Wax Content and Wax Melting Sample Clauses

Wax Content and Wax Melting. Point Crude oils and heavy true distillates should be tested to determine the minimum fuel temperature required to keep all of the wax in solution. One approach is to remove the wax from the fuel and then to determine its melting point, which represents the maximum solution temperature. There is no standard method for wax separation, but there are several laboratory procedures which are satisfactory. They all involve dilution of the fuel with a poor wax solvent and then chilling to 0(Degree)F (-18(Degree)C) or lower to separate the wax crystals which are filtered out at low temperature. An instrumental procedure which measures the wax solution temperature directly on the fuel is Differential Scanning Calorimetry (DSC). This method is still being developed and has not yet been successful with all crude oils. For light distillate fuels, ASTM D 2500 Cloud Point or ASTM D3 117 Wax Appearance Point may be used. Table 3-- Fuel Analysis Data PROPERTY ASTM METHOD (1) MEASURED VALUE Gross Heating Value, Btu/lb D240 Kin. Viscosity, cSt, 100(Degree)F (37.8(Degree)C) D445 Kin. Viscosity, cSt, 122(Degree)F (50.0(Degree)C) D445 Kin. Viscosity, cSt, 210(Degree)F (98.9(Degree)C) D445 Specific Gravity, 60(Degree)F (15.6(Degree)C) D1298 Specific Gravity, 100W (37.8(Degree)C) D1298 Pour Point, (Degree)F ((Degree)C) D97 Rash Point, (Degree)F ((Degree)C) D98 Distillation Range (Not on Residuals) D86 IBP (Degree) 10% (Degree) 20% (Degree) 30% (Degree) 40% (Degree) 50% (Degree) 60% (Degree) 70% (Degree) 80% (Degree) 90% (Degree) EP (Degree) Carbon Residue, Wt. % D524 _____________ Sulfur, Wt. % (Very Light Distillates) D1266 _____________ Sulfur, Wt. % (All Other Fuels) D129 _____________ Hydrogen, Wt. % _____________ Nitrogen, Wt. % _____________ Total Ash (2), ppm D482 _____________ Table 3-- Fuel Analysis Data (Cont'd) Trace Metals, ppm (2) _______________ Sodium Potassium _______________ Vanadium _______________ Calcium Lead _______________ Other Metals Over 5 ppm Sediment & Water Vol. % D1796 _______________ Water, Vol. % D95 _______________ Filterable Dirt, mg/100ml D2276 _______________ Wax, Wt. % _______________ Wax, Melting Point, (Degree)F _______________ Cetane No. (Diesel Engine Start Only) D975 _______________ (1) Book of ASTM Standards, Part 17 (2) A total ash less than 3 ppm is acceptable in place of trace metal analysis (3) Wax data only on crudes and heavy distillates GE INDUSTRIAL & POWER SYSTEMS GENERAL ELECTRIC COMPANY XXX XXXXX XXXX, XXXXXXXXXXX XX 00000 518...
AutoNDA by SimpleDocs

Related to Wax Content and Wax Melting

  • THIRD-PARTY CONTENT, SERVICES AND WEBSITES 10.1 The Services may enable You to link to, transfer Your Content or Third Party Content to, or otherwise access, third parties’ websites, platforms, content, products, services, and information (“Third Party Services”). Oracle does not control and is not responsible for Third Party Services. You are solely responsible for complying with the terms of access and use of Third Party Services, and if Oracle accesses or uses any Third Party Services on Your behalf to facilitate performance of the Services, You are solely responsible for ensuring that such access and use, including through passwords, credentials or tokens issued or otherwise made available to You, is authorized by the terms of access and use for such services. If You transfer or cause the transfer of Your Content or Third Party Content from the Services to a Third Party Service or other location, that transfer constitutes a distribution by You and not by Oracle. 10.2 Any Third Party Content we make accessible is provided on an “as-is” and “as available” basis without any warranty of any kind. You acknowledge and agree that we are not responsible for, and have no obligation to control, monitor, or correct, Third Party Content. We disclaim all liabilities arising from or related to Third Party Content. 10.3 You acknowledge that: (i) the nature, type, quality and availability of Third Party Content may change at any time during the Services Period, and (ii) features of the Services that interoperate with Third Party Services such as Facebook™, YouTube™ and Twitter™, etc., depend on the continuing availability of such third parties’ respective application programming interfaces (APIs). We may need to update, change or modify the Services under this Agreement as a result of a change in, or unavailability of, such Third Party Content, Third Party Services or APIs. If any third party ceases to make its Third Party Content or APIs available on reasonable terms for the Services, as determined by us in our sole discretion, we may cease providing access to the affected Third Party Content or Third Party Services without any liability to You. Any changes to Third Party Content, Third Party Services or APIs, including their unavailability, during the Services Period does not affect Your obligations under this Agreement or the applicable order, and You will not be entitled to any refund, credit or other compensation due to any such changes.

  • Access Toll Connecting Trunk Group Architecture 9.2.1 If CSTC chooses to subtend a Verizon access Tandem, CSTC’s NPA/NXX must be assigned by CSTC to subtend the same Verizon access Tandem that a Verizon NPA/NXX serving the same Rate Center Area subtends as identified in the LERG. 9.2.2 CSTC shall establish Access Toll Connecting Trunks pursuant to applicable access Tariffs by which it will provide Switched Exchange Access Services to Interexchange Carriers to enable such Interexchange Carriers to originate and terminate traffic to and from CSTC’s Customers. 9.2.3 The Access Toll Connecting Trunks shall be two-way trunks. Such trunks shall connect the End Office CSTC utilizes to provide Telephone Exchange Service and Switched Exchange Access to its Customers in a given LATA to the access Tandem(s) Verizon utilizes to provide Exchange Access in such LATA. 9.2.4 Access Toll Connecting Trunks shall be used solely for the transmission and routing of Exchange Access to allow CSTC’s Customers to connect to or be connected to the interexchange trunks of any Interexchange Carrier which is connected to a Verizon access Tandem.

  • Content and Services Neither Licensor nor the provider of the wireless network is the provider of any financial services available through or related to the Software, and neither Licensor nor the provider of the wireless network or any contractor of the provider of the financial services available through or related to the Software, is responsible for any of the materials, information, products or services made available to you via the Software.

  • Audit of Existing Content and Functionality By September 1, 2017, the Recipient will propose for OCR’s review and approval the identity and bona fides of an Auditor (corporation or individual) to audit all content and functionality on its website, including, but not limited to, the home page, all subordinate pages, and intranet pages and sites, to identify any online content or functionality that is inaccessible to persons with disabilities, including online content and functionality developed by, maintained by, or offered through a third party vendor or an open source. The Auditor will have sufficient knowledge and experience in website accessibility for people with disabilities to carry out all related tasks, including developing a Proposed Corrective Action Plan. The Audit will use the Benchmarks for Measuring Accessibility set out above, unless the Recipient receives prior permission from OCR to use a different standard as a benchmark. During the Audit, the Recipient will also seek input from members of the public with disabilities, including parents, students, employees, and others associated with the Recipient, and other persons knowledgeable about website accessibility, regarding the accessibility of its online content and functionality.

  • SOURCE CODE ESCROW FOR LICENSED PRODUCT If Source Code or Source Code escrow is offered by either Contractor or Product manufacturer or developer to any other commercial customers, Contractor shall either: (i) provide Licensee with the Source Code for the Product; or (ii) place the Source Code in a third party escrow arrangement with a designated escrow agent who shall be named and identified to the State, and who shall be directed to release the deposited Source Code in accordance with a standard escrow agreement acceptable to the State; or (iii) will certify to the State that the Product manufacturer/developer has named the State, acting by and through the Authorized User, and the Licensee, as a named beneficiary of an established escrow arrangement with its designated escrow agent who shall be named and identified to the State and Licensee, and who shall be directed to release the deposited Source Code in accordance with the terms of escrow. Source Code, as well as any corrections or enhancements to such source code, shall be updated for each new release of the Product in the same manner as provided above and such updating of escrow shall be certified to the State in writing. Contractor shall identify the escrow agent upon commencement of the Contract term and shall certify annually that the escrow remains in effect in compliance with the terms of this clause. The State may release the Source Code to Licensees under this Contract who have licensed Product or obtained services, who may use such copy of the Source Code to maintain the Product.

  • COVID-19 Vaccine Passports Pursuant to Texas Health and Safety Code, Section 161.0085(c), Contractor certifies that it does not require its customers to provide any documentation certifying the customer’s COVID-19 vaccination or post-transmission recovery on entry to, to gain access to, or to receive service from the Contractor’s business. Contractor acknowledges that such a vaccine or recovery requirement would make Contractor ineligible for a state-funded contract.

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.

  • Foreign-Owned Companies in Connection with Critical Infrastructure If Texas Government Code, Section 2274.0102(a)(1) (relating to prohibition on contracts with certain foreign-owned companies in connection with critical infrastructure) is applicable to this Contract, pursuant to Government Code Section 2274.0102, Contractor certifies that neither it nor its parent company, nor any affiliate of Contractor or its parent company, is: (1) majority owned or controlled by citizens or governmental entities of China, Iran, North Korea, Russia, or any other country designated by the Governor under Government Code Section 2274.0103, or (2) headquartered in any of those countries.

  • Proposed Policies and Procedures Regarding New Online Content and Functionality By October 31, 2017, the School will submit to OCR for its review and approval proposed policies and procedures (“the Plan for New Content”) to ensure that all new, newly-added, or modified online content and functionality will be accessible to people with disabilities as measured by conformance to the Benchmarks for Measuring Accessibility set forth above, except where doing so would impose a fundamental alteration or undue burden. a) When fundamental alteration or undue burden defenses apply, the Plan for New Content will require the School to provide equally effective alternative access. The Plan for New Content will require the School, in providing equally effective alternate access, to take any actions that do not result in a fundamental alteration or undue financial and administrative burdens, but nevertheless ensure that, to the maximum extent possible, individuals with disabilities receive the same benefits or services as their nondisabled peers. To provide equally effective alternate access, alternates are not required to produce the identical result or level of achievement for persons with and without disabilities, but must afford persons with disabilities equal opportunity to obtain the same result, to gain the same benefit, or to reach the same level of achievement, in the most integrated setting appropriate to the person’s needs. b) The Plan for New Content must include sufficient quality assurance procedures, backed by adequate personnel and financial resources, for full implementation. This provision also applies to the School’s online content and functionality developed by, maintained by, or offered through a third-party vendor or by using open sources. c) Within thirty (30) days of receiving OCR’s approval of the Plan for New Content, the School will officially adopt, and fully implement the amended policies and procedures.

  • Product Information EPIZYME recognizes that by reason of, inter alia, EISAI’s status as an exclusive licensee in the EISAI Territory under this Agreement, EISAI has an interest in EPIZYME’s retention in confidence of certain information of EPIZYME. Accordingly, until the end of all Royalty Term(s) in the EISAI Territory, EPIZYME shall keep confidential, and not publish or otherwise disclose, and not use for any purpose other than to fulfill EPIZYME’s obligations, or exercise EPIZYME’s rights, hereunder any EPIZYME Know-How Controlled by EPIZYME or EPIZYME Collaboration Know-How, in each case that are primarily applicable to EZH2 or EZH2 Compounds (the “Product Information”), except to the extent (a) the Product Information is in the public domain through no fault of EPIZYME, (b) such disclosure or use is expressly permitted under Section 9.3, or (c) such disclosure or use is otherwise expressly permitted by the terms and conditions of this Agreement. For purposes of Section 9.3, each Party shall be deemed to be both the Disclosing Party and the Receiving Party with respect to Product Information. For clarification, the disclosure by EPIZYME to EISAI of Product Information shall not cause such Product Information to cease to be subject to the provisions of this Section 9.2 with respect to the use and disclosure of such Confidential Information by EPIZYME. In the event this Agreement is terminated pursuant to Article 12, this Section 9.2 shall have no continuing force or effect, but the Product Information, to the extent disclosed by EPIZYME to EISAI hereunder, shall continue to be Confidential Information of EPIZYME, subject to the terms of Sections 9.1 and 9.3 for purposes of the surviving provisions of this Agreement. Each Party shall be responsible for compliance by its Affiliates, and its and its Affiliates’ respective officers, directors, employees and agents, with the provisions of Section 9.1 and this Section 9.2.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!