Weight of Lading; Xxxxx & Axle Overweight Conditions Sample Clauses

Weight of Lading; Xxxxx & Axle Overweight Conditions. The weight of the freight should be evenly distributed in the container or trailer, and the freight should be restrained adequately to prevent it from exerting excessive pressures against doors, walls, or ends of the containers that might cause their failure. The loaded weight must not exceed the limit set forth in the equipment manufacturer’s plates. The weight of the lading may not exceed following specified weights for the length of container set forth in the following chart: Nominal Length (ft.) Maximum Gross Weight (lbs.) (Lading Plus Tare) 53' 42,500 45’ 43,000 40' 43,500 20' 37,000 The total weight of the trailer on stanchion must not exceed 65,000 lbs. In loading heavy or concentrated weight commodities, no more than 25,000 pounds may be distributed over any 10 linear feet within the container. On freight with small supporting bases, no more than 3,500 pounds may be concentrated on a floor area of less than 25 square inches (minimum dimension 3.1 inches by 8 inches), with such areas no closer than 35 inches to one another. You are responsible for complying with the Intermodal Safe Container Act and all applicable state and local requirements regarding shipment weights, including foregoing and applicable weight limitations per axle. Keep in mind that for intermodal shipments, the placement of the axles on the chassis used for the delivery of the container from the destination rail terminal to the final destination may differ from the axle placement on the chassis used for pick-up from the consignor to the origin rail terminal. Such differences must be taken into consideration when loading the container. Neither we nor the underlying transportation provider will be responsible for any weight violation. The customer will be responsible for all costs arising out of the overweight condition of the equipment, including fines or penalties charged by a governmental authority, repair of damaged equipment, storage, redelivery charges, loss or damage to freight, and adjustment and transload services. Forklifts or other equipment, when loaded or empty, should not exceed the floor rating of the container or trailer being loaded. In many cases, the floor rating may be found on the door of the container or trailer.
AutoNDA by SimpleDocs

Related to Weight of Lading; Xxxxx & Axle Overweight Conditions

  • Minimum Shipping Requirements for TIPS Sales Vendor shall ship, deliver, or provide ordered goods and services within a commercially reasonable time after acceptance of the order. If a delay in delivery is anticipated, Vendor shall notify the TIPS Member as to why delivery is delayed and provide an updated estimated time for completion. The TIPS Member may cancel the order if the delay is not commercially acceptable or not consistent with the Supplemental Agreement applicable to the order.

  • Funding Restrictions and Order Quantities The Agency reserves the right to reduce or increase estimated or actual quantities in whatever amount necessary without prejudice or liability to the Agency, if:

  • Offtake constraints due to Backdown The Solar Power Developer and Buying Entity shall follow the forecasting and scheduling process as per the regulations in this regard by the Appropriate Commission. The Government of India, as per Clause 5.2(u) of the Indian Electricity Grid Code (IEGC), encourages a status of “must-run” to solar power projects. Accordingly, no solar power plant, duly commissioned, should be directed to back down by a Discom/ Load Dispatch Centre (LDC). In the eventuality of backdown, including backdown on account of non-dispatch of power due to non-compliance with “Order No. 23/22/2019- R&R dated 28.06.2019 of Ministry of Power regarding Opening and maintaining of adequate Letter of Credit (LC) as Payment Security Mechanism under Power Purchase Agreements by Distribution Licensees” and any clarifications or amendment thereto, except for the cases where the Backdown is on account of events like consideration of grid security or safety of any equipment or personnel or other such conditions, subject to the submission of documentary evidences from the competent authority, the SPD shall be eligible for a minimum generation compensation, from Buying Entity, restricted to the following and there shall be no other claim, directly or indirectly against SECI: Duration of Backdown Provision for Generation Compensation Hours of Backdown during a monthly billing cycle. Generation Compensation = 100% of [(Average Generation per hour during the month) X (number of backdown hours during the month)] X PPA tariff Where, Average Generation per hour during the month (kWh) = Total generation in the month (kWh) ÷ Total hours of generation in the month

  • Initial Forecasts/Trunking Requirements Because Verizon’s trunking requirements will, at least during an initial period, be dependent on the Customer segments and service segments within Customer segments to whom CSTC decides to market its services, Verizon will be largely dependent on CSTC to provide accurate trunk forecasts for both inbound (from Verizon) and outbound (to Verizon) traffic. Verizon will, as an initial matter, provide the same number of trunks to terminate Reciprocal Compensation Traffic to CSTC as CSTC provides to terminate Reciprocal Compensation Traffic to Verizon. At Verizon’s discretion, when CSTC expressly identifies particular situations that are expected to produce traffic that is substantially skewed in either the inbound or outbound direction, Verizon will provide the number of trunks CSTC suggests; provided, however, that in all cases Verizon’s provision of the forecasted number of trunks to CSTC is conditioned on the following: that such forecast is based on reasonable engineering criteria, there are no capacity constraints, and CSTC’s previous forecasts have proven to be reliable and accurate.

  • Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.

  • OTHER APPLICABLE TERMS & CONDITIONS 5.1. All registered E-bidders at PAH website shall undertake to fully comply with the Terms and Conditions herein. In addition all successful E-Bidders shall also be bound by the terms and conditions as stipulated in the Proclamation of Sale.

  • CONDITIONS APPLICABLE PENDING TRANSFER As has already been referred to in this agreement, the common property will be owned and controlled by a body corporate for and on behalf of all owners including the purchaser. As the body corporate will only be established once the first transfer of a unit in the development has occurred, the Seller shall from the completion date and until the date of the establishment of the body corporate bear the rights and obligations of the body corporate. In this regard, during the period from the completion date until date of transfer, the following conditions shall apply:

  • Exclusion of applications on preliminary points of law Any recourse to any Court for the determination of a preliminary point of law arising in the course of the arbitration proceedings is excluded.

  • ADDITIONAL SPECIAL CONTRACT CONDITIONS A. Special Contract Conditions revisions: the corresponding subsections of the Special Contract Conditions referenced below are replaced in their entirety with the following:

  • Switching System Hierarchy and Trunking Requirements For purposes of routing ECI traffic to Verizon, the subtending arrangements between Verizon Tandem Switches and Verizon End Office Switches shall be the same as the Tandem/End Office subtending arrangements Verizon maintains for the routing of its own or other carriers’ traffic (i.e., traffic will be routed to the appropriate Verizon Tandem subtended by the terminating End Office serving the Verizon Customer). For purposes of routing Verizon traffic to ECI, the subtending arrangements between ECI Tandem Switches and ECI End Office Switches shall be the same as the Tandem/End Office subtending arrangements that ECI maintains for the routing of its own or other carriers’ traffic.

Time is Money Join Law Insider Premium to draft better contracts faster.