Holding time definition

Holding time means the time that will elapse from the establishment of the initial filling condition until the pressure has risen due to heat influx to the lowest set pressure of the pressure limiting devices (s) of tanks intended for the carriage of refrigerated liquefied gases;
Holding time means the period from time of sampling to time of analysis.
Holding time means the moment of the end of trading on the JSE or FSE (as applicable) on 5 December 2017;

Examples of Holding time in a sentence

  • This shall be done with 100% Leak-proof under Hydro-static Pressure Test under 4.0 Kg-f / cm2 (g) pressure with a minimum Holding time of 1.0 hour and those joints after found tested OK shall be preserved and care is to be taken in such a manner so that there should be no undue load / impact / hammerrage on those tested joints so as to make the joint quite sound.

  • This shall be done with 100% Leak-proof under Hydro-static Pressure Test under4.0 Kg-f / cm2 (g) pressure with a minimum Holding time of 1.0 hour and those joints after found tested OK shall be preserved and care is to be taken in such a manner so that there should be no undue load / impact / hammerrage on those tested joints so as to make the joint quite sound.

  • Holding time was often less than 5 minutes and not longer than 15 minutes.

  • Holding time is the maximum time allowed between sample collection and extraction (if applicable) and sample analysis, during which the designated preservation and storage techniques are employed.

  • Holding time criteria are established to maintain the samples in a state that is representative of the in-situ field conditions before analysis.


More Definitions of Holding time

Holding time means the time that will elapse from the establishment of the initial filling condition until the pressure has risen due to heat influx to the lowest set pressure of the safety valves.”
Holding time means the maximum time a sample may be held before beginning of an associated analysis.
Holding time means the maximum time that a sample may be held prior to preparation or analysis.
Holding time means the time that will elapse from the establishment of the initial filling condition until the pressure has risen due to heat influx to the lowest set pressure of the safety valves."(Reference documents: ECE/TRANS/WP.15/AC.2/2013/27 and Informal document INF.20 as amended)
Holding time means the time between sample collection and the initiation of the preparation and/or analysis as presented in CEL's Quality Assurance Program Manual unless otherwise specified.
Holding time means the time that will elapse from the establishment of the initial filling condition until the pressure has risen due to heat influx to the lowest set pressure of the pressure limiting devices (s) of tanks intended for the carriage of refrigerated liquefied gases.NOTE: For portable tanks, see 6.7.4.1.”.(Reference document: ECE/TRANS/WP.15/AC.1/134/Add.1) Chapter 1.6 1.6.4 Add a new transitional measure to read as follows:
Holding time means the time that will elapse from the establishment of the initial filling condition until the pressure has risen due to heat influx to the lowest set pres- sure of the pressure limiting device(s) of tanks intended for the carriage of refriger- ated liquefied gases; NOTE: For portable tanks, see 6.7.4.1."