Transfer of Technology 1. The Parties agree to exchange views and information on their law and international practices on the protection and enforcement of intellectual property rights, affecting transfer of technology. This shall, in particular, include exchanges on measures to facilitate information flows, business partnerships, and voluntary licensing and subcontracting agreements. Particular attention shall be paid to the conditions necessary to create an adequate enabling environment for technology transfer in the host countries, including issues such as the domestic legal framework and the development of human capital.
2. When measures are taken with regard to technology transfer, the legitimate interests of the intellectual property right holders shall be protected.
Transfer of Materials To facilitate the conduct of activities under the Research Plan or an Additional Research Plan, as applicable, either Party (the “Transferor Party”) may, at its election, provide Materials to the other Party (the “Transferee Party”) solely as mutually agreed by the Parties or as set forth in the Research Plan or any Additional Research Plan. All such Materials (a) will remain the sole property of the Transferor Party, (b) will be used only in the exercise if the Transferee Party’s rights or fulfillment of the Transferee Party’s obligations under this Agreement, (c) except as provided in the Research Plan or Additional Research Plan or as otherwise agreed by the Parties, (i) will remain solely under the control of the Transferee Party, (ii) will not be used or delivered by the Transferee Party to or for the benefit of any Third Party, and (iii) will not be used in research or testing involving human subjects, and (d) will be subject to all additional restrictions and obligations that the Transferor Party has identified in a written notice to the Transferee Party as being necessary for the Transferor Party to comply with its obligations to Third Parties with respect to the applicable Material, which notice is provided at or prior to the delivery of such Materials to the Transferee Party. Without limitation to ARTICLE 7, all Materials supplied under this Section 2.1.9 are supplied “as is”, with no warranties of fitness for a particular purpose, and must be used with prudence and appropriate caution in any experimental work, as not all of their characteristics may be known. Following the completion of the activities for which the applicable Materials were supplied under this Section 2.1.9 or upon the Transferor Party’s earlier request, the Transferee Party will either destroy or return to the Transferor Party, at the Transferor Party’s sole discretion, all Materials provided by the Transferor Party that are unused; provided that Vertex will have the right to retain and continue to use any Materials provided by Company that Vertex has the right to Exploit under the license granted to Vertex pursuant to Section 4.1.1.
Confidentiality and Intellectual Property Rights (a) The parties acknowledge that the information which the disclosing party submits to the receiving party in connection with this Agreement includes disclosing party's confidential and proprietary information, both of a technical and commercial nature. Receiving party agrees not to disclose such information to third parties without disclosing party's prior written consent.
(b) The intellectual property rights, copyrights and other rights connected therewith, in respect of drawings, specifications, documents, data and software made available by the Seller to the Buyer shall be owned solely by the Seller and shall remain its property. Buyer is not allowed to permit any third party to fabricate the Products or any parts thereof.
(c) The Buyer is obliged to inform the Seller of any intellectual property rights that may exist with respect to the Equipment if Services are rendered for Equipment not supplied by the Seller. In case of third-party claims that may be asserted on the grounds of the existence of intellectual property rights on the Equipment or Products not delivered by the Seller, the Buyer shall indemnify and hold harmless the Seller against any such claims.
(d) With regard to software the Seller grants to the Buyer a non-exclusive and non-transmissible right to use the intellectual property right, in machine-readable, object code form, on one system limited to the operation of the agreed Equipment. The software license shall be unlimited in time and free of charge, if not otherwise agreed. Neither the Buyer nor any third party shall modify, reproduce, translate, reverse engineer, transfer from object code to the source code or decompile the Seller´s software. The license does not entitle the Buyer to use the software for any equipment other than the agreed Equipment, to grant sub-licenses or to copy the software documents without the Seller ´s prior written consent. The Buyer is only entitled to make a single copy for backup purposes to be able to reload the system limited to the one agreed Equipment. If the Buyer exchanges the agreed Equipment, new software has to be purchased and installed. In case of termination of the Agreement the license terminates and all copies of the software and the documentation shall be returned to the Seller promptly after termination.
Manufacturing Technology Transfer Upon AbbVie’s written request with respect to a given Collaboration CAR-T Product and Licensed Product, Caribou shall effect a full transfer to AbbVie or its designee (which designee may be an Affiliate or a Third Party Provider) of all Materials and Know-How Controlled by Caribou relating to the then-current process for the Manufacture of such Collaboration CAR-T Product and any corresponding Licensed Products (each, a “Manufacturing Process”). Caribou shall provide, shall cause its Affiliates to provide, and shall use Commercially Reasonable Efforts to assist AbbVie in causing all Third Party Providers to provide, all reasonable assistance requested by AbbVie to enable AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to implement each Manufacturing Process at the facilities designated by AbbVie. If requested by AbbVie, such assistance shall include facilitating the entering into of agreements with applicable Third Party suppliers relating to such Collaboration CAR-T Product and any corresponding Licensed Products. Without limitation of the foregoing, in connection with the Manufacturing Process and related transfer:
(a) Caribou shall, and shall cause its Affiliates to, make available to AbbVie (or its Affiliate or designated Third Party Provider, as applicable), and shall use Commercially Reasonable Efforts to assist AbbVie in causing all Third Party Providers to make available to AbbVie, from time to time as AbbVie may request, all Materials and Manufacturing-related Know-How Controlled by Caribou relating to each Manufacturing Process, including methods, reagents and processes and testing/characterization Know-How, and all documentation constituting material support, performance advice, shop practice, standard operating procedures, specifications as to Materials to be used, and control methods, that are necessary or reasonably useful to enable AbbVie (or its Affiliate or designated Third Party manufacturer, as applicable) to use and practice such Manufacturing Process;
(b) Caribou shall cause all appropriate employees and representatives of Caribou and its Affiliates, and shall use Commercially Reasonable Efforts to assist AbbVie in causing all appropriate employees and representatives of Third Party Providers, to meet with employees or representatives of AbbVie (or its Affiliate or designated Third Party Provider, as applicable) at the applicable manufacturing facility at mutually convenient times to assist with the working up and use of each Manufacturing Process and with the training of the personnel of AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to the extent necessary or reasonably useful to enable AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to use and practice such Manufacturing Process;
(c) Without limiting the generality of this Section 4.4.2, Caribou shall cause all appropriate analytical and quality control laboratory employees and representatives of Caribou and its Affiliates, and shall use Commercially Reasonable Efforts to assist AbbVie in causing all appropriate analytical and quality control laboratory employees and representatives of Third Party Providers, to meet with employees or representatives of AbbVie (or its Affiliate or designated Third Party Provider, as applicable) at the applicable manufacturing facility and make available all necessary equipment, at mutually convenient times, to support and execute the provision of all applicable analytical methods and the validation thereof (including all applicable Know-How, Information and Materials Controlled by Caribou, and sufficient supplies of all primary and other reference standards);
(d) Caribou shall, and shall cause its Affiliates to, take such steps, and shall use Commercially Reasonable Efforts to assist AbbVie in causing Third Party Providers take such steps, as are necessary or reasonably useful to assist AbbVie (or its Affiliate or designated Third Party Provider, as applicable) in obtaining any necessary licenses, permits or approvals from Regulatory Authorities with respect to the Manufacture of the applicable Collaboration CAR-T Products and corresponding Licensed Products at the applicable facilities; and
(e) Caribou shall, and shall cause its Affiliates to, provide, and shall use Commercially Reasonable Efforts to assist AbbVie in causing Third Party Providers to provide, such other assistance as AbbVie (or its Affiliate or designated Third Party Provider, as applicable) may reasonably request to enable AbbVie (or its Affiliate or designated Third Party Provider, as applicable) to use and practice each Manufacturing Process and otherwise to Manufacture the applicable Collaboration CAR-T Products and corresponding Licensed Products.
Ownership and Intellectual Property Rights 1. This Agreement gives you limited rights to use the Software. Syncro retains any and all rights, title and interest in and to the Software and all copies thereof, including copyrights, patents, trade secret rights, trademarks and other intellectual property rights. All rights not specifically granted in this Agreement, including International Copyrights, are reserved by Syncro. The structure, organization and code of the Software are valuable trade secrets and confidential information of Syncro.
TECHNOLOGY/KNOWLEDGE TRANSFER ACTIVITIES The goal of this task is to develop a plan to make the knowledge gained, experimental results, and lessons learned available to the public and key decision makers. • Prepare an Initial Fact Sheet at start of the project that describes the project. Use the format provided by the CAM. • Prepare a Final Project Fact Sheet at the project’s conclusion that discusses results. Use the format provided by the CAM. • Prepare a Technology/Knowledge Transfer Plan that includes: o An explanation of how the knowledge gained from the project will be made available to the public, including the targeted market sector and potential outreach to end users, utilities, regulatory agencies, and others.
o A description of the intended use(s) for and users of the project results. o Published documents, including date, title, and periodical name. o Copies of documents, fact sheets, journal articles, press releases, and other documents prepared for public dissemination. These documents must include the Legal Notice required in the terms and conditions. Indicate where and when the documents were disseminated. o A discussion of policy development. State if project has been or will be cited in government policy publications, or used to inform regulatory bodies. o The number of website downloads or public requests for project results. o Additional areas as determined by the CAM. • Conduct technology transfer activities in accordance with the Technology/Knowledge Transfer Plan. These activities will be reported in the Progress Reports. • When directed by the CAM, develop Presentation Materials for an Energy Commission- sponsored conference/workshop(s) on the project. • When directed by the CAM, participate in annual EPIC symposium(s) sponsored by the California Energy Commission. • Provide at least (6) six High Quality Digital Photographs (minimum resolution of 1300x500 pixels in landscape ratio) of pre and post technology installation at the project sites or related project photographs. • Prepare a Technology/Knowledge Transfer Report on technology transfer activities conducted during the project. • Initial Fact Sheet (draft and final) • Final Project Fact Sheet (draft and final) • Presentation Materials (draft and final) • High Quality Digital Photographs • Technology/Knowledge Transfer Plan (draft and final) • Technology/Knowledge Transfer Report (draft and final)
Licensed Intellectual Property Section 3.17(h)(vi)...................................29
Technical Information The Employer agrees to provide to the Union such information that is available relating to employees in the bargaining unit, as may be required by the Union for collective bargaining purposes.
INTELLECTUAL PROPERTY RIGHTS - INVENTION AND PATENT RIGHTS A. General
1. NASA has determined that 51 U.S.C. § 20135(b) does not apply to this Agreement. Therefore, title to inventions made (conceived or first actually reduced to practice) under this Agreement remain with the respective inventing party(ies). No invention or patent rights are exchanged or granted under this Agreement, except as provided herein.
Sublicense to Use the Scudder Trademarks As exclusive licensee of the rights to use anx xxxxxcense the use of the "Scudder," "Scudder Investments" and "Scudder, Stevens & Clark, Inx." xxxdemaxxx (xxgether, the "Scuddex Xxxxx"), xxx xerexx xxant the Trust a nonexclusive right xxx xxxlicense to use (i) the "Scudder" name and mark as part of the Trust's name (the "Fund Namx"), xxd (ii) the Scudder Marks in connection with the Trust's investment products xxx xxxvices, in each case only for so long as this Agreement, any other investment management agreement between you or any organization which shall have succeeded to your business as investment manager ("your Successor") and the Trust, or any extension, renewal or amendment hereof or thereof remains in effect, and only for so long as you are a licensee of the Scudder Marks, provided however, that you agree to use your best xxxxxxx to maintain your license to use and sublicense the Scudder Marks. The Trust agrees that it shall have no right to suxxxxxxxe or assign rights to use the Scudder Marks, shall acquire no interest in the Scudder Marks othxx xxxx the rights granted herein, that all of txx Xxxxt's uses of the Scudder Marks shall inure to the benefit of Scudder Trust Company xx xxxer and licensor of the Scudder Marks (xxx "Xrademark Owner"), and that the Trust shall nxx xxxxlenge the validity of the Scudder Marks or the Trademark Owner's ownership thereof. The Truxx xxxxher agrees that all services and products it offers in connection with the Scudder Marks shall meet commercially reasonable standards of duaxxxx, xs may be determined by you or the Trademark Owner from time to time, provided that you acknowledge that the services and products the Trust rendered during the one-year period preceding the date of this Agreement are acceptable. At your reasonable request, the Trust shall cooperate with you and the Trademark Owner and shall execute and deliver any and all documents necessary to maintain and protect (including but not limited to in connection with any trademark infringement action) the Scudder Marks and/or enter the Trust as a registered user thereof. Xx xxch time as this Agreement or any other investment management agreement shall no longer be in effect between you (or your Successor) and the Trust, or you no longer are a licensee of the Scudder Marks, the Trust shall (to the extent that, and as soon ax, xx xawfully can) cease to use the Fund Name or any other name indicating that it is advised by, managed by or otherwise connected with you (or your Successor) or the Trademark Owner. In no event shall the Trust use the Scudder Marks or any other name or mark confusingly similar therexx (xxxluding, but not limited to, any name or mark that includes the name "Scudder") if this Agreement or any other investment advisory agrexxxxx xetween you (or your Successor) and the Fund is terminated.
