xxxxxx Xxx to mitigate the consequences of such Data Breach.
000 SCOPE OF WORK 5.100 The scope of this Agreement covers all work of a maintenance, repair and renovation nature, assigned by the Owner to the Company and performed by the employees of the Company covered by this Agreement, within the limits of the Owner's plant site.
Brief Description Identification of the device: mirror, camera/monitor, other device 2/ Device for indirect vision of Class I, II, III, IV, V, VI, S 2/ Δ Symbol 2m as defined in paragraph 6.1.3.1.1. of this Regulation: yes/no 2/ Annex 3
