Continuous Opacity Monitoring System definition

Continuous Opacity Monitoring System means all equipment required to determine opacity and data recording.
Continuous Opacity Monitoring System. (COMS) means a continuous monitoring system that measures the opacity of emissions.
Continuous Opacity Monitoring System or “COMS” means the total equipment used to sample and condition (if applicable), to analyze, and to provide a record of the opacity of emissions from a Unit.

Examples of Continuous Opacity Monitoring System in a sentence

  • Continuous Opacity Monitoring System (COMS) - The total equipment required for the determination of opacity as to include sampling, analysis and recording of emission data.

  • Prior to the Date of Lodging, CountryMark installed a Continuous Opacity Monitoring System (“COMS”) to monitor opacity at the FCCU.

  • The gas control panel also controls the flow of excess sample to the sample vent.COMS (Continuous Opacity Monitoring System) - monitors the opacity of particulate flowing through a stack or duct.

  • Plan Approval 42-028E] [Authority for this condition is derived from Global Consent Decree] (a) Furnace #3 will be "affected facilities" under 40 CFR 60 Subparts A and CC, 180 Days after installation and certification of the Continuous Opacity Monitoring System (COMS).

  • Compliance with the emissions limits set for opacity shall be deter- mined by using data from a Continuous Opacity Monitoring System (COMS) except during saturated stack condi- tions (uncombined water droplets).

  • The standard for a modified process also requires Continuous Opacity Monitoring System (COMS) to measure the visible emissions discharged into the atmosphere from GM4.

  • The monitoring data were documented in the June 14, 2016 technical memorandum entitled Review of Continuous Opacity Monitoring System Data from the Pulp and Paper ICR Responses for Subpart MM Sources, which is located in Docket ID No. EPA-HQ-OAR-2014-0741 (U.S. Environmental Protection Agency 2016).

  • Continuous Opacity Monitoring System (COMS)” means the total equipment required for the determination of opacity emissions, including the associated data recording equipment (such as strip chart, computer disk, magnetic tape, etc.).

  • By no later than December 31, 2012, Holly shall install and operate a Continuous Opacity Monitoring System (“COMS”) to monitor opacity at the FCCU.

  • The proposed baghouse will easily remove over 99% of the PM generated by the combustion process, and the proposed PM limit of 0.018 lb/MMBtu is less than the NSPS limit of 0.03 lb/MMBtu.The opacity is limited to 20% and the source must install a Continuous Opacity Monitoring System (COMS) or other approved method per 40 CFR 60.47a(a).

Related to Continuous Opacity Monitoring System

  • Continuous monitoring system means the total equipment, required under the emission monitoring section in applicable subsections used to sample and condition (if applicable), to analyze, and to provide a permanent record of emissions or process parameters.

  • Continuous parameter monitoring system or "CPMS" means all of the equipment necessary to meet the data acquisition and availability requirements of this chapter, to monitor process and control device operational parameters (for example, control device secondary voltages and electric currents) and other information (for example, gas flow rate, oxygen or carbon dioxide concentrations), and to record average operational parameter value on a continuous basis.

  • Continuous parameter monitoring system (CPMS means all of the equipment necessary to meet the data acquisition and availability requirements of the Prevention of Significant Deterioration program, to monitor process and control device operational parameters (for example, control device secondary voltages and electric currents) and other information (for example, gas flow rate, O2 or CO2 concentrations), and to record average operational parameter value(s) on a continuous basis.

  • Continuous emission monitoring system or "CEMS" means the equipment required under section 11 of this rule to sample, analyze, measure, and provide, by means of readings recorded at least once every fifteen (15) minutes, using an automated data acquisition and handling system (DAHS), a permanent record of nitrogen oxides emissions, stack gas volumetric flow rate, stack gas moisture content, and oxygen or carbon dioxide concentration, as applicable, in a manner consistent with 40 CFR 75*. The following systems are the principal types of continuous emission monitoring systems required under section 11 of this rule:

  • Continuous emissions monitoring system or “CEMS” means all of the equipment that may be required to meet the data acquisition and availability requirements of this chapter, to sample, to condition (if applicable), to analyze, and to provide a record of emissions on a continuous basis.

  • Continuous emissions monitoring system (CEMS) means all of the equipment that may be required to meet the data acquisition and availability requirements of this section, to sample, condition (if applicable), analyze, and provide a record of emissions on a continuous basis.

  • Continuous monitoring means the collection and use of measurement data and other information to record the data inputs required to calculate the 365-day rolling average lifecycle GHG emissions, in accordance with the compliance monitoring plan described in section IV.C.

  • Continuous emissions rate monitoring system or “CERMS” means the total equipment required for the determination and recording of the pollutant mass emissions rate (in terms of mass per unit of time).

  • Performance Monitoring System has the meaning given to it in paragraph 1.1.2 in Part B of Schedule 6 (Service Levels, Service Credits and Performance Monitoring);

  • Beam monitoring system means a system designed and installed in the radiation head to detect and measure the radiation present in the useful beam.

  • Monitoring System means a system established by BNY to fulfill the Responsibilities specified in clauses (d) and (e) of Section 1 of Article III of this Agreement.

  • Fraud Monitoring System means an off-line administration system that monitors suspected occurrences of ABT- related fraud.

  • Continuous work means work carried on with consecutive shifts throughout the twenty four hours of each of at least five consecutive days without interruption except during breakdowns or meal breaks or due to unavoidable causes beyond the control of the Employer.

  • Primary dose monitoring system means a system which will monitor the useful beam during irradiation and which will terminate irradiation when a pre-selected number of dose monitor units have been delivered.

  • Generation Service means the sale of electricity, including ancillary services such as the provision of reserves, to a Customer by a Competitive Supplier.

  • *Continuous Contract Any existing written agreement (including any renewals that are exercised) between a prime contractor and a HUB vendor, where the HUB vendor provides the prime contractor with goods or service under the same contract for a specified period of time. The frequency the HUB vendor is utilized or paid during the term of the contract is not relevant to whether the contract is considered continuous. Two or more contracts that run concurrently or overlap one another for different periods of time are considered by CPA to be individual contracts rather than renewals or extensions to the original contract. In such situations the prime contractor and HUB vendor are entering (have entered) into “new” contracts.

  • continuous supply of services means a supply of services which is provided, or agreed to be provided, continuously or on recurrent basis, under a contract, for a period exceeding three months with periodic payment obligations and includes supply of such services as the Government may, subject to such conditions, as it may, by notification, specify;

  • Interconnection Service means the physical and electrical interconnection of the Customer Facility with the Transmission System pursuant to the terms of Tariff, Part IV and Tariff, Part VI and the Interconnection Service Agreement entered into pursuant thereto by Interconnection Customer, the Interconnected Transmission Owner and Transmission Provider.

  • Secondary dose monitoring system means a system which will terminate irradiation in the event of failure of the primary dose monitoring system.

  • Basic generation service provider or "provider" means a

  • Continuous enrollment means enrollment in a state- supported postsecondary education institution at the same degree level for consecutive terms, excluding summer term, since the beginning of the period for which continuous enrollment is claimed unless a sequence of continuous enrollment is broken due to extenuating circumstances beyond the student’s control, including serious personal illness or injury, or illness or death of a parent.

  • Net metering system means a facility for the production of electrical energy that:

  • Base station means the station as set out in Part-II (SOQ) hereof where the vehicle(s) / equipment shall be permanently based, (i.e. based for minimum period of 10 (Ten) days at a stretch) which may be changed at the discretion of the Company.

  • Continuous Improvement Plan means a plan for improving the provision of the Goods and/or Services and/or reducing the Charges produced by the Supplier pursuant to Framework Schedule 12 (Continuous Improvement and Benchmarking);

  • Planned Downtime means planned downtime for upgrades and maintenance to the Services scheduled in advance of such upgrades and maintenance.

  • Network Integration Transmission Service means the transmission service provided under Tariff, Part III.