Partial pressure definition

Partial pressure means the pressure, p, attributable to a single gas in a gas mixture. For an ideal gas, the partial pressure divided by the total pressure is equal to the constituent's molar concentration, x;
Sample 1Sample 2Sample 3
Partial pressure means the pressure exerted by a specified component in a mixture of gases.
Sample 1Sample 2Sample 3
Partial pressure means the pressure exerted by a specified component in a mixture of gases. "Performance test" or "test" means a series of test runs used for the purpose of determining
Sample 1

Examples of Partial pressure in a sentence

  • Using the following values:Kiln temperature measured by the probe is 350 ◦C; Partial pressure of reference air 0.2095;Reference gas that has a 1 % oxygen concentration (pO2 = 0.01); E is the unknown component.Using the Nernst equation, we calculate a sensor output voltage of E=-40.830 mV.

  • Partial pressure of sodium and cadmium (or mer- cury) during lamp operation is determined by the temperature of the coldest spot of the burner [26].

  • Using the following values:Kiln temperature measured by the probe is 350 ◦C; Partial pressure of reference air 0.2095;Reference gas that has a 1 oxygen concentration (pO2 = 0.01); E is the unknown component.Using the Nernst equation, we calculate a sensor output voltage of E=-40.830 mV.

  • After the completion of machining, the finished product is removed from the fixture and different piece of the raw material is fastened to the fixture and the whole process is repeated again.

  • Partial pressure of water surface CO2 (pCO2) was also measured at 50 cm-depth during specific surveys (see flux measurement) using a miniCO2 sensor (Pro-Oceanus Systems Inc.) with an accuracy of ± 30 ppm.

  • Partial pressure profile according to the stagnant film theory in the sample crucible (S).

  • Figure 9: Partial pressure of ammonia over an entire orbit while RELL was stationary.The operations proceeded through scanning the remaining RBVMs, the PFCS and the Z1 truss though nothing significant was found during those scans.

  • Figure 1.2 Partial pressure of haemolymph oxygen (pO2 - mmHg) in the spiny spider crab, Maja squinado (Herbst 1788) during progressive cooling and warming (Means ± S.D.): Tp I and Tp II indicate lower and upper pejus temperature thresholds respectively while Tc I and Tc II indicate lower and upper critical temperature thresholds respectively.

  • Partial pressure of oxygen in tissue is reduced, owing to capillary degeneration, which leads to consequent necrosis and chronic wounds formation.

  • Partial pressure of atmospheric carbon dioxide seawater CO2 (pCO2-μatm): 22 in equilibrium with seawater (pCO2).

Related to Partial pressure

  • Operating pressure means the pressure at which the parts of an irrigation system are designed by the manufacturer to operate.

  • Pressure means relative pressure versus atmospheric pressure, unless otherwise stated.

  • Reid vapor pressure means the vapor pressure of crude oil or other volatile petroleum products at 100 degrees Fahrenheit as determined by the latest edition of ASTM D6377 (RVPE): Standard Test Method for Determination of Vapor Pressure of Crude Oil.

  • Working pressure means the settled pressure of a compressed gas at a reference temperature of 15 °C in a full pressure receptacle;

  • residential premises means a house, building, structure, shelter, or mobile home, or portion thereof, used as a dwelling, home, residence, or living place by 1 or more human beings. “Residential premises” includes an apartment unit, a boardinghouse, a rooming house, a mobile home, a mobile home space, and a single or multiple family dwelling, but does not include a hotel, a motel, motor home, or other tourist accommodation, when used as a temporary accommodation for guests or tourists, or premises used as the principal place of residence of the owner and rented occasionally during temporary absences including vacation or sabbatical leave.

  • Commercial Premises Means a place of trade or premises operated for financial gain, including but not limited to, a retirement village or a block of flats that has a common facility; a place of trade where the manufacture and production of products or produce takes place; a site where renovation, restoration and refurbishment work as described in Appendix B takes place.

  • industrial premises means any place or premises (not being a private dwelling house), including the precincts thereof, in which or in any part of which any industry, trade, business, occupation or manufacturing is being ordinarily carried on with or without the aid of power and includes a godown attached thereto;

  • design pressure means the maximum pressure that a pressure vessel or plant is designed to withstand safety when operating normally;

  • width means, in relation to a lot,

  • Acre-foot means the amount of water necessary to cover one acre of land to the depth of one foot, or 325,851 U.S. gallons of water.

  • Vapor pressure as herein used means Vapor Pressure at 100° Fahrenheit as determined by ASTM Method D-323-90, "Standard Method of Test for Vapor Pressure of Petroleum Products (Reid Method)."

  • Premises Building Partial Damage means if the Building of which the Premises are a part is damaged or destroyed to the extent that the cost to repair is less than fifty percent (50%) of the then Replacement Cost of the building.

  • Building Work has the meaning given to it in section 6 of the Building and Construction Industry (Improving Productivity) Act 2016 (Cth);

  • Lot width means the shorter of the following two linear measurements:

  • Partial confinement means confinement for no more than one

  • Side Yard means a yard of a lot extending from the front yard to the rear yard, and from the side lot line to the nearest wall of the nearest main building or structure on the lot;

  • Elevation means the vertical distance of a point or a level, on or affixed to the surface of the earth, measured from mean sea level;

  • Potential electrical output capacity means, with regard to a unit, 33 per- cent of the maximum design heat input of the unit.

  • True vapor pressure means the equilibrium partial pressure exerted by a petroleum liquid as determined in accordance with methods described in American Petroleum Institute (API) Bulletin 2517, Evaporation Loss from External Floating Roof Tanks, 1980. The API procedure may not be applicable to some high viscosity or high pour crudes. Available estimates of true vapor pressure may be used in special cases such as these.

  • Premises Building Total Destruction means if the Building of which the Premises are a part is damaged or destroyed to the extent that the cost to repair is fifty percent (50%) or more of the then Replacement Cost of the Building.

  • Building Square Footage or "BSF" means the square footage of assessable internal living space of a Unit, exclusive of any carports, walkways, garages, overhangs, patios, enclosed patios, detached accessory structure, other structures not used as living space, or any other square footage excluded under Government Code Section 65995 as determined by reference to the Building Permit for such Unit.

  • Water surface elevation means the height, in relation to the National Geodetic Vertical Datum (NGVD) of 1929, the North American Vertical Datum (NAVD) of 1988, or other datum, where specified, of floods of various magnitudes and frequencies in the floodplains of riverine areas.

  • Electrical work Means any labor or material used in installing, altering, maintaining, or extending an electrical wiring system and the appurtenances, apparatus, or equipment used in connection with the use of electrical energy in, on, outside, or attached to a building, residence, structure, property, or premises. The term includes service entrance conductors as defined by the National Electrical Code.

  • Premises Partial Damage means damage or destruction to the Premises, other than Lessee-Owned Alterations and Utility Installations, the repair cost of which damage or destruction is less than fifty percent (50%) of the then Replacement Cost (as defined in Paragraph 9.1(d)) of the Premises (excluding Lessee-Owned Alterations and Utility Installations and Trade Fixtures) immediately prior to such damage or destruction.

  • Boiler means an enclosed fossil or other fuel-fired combustion device used to produce heat and to transfer heat to recirculating water, steam, or other medium.

  • Pressure vessel means a vessel that may be used for containing, storing, distributing, transferring, distilling, processing or otherwise handling any gas, vapour or liquid under pressure greater than the atmospheric pressure and includes any pipeline fitting or other equipment attached thereto or used in connection therewith; and