Exhaust pipe definition

Exhaust pipe means the pipe that attaches to the muffler and exits the vehicle.
Sample 1Sample 2Sample 3
Exhaust pipe means that part of the means of enclosed conveyance designed to carry from the lower extremity of an exhaust manifold to the entry point of a muffler.
Sample 1Sample 2

Examples of Exhaust pipe in a sentence

  • Exhaust pipe, muffler, catalytic converter, or tail pipe and associated attaching parts.

  • Exhaust pipe discharge shall be directed away from any operator’s position.

  • Exhaust pipe discharge shall be directed away from any operator’s position or entry doors on body.

  • Flywheel (h) Camshaft, Camshaft drive timing gears (i) Inlet and exhaust manifold, Mufflers, Exhaust pipe (j) Variable Valve Timing (VVT).

  • Exhaust pipe, muffler and tailpipe shall be outside the bus body compartment and attached to the chassis so as not to damage any other chassis component.

  • Exhaust pipe, muffler, and tail pipe shall be outside bus body attached to chassis.

  • Exhaust pipe size shall be sufficient to ensure that exhaust back pressure does not exceed the maximum limitations specified by the engine manufacturer.

  • Check whether insulation of the Exhaust pipe is proper.7. Check that ventilation of the EA Room is proper.

  • Exhaust pipe size shall be sufficient to ensure that exhaust backpressure does not exceed the maximum limitations specified by the engine manufacturer.

  • Exhaust pipe to run horizontal under the chassis and vertical up the passenger side adjacent to the main exhaust discharge and mounted to main exhaust discharge.

Related to Exhaust pipe

  • Sump means any pit or reservoir that meets the definition of tank and those troughs/trenches connected to it that serve to collect hazardous waste for transport to hazardous waste storage, treatment, or disposal facilities; except that as used in the landfill, surface impoundment, and waste pile rules, “sump” means any lined pit or reservoir that serves to collect liquids drained from a leachate collection and removal system or leak detection system for subsequent removal from the system.

  • Pipe or “Piping” means a hollow cylinder or tubular conduit that is constructed of non-earthen materials.

  • Drip irrigation means any non-spray low volume irrigation system utilizing emission devices with a flow rate measured in gallons per hour. Low volume irrigation systems are specifically designed to apply small volumes of water slowly at or near the root zone of plants.

  • Downstream means carrying a transmission from the Headend to remote points on the Cable System or to Interconnection points on the Cable System.

  • Slug means any discharge of water, sewage, or industrial waste which in concentration of any given constituent or in quantity of flow exceeds for any period of duration longer than fifteen (15) minutes more than five (5) times the average twenty-four (24) hour concentration or flows during normal operation.

  • Incineration means an engineered process involving burning or combustion of solid waste to thermally degrade waste materials at high temperatures;

  • Valve means a device used to control the flow of water in the irrigation system.

  • Mass of a vehicle in running order means the mass of an unladen vehicle with bodywork, and with coupling device in the case of a towing vehicle, or the mass of the chassis with cab if the manufacturer does not fit the bodywork and/or coupling device, including coolant, oils, 90 per cent of fuel, 100 per cent of other liquids except used waters, tools, spare wheel, driver (75 kg) and, for buses and coaches, the mass of the crew member (75 kg) if there is a crew seat in the vehicle.

  • Heat input means the product (expressed in mmBtu/time) of the gross calorific value of the fuel (expressed in Btu/lb) and the fuel feed rate into the combustion device (expressed in mass of fuel/time) and does not include the heat derived from preheated combustion air, recirculated flue gases, or ex- haust from other sources.

  • Backpressure means a pressure (caused by a pump, elevated tank or piping, boiler, or other means) on the consumer's side of the service connection that is greater than the pressure provided by the public water system and which may cause backflow.

  • drain means (subject to Section 219(2) of the 1991 Act) a drain used for the drainage of one building or any buildings or yards appurtenant to buildings within the same curtilage;

  • Nitrogen oxides means nitric oxide and nitrogen dioxide, expressed as nitrogen dioxide (NO2);

  • Underground injection means the subsurface emplacement of fluids through a bored, drilled or driven well; or through a dug well, where the depth of the dug well is greater than the largest surface dimension. (See also “injection well”.)

  • Compaction means the increase in soil bulk density.

  • Nuclear reactor means any apparatus designed or used to sustain nuclear fission in a self-supporting chain reaction or to contain a critical mass of fissionable material.

  • Unladen mass means the mass of any motor vehicle or trailer as recorded in a licence or certificate issued in respect of such motor vehicle or trailer by any authority empowered by law to issue licences in respect of motor vehicles;

  • Wastewater collection system means the sewer and pumping system used for the collection and conveyance of domestic, commercial and industrial wastewater; and

  • Power boiler means a boiler in which steam or other vapor is generated at a pressure of more than 15 psig for use external to itself or a boiler in which water is heated and intended for operation at pressures in excess of 160 psig and/or temperatures in excess of 250 degrees F by the direct application of energy from the combustion of fuels or from electricity, solar or nuclear energy.

  • Membrane filtration means a pressure or vacuum driven separation process in which particulate matter larger than one micrometer is rejected by an engineered barrier, primarily through a size exclusion mechanism, and which has a measurable removal efficiency of a target organism that can be verified through the application of a direct integrity test. This definition includes the common membrane technologies of microfiltration, ultrafiltration, nanofiltration, and reverse osmosis.

  • Spoil means excavated material which is unsuitable for use as material in the construction works or is material which is surplus to the requirements of the construction works;