Inboard Engine definition

Inboard Engine means a four-stroke spark-ignition marine engine not used in a personal watercraft that is designed such that the propeller shaft penetrates the hull of the marine watercraft while the engine and the remainder of the drive unit is internal to the hull of the marine watercraft.
Inboard Engine means a four-stroke spark-ignition marine engine not used in a personal watercraft that is designed such that the propeller shaft penetrates the hull of the marine watercraft while the engine

Examples of Inboard Engine in a sentence

  • In general there are no safe anchorages or landing jetties to attract Inboard Engine (IBE) fishing crafts (such as day-boats and multi-day boats).

  • Figure 1Profile of an Inboard-engine Propeller Boat Figure 2View of Inboard Engine Compartment The left- and right-bank exhaust pipes are routed below the floor to the rear (transom), exiting just above water level.

  • Increase funds repair of additional constructive equipment as follows: Boat Bridge Erection Inboard Engine (1); Compressor Air (1); Crane Rough Terrain B2460 Hydraulic Light (1); Extinguisher Fire Chemical (1); Generator Set Diesel (4); Generator Set Skid-Mounted (17); Kit Launch Line Charge Trailer Mounted (1); Pump Module Fuel (Sixcon) (3); Shop Equipment (2); Storage Tank Module Fuel Sixcon (2); Tractor Full Tracked With Angle Blade (2);Truck Forklift Variable Reach (5).

  • CARBON MONOXIDE IS A DANGEROUS GAS THAT IS POTENTIALLY LETHAL.WARNING Inboard Engine Cooling SystemAll marine engines use surface water as a cool- ing medium.

  • The center does not utilize a physician’s assistant.Reviewed sign-in/out logbooks confirmed the DHA was on-site at least once a week, for at least two hours, with no more than nine days passing between on-site visits, as required.

  • Inboard Engine Hydraulic Assist Steering Power assisted cable steering is standard equip- ment on single engine boats powered by Mercruis- er and Volvo engines.

  • Schedule of InsuranceValue to be InsuredDate PurchasedPurchase PriceHull & Equipment including Inboard Engine (if any)Outboard Motor(s) to Parent VesselSpecial Equipment – attach value listDinghy/Tender to Parent Vessel.N.B. Must be permanently marked with the name ofParent VesselOutboard Motor(s) to Dinghy/TenderTrailerPersonal Effects(Max.

  • If the position changes and attributes remain the same, it is called spatial variability.

  • Although there is uncertainty, costs of the Recovery Plan range from $1.04 to 1.26 billion over the next 5 years, and over $10 billion over the next 50 years.

  • CONTACT YOUR MONTEREY DEALER OR ENGINE MANUFACTURER FOR INFORMATION ON THE PROPER PAINTING PROCEDURES.CAUTION Inboard Engine Exhaust SystemInboard engines use the exhaust system to expel exhaust gases and cooling water.

Related to Inboard Engine

  • Diesel engine means an internal combustion, compression-ignition (CI) engine with operating characteristics significantly similar to the theoretical diesel combustion cycle. The regulation of power by controlling fuel supply in lieu of a throttle is indicative of a compression ignition engine.

  • Engine under the Lease. The term "Engines" means, as of any date of determination, both Engines then leased to the Lessee pursuant to the Lease.

  • Spares means a part or a sub-assembly or assembly for substitution which is ready to replace an identical or similar part or sub-assembly or assembly including a component or an accessory;

  • Dual-Fuel Engine means an engine that is designed to simultaneously operate with a liquid fuel and a gaseous fuel, both fuels being metered separately, the consumed amount of one of the fuels relative to the other one being able to vary depending on the operation;

  • parent engine means an engine selected from an engine family in such a way that its emissions characteristics will be representative for that engine family;

  • information society service means a service as defined in point (b) of Article 1(1) of Directive (EU) 2015/1535 of the European Parliament and of the Council;

  • Associated equipment means equipment that is used in conjunction with a radiographic exposure device to make radiographic exposures that drives, guides, or comes in contact with the source, e.g., guide tube, control tube, control (drive) cable, removable source stop, “J” tube and collimator when it is used as an exposure head.

  • Compression Ignition Engine means an internal combustion engine with operating characteristics significantly similar to the theoretical diesel combustion cycle. The regulation of power by controlling fuel supply in lieu of a throttle is indicative of a compression ignition engine.

  • Engine degreaser means a cleaning product designed to remove grease, grime, oil and other contaminants from the external surfaces of engines and other mechanical parts.

  • Systems Engineering means preparing specifications, identifying and resolving interface problems, developing test requirements, evaluating test data, and supervising design.

  • Internal combustion engine or ‘engine’ means an energy converter, other than a gas turbine, designed to transform chemical energy (input) into mechanical energy (output) with an internal combustion process; it includes, where they have been installed, the emission control system and the communication interface (hardware and messages) between the engine's electronic control unit(s) and any other powertrain or non-road mobile machinery control unit necessary to comply with Chapters II and III;

  • Stationary internal combustion engine means a spark or compression ignited, reciprocating internal combustion engine that is not a portable emission unit.

  • Fishing gear means any item or piece of equipment that is used in fishing or aquaculture to target, capture or rear marine biological resources or that is floating on the sea surface, and is deployed with the objective of attracting and capturing or of rearing such marine biological resources;

  • Value Engineering means the detailed analysis of systems, equipment, materials, services, facilities, and supplies required by the Contract Documents for the purpose of achieving the desired and essential functions of the Owner’s program at the lowest cost consistent with required and necessary performance, longevity, reliability, quality and safety.

  • Sailboat means the same as that term is defined in Section 73-18-2.

  • Supplier of water means any person who owns or operates a public water system.