Using library facilities. If you use our library services, you will be bound by a Copyright Declaration which you will be asked to agree to when you first use those services.
Using library facilities Sample Clauses
Related to Using library facilities
Laundry Facilities Washers and dryers are installed in each apartment for the exclusive use of students in the apartment. Any other use is prohibited. The use of washers and dryers are free. LINEN: Brighton provides a mattress cover on all mattresses. Students need to bring their own bedding. All beds are regular twin size. The typical cost for replacing a mattress cover is $25.00. MAINTENANCE: Students are responsible to notify the manager in writing as soon as possible if they notice anything in an apartment that requires repair work or maintenance. See “Property Conditions” section 12 of the BYU-Idaho Student Landlord Housing Contract.
Ancillary Facilities (a) If any Borrower and any Ancillary Lender agree, subject to compliance with the requirements set forth in this Section 2.23, such Ancillary Lender shall be permitted to provide an Ancillary Facility on a bilateral basis to such Borrower. To the extent any Ancillary Facility exists, the following shall apply: (i) The applicable Revolving Commitment of the Ancillary Lender shall: (A) be deemed to be utilized by its applicable Ancillary Commitment for purposes of (1) calculating the commitment fee payable to such Ancillary Lender pursuant to Section 2.12(a) and (2) calculating the aggregate remaining amount of Revolving Exposure of all applicable Revolving Lenders available under the Revolving Facility (it being understood the commitment fee payable pursuant Section 2.12(a) to Lenders without an Ancillary Facility shall not be modified by the existence of any Ancillary Facility and for purposes of such calculation it shall be assumed that each such Lender’s Revolving Commitments have not been reduced as a result of such Ancillary Facility) (such remaining amount, the “Remaining Revolving Exposure”) and (B) not be deemed to be utilized by the Ancillary Commitment of the applicable Ancillary Lender for purposes of determining whether the Dollar Equivalent of such Ancillary Lender’s Revolving Exposure exceeds its applicable Revolving Commitment (and therefor whether such Ancillary Lender is required to make or participate in a Loan or Letter of Credit under this Agreement). (ii) Borrowings of the Remaining Revolving Exposure shall be made on a pro rata basis among the Revolving Lenders of the applicable Class (including the applicable Ancillary Lenders) pursuant to and subject to the limitations set forth in Section 2.01. (b) To request the creation of an Ancillary Facility, any Borrower shall deliver to the Administrative Agent not later than five (5) Business Days (or such shorter period agreed to by the Administrative Agent) prior to the first date on which such Ancillary Facility is proposed to be made available: (i) a notice in writing specifying: (A) the Borrower or Borrowers to which extensions of credit will be made available thereunder; (B) the first Business Day on which such Ancillary Facility shall be made and the expiration date of such Ancillary Facility (which shall be no later than the Revolving Maturity Date); (C) the type of Ancillary Facility being provided; (D) the identity of the Ancillary Lender(s); and (E) the amount and currency of the Ancillary Commitment with respect to such Ancillary Facility (which shall be expressed in any currency to which such Ancillary Lenders may agree) and shall not exceed such Ancillary Lender’s Revolving Commitment; (ii) a copy of the Ancillary Facility Documents with respect to such Ancillary Facility, together with a certificate of a Responsible Officer of the applicable Borrower(s) certifying that the terms of such Ancillary Facility satisfy the requirements set forth in this Section 2.23 (including any applicable definitions used herein); and (iii) such other information that the Administrative Agent may reasonably request in connection with such Ancillary Facility. The Administrative Agent shall give notice to each Revolving Lender of such Ancillary Facility notice. (i) Subject to the terms of this Agreement, an Affiliate of any Revolving Lender (other than a Disqualified Institution) may become an Ancillary Lender, in which case such Revolving Lender and such Affiliate shall be treated as a single Revolving Lender whose Revolving Commitment is as set forth in Schedule 2.01 or in the Assignment and Assumption pursuant to which such Revolving Lender assumed its Revolving Commitment. (ii) To the extent that this Agreement or any other Loan Document imposes any obligation on any Ancillary Lender and such Ancillary Lender is an Affiliate of a Revolving Lender and not a party thereto, the relevant Revolving Lender shall ensure that such obligation is performed by such Affiliate in compliance with the terms hereof or such other Loan Document. (iii) Each Ancillary Lender, in its capacity as such, hereby appoints the Administrative Agent as its agent for purposes of the Loan Documents and for the avoidance of doubt agrees the Administrative Agent may rely on the applicable protections and indemnities set forth herein (including those set forth in Article IX) with respect to its role as agent under the Loan Documents for such Ancillary Lender. (d) The terms and conditions of any Ancillary Facility shall be as agreed by the applicable Ancillary Lenders and the applicable Borrower thereunder; provided that such terms shall at all times: (i) permit extensions of credit thereunder to be made only to the applicable Borrower; (ii) provide that the Ancillary Commitment of the applicable Ancillary Lenders under such Ancillary Facility shall not exceed such Ancillary Lender’s USD Only Revolving Commitment or USD/Multicurrency Revolving Commitment, as applicable, and that, in the event and on such occasion that such Ancillary Commitment exceeds such USD Only Revolving Commitment or USD/Multicurrency Revolving Commitment, as applicable, such Ancillary Commitment shall be automatically reduced by the amount of such excess; (iii) provide that the Ancillary Facility Exposure shall not exceed the Ancillary Commitment with respect to such Ancillary Facility and (iv) provide that the Ancillary Commitment under such Ancillary Facility shall be canceled, and that all extensions of credit under such Ancillary Facility shall be repaid, not later than the Revolving Maturity Date unless cash collateralized or supported by the issuance of a “back to back” letter of credit in a manner meeting the requirements of clause (iv) of the definition of “Date of Full Satisfaction”. (e) (i) Each Ancillary Facility shall terminate on the Revolving Maturity Date or such earlier date (A) as provided in the relevant Ancillary Facility Document or (B) on which its expiry date occurs or on which it is cancelled in accordance with the terms of this Agreement.
Sanitary Facilities Construction (a) Closets shall be soundly constructed and roofed with weatherproof material. The floor of each closet shall be well drained and constructed of concrete, bricks and cement, or of other approved materials which shall be impervious to water. Every closet shall be well lighted by natural or artificial light and shall be ventilated. Each closet shall have a hinged door, capable of being fastened on the inside, lift seats/flaps and toilet paper. (b) If closets are of single unit construction (only to be used for the formwork process), not contained within a purpose built ablution block, privacy walls which shield the closet/s from outside view shall be installed. (Privacy walls are not required for purpose built ablution blocks eg ATCO huts). (c) Where practicable, toilets to be connected to sewerage before commencement of the job. (d) Closet/urinal location to be conveniently accessible to Employees, but not so close as to cause a nuisance to those persons. (e) Where necessary, portable water seal toilets of an approved standard are to be provided and regularly serviced. (f) Conveniently accessible closets and urinals are to be distributed every 5th floor on multi storey constructions. (g) Closets and urinals are to be washed daily with disinfectant and kept in clean, hygienic condition. (h) Adequate washing facilities, suitably drained, and wash basins/troughs are to be supplied with hot and cold running water. (i) Soap and towels are to be supplied.
Entrance Facility The facilities between a Party's designated premises and the Central Office serving that designated premises.
Access to Facility 13.1 Each Party shall ensure that its facilities are secured at all times. 13.2 The Customer shall permit and, if the land on which the Facility is located is not owned by Customer, cause such landowner to permit, the Distributor's employees and agents to enter the property on which the Facility is located at any reasonable time. Such access shall be provided for the purposes of inspecting and/or testing the Facility as and when permitted by this Agreement, the Code or the Distributor’s Conditions of Service or as required to ensure the continued safe and satisfactory operation of the Facility, to ensure the accuracy of the Distributor's meters, to establish work protection, or to perform work. 13.3 Any inspecting and/or testing referred to in section 13.2 shall not relieve the Customer from its obligation to operate and maintain the Facility and any related equipment in a safe and satisfactory operating condition and in accordance with this Agreement. 13.4 The Distributor shall have the right to witness any testing done by the Customer of the Facility and, to that end, the Customer shall provide the Distributor with at least fifteen working days advance notice of the testing. 13.5 Notwithstanding section 10.1, where the Distributor causes damage to the Customer's property as part of this access, the Distributor shall pay to the Customer the Customer's reasonable costs of repairing such property or, if such property cannot be repaired, replacing such property. 13.6 Notwithstanding section 10.1, if the Customer has been given access to the Distributor’s property, and if the Customer causes damage to the Distributor’s property as part of that access, the Customer shall pay to the Distributor the Distributor’s reasonable costs of repairing such property or, if such property cannot be repaired, replacing such property.
Verizon OSS Facilities Any gateways, interfaces, databases, facilities, equipment, software, or systems, used by Verizon to provide Verizon OSS Services to ICG.
Access to Facilities Each of the Company and each of its Subsidiaries will permit any representatives designated by the Purchaser (or any successor of the Purchaser), upon reasonable notice and during normal business hours, at such person's expense and accompanied by a representative of the Company, to: (a) visit and inspect any of the properties of the Company or any of its Subsidiaries; (b) examine the corporate and financial records of the Company or any of its Subsidiaries (unless such examination is not permitted by federal, state or local law or by contract) and make copies thereof or extracts therefrom; and (c) discuss the affairs, finances and accounts of the Company or any of its Subsidiaries with the directors, officers and independent accountants of the Company or any of its Subsidiaries. Notwithstanding the foregoing, neither the Company nor any of its Subsidiaries will provide any material, non-public information to the Purchaser unless the Purchaser signs a confidentiality agreement and otherwise complies with Regulation FD, under the federal securities laws.
System Upgrade Facilities Transmission Owner shall design, procure, construct, install, and own the System Upgrade Facilities described in Appendix A hereto. The responsibility of the Developer for costs related to System Upgrade Facilities shall be determined in accordance with the provisions of Attachment S to the NYISO OATT.
Unbundled Loop Modifications (Line Conditioning 2.5.1 Line Conditioning is defined as routine network modification that BellSouth regularly undertakes to provide xDSL services to its own customers. This may include the removal of any device, from a copper Loop or copper Subloop that may diminish the capability of the Loop or Subloop to deliver high-speed switched wireline telecommunications capability, including xDSL service. Such devices include, load coils, excessive bridged taps, low pass filters, and range extenders. Excessive bridged taps are bridged taps that serves no network design purpose and that are beyond the limits set according to industry standards and/or the BellSouth’s TR 73600 Unbundled Local Loop Technical Specification. 2.5.2 BellSouth will remove load coils only on copper Loops and Subloops that are less than eighteen thousand (18,000) feet in length. 2.5.3 For any copper loop being ordered by NewPhone which has over six thousand (6,000) feet of combined bridged tap will be modified, upon request from NewPhone, so that the loop will have a maximum of six thousand (6,000) feet of bridged tap. This modification will be performed at no additional charge to NewPhone. Loop conditioning orders that require the removal of bridged tap that serves no network design purpose on a copper Loop that will result in a combined total of bridged tap between two thousand five hundred (2,500) and six thousand (6,000) feet will be performed at the rates set forth in Exhibit A. 2.5.4 NewPhone may request removal of any unnecessary and non-excessive bridged tap (bridged tap between zero (0) and two thousand five hundred (2,500) feet which serves no network design purpose), at rates pursuant to BellSouth’s SC Process as mutually agreed to by the Parties. 2.5.5 Rates for ULM are as set forth in Exhibit A. 2.5.6 BellSouth will not modify a Loop in such a way that it no longer meets the technical parameters of the original Loop type (e.g., voice grade, ADSL, etc.) being ordered. 2.5.7 If NewPhone requests ULM on a reserved facility for a new Loop order, BellSouth may perform a pair change and provision a different Loop facility in lieu of the reserved facility with ULM if feasible. The Loop provisioned will meet or exceed specifications of the requested Loop facility as modified. NewPhone will not be charged for ULM if a different Loop is provisioned. For Loops that require a DLR or its equivalent, BellSouth will provide LMU detail of the Loop provisioned. 2.5.8 NewPhone shall request Loop make up information pursuant to this Attachment prior to submitting a service inquiry and/or a LSR for the Loop type that NewPhone desires BellSouth to condition. 2.5.9 When requesting ULM for a Loop that BellSouth has previously provisioned for NewPhone, NewPhone will submit a SI to BellSouth. If a spare Loop facility that meets the Loop modification specifications requested by NewPhone is available at the location for which the ULM was requested, NewPhone will have the option to change the Loop facility to the qualifying spare facility rather than to provide ULM. In the event that BellSouth changes the Loop facility in lieu of providing ULM, NewPhone will not be charged for ULM but will only be charged the service order charges for submitting an order.
Additional Facilities If any structural additions or change in use shall be made to the buildings or other improvements included in the Project Facility subsequent to the date hereof (other than the initial construction of the Building contemplated by the Project), or if any additional buildings or improvements shall be constructed on the Land other than the Building (such change of use, new structures, structural additions, buildings and improvements being referred to hereinafter as “Additional Facilities”), the Obligor agrees that its PILOT Obligations hereunder shall be increased by an amount, as determined by the Agency or a tax assessor selected by the Agency, equal to the increased tax payments, if any, that would have been payable on such increase if this Agreement were not in effect. Nothing herein shall constitute the Agency’s consent to the construction of any such additions or additional buildings or improvements or to such change of use.
