emission factor means the average emission rate of a greenhouse gas relative to the activity data of a source stream assuming complete oxidation for combustion and complete conversion for all other chemical reactions;
Load factor means the percentage of aircraft seats actually occupied on a flight (RPMs divided by ASMs). “NMB” means the National Mediation Board.
Emission Rate for a given pollutant means the number of pounds of that pollutant emitted per million British thermal units of heat input (lb/mmBTU), measured in accordance with this Consent Decree.
Emissions unit means any part or activity of a stationary source that emits or has the potential to emit any regulated air pollutant or any pollutant listed under Section 7412(b) of the FCAA. This term is not meant to alter or affect the definition of the term "unit" for purposes of Title IV of the FCAA.
Loss Factor means the scaling factor determined in accordance with clause 6 and applied by the reconciliation manager to volumes of electricity measured or estimated in respect of ICPs on the Network, in order to reflect the impact of the ICP on Losses within the Network;
SFTR means Regulation (EU) 2015/2365 of the European Parliament and of the Council of 25 November 2015 on transparency of securities financing transactions and of reuse and amending Regulation (EU) No 648/2012;
Excess emissions - means an emission rate that exceeds any applicable emission limitation or standard allowed by any rule in Sections .0500, .0900, .1200, or .1400 of Subchapter 02D; or by a permit condition; or that exceeds an emission limit established in a permit issued under 15A NCAC 02Q .0700. (Note: Definitions of excess emissions under 02D .1110 and 02D .1111 shall apply where defined by rule.)
greenhouse gas emissions means emissions in terms of tonnes of CO2 equivalent of carbon dioxide (CO2), methane (CH4), nitrous oxide (N2O), hydrofluorcarbons (HFCs), perfluorocarbons (PFCs), nitrogen trifluoride (NF3) and sulphur hexafluoride (SF6) determined pursuant to Regulation (EU) No 525/2013 and falling within the scope of this Regulation;
Fit factor means a quantitative estimate of the fit of a particular respirator to a specific individual, and typically estimates the ratio of the concentration of a substance in ambient air to its concentration inside the respirator when worn.
Acid rain emissions limitation means, as defined in 40 CFR 72.2*, a limitation on emissions of sulfur dioxide or nitrogen oxides under the acid rain program under Title IV of the Clean Air Act (CAA).
Class Factor As to any date of determination and any Combinable Class, the then current Class Factor for the Related REMIC Class. As to any date of determination and any RCR Class, a fraction the numerator of which is the sum of the then current Class Balances of
High global warming potential hydrofluorocarbons means any hydrofluorocarbons in a particular end use for which EPA’s Significant New Alternatives Policy (SNAP) program has identified other acceptable alternatives that have lower global warming potential. The SNAP list of alternatives is found at 40 CFR Part 82 subpart G with supplemental tables of alternatives available at (http://www.epa.gov/snap/).
Stress Factor means 2.25.
emission limit value means a limit on the concentration, mass or emission rate of mercury or mercury compounds, often expressed as “total mercury”, emitted from a point source.
Sustainability Factors means environmental, social and employee matters, respect for human rights, anti‐corruption and anti‐bribery matters.
Peak tube potential means the maximum value of the potential difference across the x-ray tube during an exposure.
Adjustment Factor means, with respect to a share of the Fund (or one unit of any other security for which a Fund Closing Price must be determined), 1.0, subject to adjustment in the event of certain events affecting the shares of the Fund. See “—Anti-dilution Adjustments Relating to the Fund; Alternate Calculation —Anti-dilution Adjustments” below.
Yearly (1/Year) sampling frequency means the sampling shall be done in the month of September, unless specifically identified otherwise in the effluent limitations and monitoring requirements table.
S&P Volatility Factor means 277% or such other potential dividend rate increase factor as S&P advises the Corporation in writing is applicable.
Quarterly (1/Quarter) sampling frequency means the sampling shall be done in the months of March, June, August, and December, unless specifically identified otherwise in the Effluent Limitations and Monitoring Requirements table.
Low-level radioactive waste or “waste” means radioactive material that consists of or contains class A, B, or C radioactive waste as defined by 10 C.F.R. 61.55, as in effect on January 26, 1983, but does not include waste or material that is any of the following:
Tonne means metric tonne (1000 kilograms.)
Technique factors means the following conditions of operation:
Moody’s Discount Factor means, for purposes of determining the Discounted Value of any Moody’s Eligible Asset, the percentage determined by reference to the rating on such asset and the shortest Exposure Period set forth opposite such rating that is the same length as or is longer than the Moody’s Exposure Period, in accordance with the table set forth below: 7 weeks 151% 159% 166% 173% 187% 136% 148% 225% 8 weeks or less but greater than seven weeks. 154 161 168 176 190 137 149 231 9 weeks or less but greater than eight weeks 158 163 170 177 192 138 150 240 * Mxxxx’x rating. ** Municipal Obligations not rated by Moody’s but rated BBB by S&P. *** Municipal Obligations rated MIG-1 or VMIG-1, which do not mature or have a demand feature at par exercisable in 30 days and which do not have a long-term rating. **** Municipal Obligations not rated by Moody’s but rated SP-1+ by S&P, which do not mature or have a demand feature at par exercisable in 30 days and which do not have a long-term rating. ***** Municipal Obligations rated less than Baa3 or not rated by Moody’s and less than BBB or not rated by S&P, not to exceed 10% of Moody’s Eligible Assets. Notwithstanding the foregoing, (i) except as provided in clause (ii) below, the Moody’s Discount Factor for short-term Municipal Obligations will be 115%, so long as such Municipal Obligations are rated at least MIG-1, VMIG-l or P-1 by Moody’s and mature or have a demand feature at par exercisable in 30 days or less, or 125%, as long as such Municipal Obligations are rated at least A-1+/AA or SP-1+/AA by S&P and mature or have a demand feature at par exercisable in 30 days or less, (ii) the Moody’s Discount Factor for residual interest municipal bonds and structured notes shall be the product of (x) the percentage determined by reference to the rating on the security underlying such residual interest municipal bond multiplied by (y) 1.25 (provided that the trust in which such residual interest municipal bond is held may be terminated within five business days), and (iii) except as provided in clause (ii) above, no Moody’s Discount Factor will be applied to cash, Receivables for Municipal Obligations Sold, or futures, options and similar instruments (to the extent such securities are Moody’s Eligible Assets); provided, however, that for purposes of determining the Moody’s Discount Factor applicable to a Municipal Obligation, any Municipal Obligation (excluding any short-term Municipal Obligation) not rated by Moody’s but rated by S&P shall be deemed to have a Mxxxx’x rating which is one full rating category lower than its S&P rating.
Leakage technique factors means the technique factors associated with the diagnostic or therapeutic source assembly which are used in measuring leakage radiation. They are defined as follows:
SO2 means sulfur dioxide.