Maximum takeoff weight definition

Maximum takeoff weight means the maximum takeoff weight listed in the aircraft's type certificate data sheet for the lowest rated configuration or, if the aircraft does not have a type certificate data sheet, the maximum takeoff weight target as published by the aircraft's manufacturer.

Examples of Maximum takeoff weight in a sentence

  • These have to be computed for each route because the charges differ across the airspaces of different countries that are being flown over and are typically derived from the MTOW (Maximum take-off weight) of the aircraft.

  • Maximum take-off weight (MTOW) is the maximum allowed and registered take-off weight of the aircraft, permitted in the State of registration of the aircraft.

  • In this study, no extra equipmentsare assumed therefore, basic empty weight and standard empty weight of aircrafts are equal (Armutlu, 2002).Maximum Take-off Weight (MTOW): Maximum take-off weight is defined as the total weight of standard empty weight and payload, which are fuels, passengers and baggages.

  • Maximum take-off weight (MTOW) is also computed based on the OWE, fuel and payload weight for the mission.

  • Available engine types are as follows:0 - Fighter turbojet 1 - Turbofan2 - Light jet (not yet supported) 3 - Turboprop4 - piston prop5 - big prop, non-turboprop (not yet supported) 6 - helicopter7 – boat (not yet supported) 8 – car (not yet supported)9 - diesel vehicle (not yet supported)9) MTOW – Maximum takeoff weight of the aircraft.

  • Maximum takeoff weight is 39,600 pounds and maximum landing weight 32,700 pounds.Maximum cruise speed is mach 0.85, dive speed is mach 0.92.

  • Thereafter, the S/N Maximum takeoff weight Charges per Aircraft after the first two (2) hours 1.

  • This must be shown at any speed that can be obtained except speeds higher than the landing gear or wing flap operating(ii) Landing gear retracted;(iii) Maximum take-off weight; and(iv) The maximum power or thrust selected by the applicant as an operating limitation for use during climb; and(2) Is trimmed at the speed for best rate- of-climb except that the speed need not be less than 1·3 VSR1.(b) Cruise.

  • Orders received in the current fiscal year decreased by 188,738 million yen (down 36.9% year on year) from the previous fiscal year to 322,351 million yen.

  • CategoryNormal, Utility, AerobaticCommuterVery LightCharacteristics Maximum take-off weight (kg/lb) Number of enginesType of engine Maximum number of occupants Maximum operation altitude (ft)1 Although there is no explicitly specified restriction, single turbine engine airplanes are incompatible with the stall speed requirement, see Table 4.2 An equivalent FAA standard does not exist.

Related to Maximum takeoff weight

  • Tare Weight means the weight of an empty shipping container, excluding all materials used for wrapping, cushioning, banding, waterproofing, packaging, blocking and bracing articles within the exterior container.

  • Maximum Weighted Average Life Test means a test that will be satisfied on any date of determination if the Weighted Average Life of the Collateral Loans as of such date is less than or equal to seven (7.0) years.

  • Volume Weighted Average Price means, for any security as of any date, the daily dollar volume-weighted average price for such security on the Primary Market as reported by Bloomberg through its “Historical Prices – Px Table with Average Daily Volume” functions, or, if no dollar volume-weighted average price is reported for such security by Bloomberg, the average of the highest closing bid price and the lowest closing ask price of any of the market makers for such security as reported in the "pink sheets" by Pink Sheets LLC.

  • Maximum Daily Quantity means the daily volume of Gas or Liquids, expressed in 103m3, identified in a Shipper's Interruptible Transportation Service Agreement that Transporter agrees to receive from Shipper under Toll Schedule Interruptible Full Path Service, Toll Schedule Interruptible Receipt Service or Toll Schedule Interruptible Delivery Service, as applicable.

  • Exceedance means a condition that is detected by monitoring that provides data in terms of an emission limitation or standard and that indicates that emissions (or opacity) are greater than the applicable emission limitation or standard (or less than the applicable standard in the case of a percent reduction requirement) consistent with any averaging period specified for averaging the results of the monitoring.

  • Minimum Takedown Threshold shall have the meaning given in Section 2.1.4.

  • Gross laden weight means the actual weight of a vehicle or combination of

  • average consumption means the average consumption by a customer of a municipal service during a specific period, which consumption is calculated by dividing by three the total measured consumption of that service by that customer over the preceding three months;

  • Gross weight means the aggregate weight of a vehicle or combination of vehicles and the load

  • Minimum Weighted Average Spread Test means a test that will be satisfied on any date of determination if the Weighted Average Spread of all Eligible Collateral Obligations included in the Collateral on such date is equal to or greater than 5.00%.

  • low voltage means the set of nominal voltage levels that are used for the distribution of electricity and whose upper limit is generally accepted to be an a.c. voltage of 1000V ( or a d.c. voltage of 1500 V). [SANS 1019]

  • Load Factor means the percentage of aircraft seats actually occupied on a flight (RPMs divided by ASMs). “NMB” means the National Mediation Board.

  • tons means the gross tonnage calculated in accordance with the tonnage measurement regulations contained in Annex I of the International Convention on Tonnage Measurement of Ships, 1969; the word “tonnage” shall be construed accordingly.

  • Available RP Capacity Amount means (i) the amount of Restricted Payments that may be made at the time of determination pursuant to Sections 7.06(d), (g), (h) and (l) minus (ii) the sum of the amount of the Available RP Capacity Amount utilized by the Borrower or any Restricted Subsidiary to (A) make Restricted Payments in reliance on Sections 7.06 (g), (h) or (l), (B) incur Liens pursuant to Section 7.01(bb), (C) make Investments pursuant to Section 7.02(n), (D) incur Indebtedness pursuant to Section 7.03(y) and (E) make prepayments, redemptions, purchases, defeasances and other payments in respect of Junior Financings prior to their scheduled maturity utilizing the Available RP Capacity Amount pursuant to Section 7.13 plus (iii) the aggregate principal amount of Indebtedness prepaid prior to or substantially concurrently at such time, solely to the extent such Indebtedness (A) was secured by Liens pursuant to Section 7.01(bb) or (B) was incurred pursuant to Section 7.03(y) and not secured pursuant to Section 7.01(bb) (it being understood that the amount under this clause (iii) shall only be available for use under Sections 7.01(bb) and/or 7.03(y), as applicable).

  • Actual weight means the actual unladen weight of a vehicle or combination of

  • Maximum Capacity or ‘Pmax’ means the maximum continuous active power which a power-generating module can produce, less any demand associated solely with facilitating the operation of that power-generating module and not fed into the network as specified in the connection agreement or as agreed between the relevant system operator and the power-generating facility owner;

  • Programme Maximum Number of ETP Securities means 1,000,000,000.

  • Process weight means the total weight of all materials introduced into any source operation. Solid fuels charged will be considered as part of the process weight, but liquid and gaseous fuels and combustion air will not.

  • Grade point average or "GPA" means the grade point average earned by an eligible student and reported by the high school or participating institution in which the student was enrolled based on a scale of 4.0 or its equivalent if the high school or participating institution that the student attends does not use the 4.0 grade scale;

  • Peak tube potential means the maximum value of the potential difference across the x-ray tube during an exposure.

  • Weighting factor wT for an organ or tissue (T) means the proportion of the risk of stochastic effects resulting from irradiation of that organ or tissue to the total risk of stochastic effects when the whole body is irradiated uniformly. For calculating the effective dose equivalent, the values of wT are:

  • Total maximum daily load or "TMDL" means the sum of the individual wasteload allocations for point sources, load allocations (LAs) for nonpoint sources, natural background loading and a margin of safety. TMDLs can be expressed in terms of either mass per time, toxicity, or other appropriate measure. The TMDL process provides for point versus nonpoint source trade-offs.

  • VWAP Purchase Share Volume Maximum means a number of shares of Common Stock traded on the Principal Market during normal trading hours on the VWAP Purchase Date equal to: (i) the VWAP Purchase Share Estimate, divided by (ii) the VWAP Purchase Share Percentage (to be appropriately adjusted for any reorganization, recapitalization, non-cash dividend, stock split, reverse stock split or other similar transaction).

  • Base Capacity Resource Price Decrement means, for the 2018/2019 and 2019/2020 Delivery Years, a difference between the clearing price for Base Capacity Resources and the clearing price for Capacity Performance Resources, representing the cost to procure additional Capacity Performance Resources out of merit order when the Base Capacity Resource Constraint is binding.

  • Weight means aside from the obvious meaning in the physical sciences, the word is used in reference to a person's "size".

  • Potential electrical output capacity means, with regard to a unit, 33 per- cent of the maximum design heat input of the unit.