Piston cylinder definition

Piston cylinder means a metal cylinder containing an internal pressurized piston for collecting condensate or produced water samples.
Piston cylinder means a metal cylinder containing an internal pressurized piston for gathering crude oil, condensate, or produced water samples.
Piston cylinder means a metal cylinder containing an internalpressurized piston for collecting condensate or produced water samples.

Examples of Piston cylinder in a sentence

  • Piston- cylinder experiments were run using the hot piston in technique; pressure was increased slowly to 90% of the desired final pressure, and then temperature increased at a rate of 100°C/minute to the desired run temperature.

  • However, GPA method 2174 states, “Under no circumstances should the cylinder be filled beyond 80% of its capacity with sample.” Piston cylinder manufacturer literature (from Ametek Piston Sampling Cylinders) specifically confirms this.

  • Piston cylinder assembly with zoomed view of piston ring interaction.

  • The ability of innovation linkages to speed-up development was the most important factor, followed by the ability to access specialist expertise and increase the cost effectiveness of development activity.

  • Uncertainties (k = 1) for SEE-1 in this comparison are described as: (k = 1) = 0.175 % (1 Pa to 30 Pa)(k = 1) = 0.105 % (70 Pa to 1 kPa)Additionally CENAM, used a pressure balance for the range from 3 kPa to 10 kPa. The pressure balance was manufactured by DHI, model number 7607, with serial number 122 with Piston cylinder: 231 and Masses: 2018.

  • Piston, cylinder and muffler (b) Suction part around shell Figure 1: Schematic in suction system of the linear compressor and temperature condition on boundary We considered four cases to evaluate the effect of suction muffler.

  • Absorbance cm-1 2 0 3700 3500 3300 3100 Wave number, cm-1 FTIR spectra show only two absorption bands + broad absorption region for molecular water 3572 cm-1 3525 cm-1 San Carlos olivine IR bands in (untreated) San Carlos olivine can only be reproduced in the presence of Ti. rutile-buffered olivine (olivine contains Ti) Piston cylinder experiments, Berry et al., 2005 Incorporation of hydrogen in olivine: Titanium clinohumite-like point defect Coupled substitution of Ti on M1 site with 2 H on Si vacancy.

  • Piston cylinder shall be constructed of threaded joints with a continuous weld band about the circumference.

  • Area is subject to Case limits movement of piston suitable for Piston, cylinder, fluid and walls.

  • Fig5.1.6 Piston cylinder If the circuit need not to be required during certain times of situation the hand lever directional valve is used to apply brake.

Related to Piston cylinder

  • Grinding means to reduce to powder or small fragments and includes mechanical chipping or drilling.

  • Pistol means any firearm with a barrel less than sixteen inches in length, or is designed to be held and fired by the use of a single hand.

  • Roll coating means the application of a coating material to a substrate by means of hard rubber or steel rolls.

  • Valve means a device used to control the flow of water in the irrigation system.

  • Connector means a flanged, screwed, welded, or other joined fitting used to connect two pipelines or a pipeline and a piece of process equipment.

  • Nitrogen oxides means nitric oxide and nitrogen dioxide, expressed as nitrogen dioxide (NO2);

  • Uppermost aquifer means the geologic formation nearest the natural ground surface that is an aquifer, as well as lower aquifers that are hydraulically interconnected with this aquifer within the facility's property boundary.

  • Fiber means a glass strand or strands which is/are protected by a color coded buffer tube and which is/are used to transmit a communication signal along the glass strand in the form of pulses of light.

  • Asphalt means a dark brown to black cement-like material (solid, semisolid, or liquid in consistency) in which the predominating constituents are bitumens which occur in nature as such or which are obtained as residue in refining petroleum.

  • Antenna coating means a coating labeled and formulated exclusively for application to equipment and associated structural appurtenances that are used to receive or transmit electromagnetic signals.

  • Pilot or "Payment in Lieu of Tax" shall mean any payment made to the Agency or an affected tax jurisdiction equal to all or a portion of the real property taxes or other taxes which would have been levied by or on behalf of an affected tax jurisdiction with respect to a project but for tax exemption obtained by reason of the involvement of the Agency in such project, but such term shall not include Agency fees.

  • Co-pilot means a pilot operating other than as pilot-in-command, on an aircraft for which more than one pilot is required, but excluding a pilot who is on board the aircraft for the sole purpose of receiving flight instruction for a licence or rating.

  • HDPE means high density polyethylene;

  • Touch-up coating means a coating used to cover minor coating imperfections appearing after the main coating operation.

  • Fabrication means making up data or results and recording or reporting them.

  • factory means any premises including the precincts thereof—

  • Low-solids coating means a coating containing 0.12 kilogram or less of solids per liter (one pound or less of solids per gallon) of coating material.

  • Transportation Company means any organization which provides its own or its leased vehicles for transportation or which provides freight forwarding or air express services.

  • Drywell means a well, other than an improved sinkhole or subsurface fluid distribution system, completed above the water table so that its bottom and sides are typically dry except when receiving fluids.

  • snippet means with respect to any Material Contract, a consent and agreement in favor of the Term Loan Collateral Agent (for the benefit of the Secured Parties) in substantially the form attached hereto as Exhibit F or otherwise in form and substance reasonably satisfactory to the Term Loan Collateral Agent and the Administrative Agent.","hash":"b253905eac2329f4ce5deee359573d97","id":7},{"snippetLinks":[{"key":"the-consent","type":"clause","offset":[6,17]},{"key":"dated-as-of","type":"definition","offset": [32,43]},{"key":"march","type":"clause","offset":[44,49]},{"key":"the-bank","type":"clause","offset":[72,80]},{"key":"sumitomo","type":"definition","offset":[87,95]},{"key":"heavy","type":"clause","offset":[96,101]},{"key":"industries","type":"clause","offset":[102,112]},{"key":"ltd","type":"clause","offset":[114,117]},{"key":"solely-for-purposes-of- section","type":"clause","offset":[120,150]},{"key":"borrower-and","type":"clause","offset":[173,185]},{"key":"certain","type":"clause","offset":[186,193]},{"key":"subsidiaries","type":"clause","offset":[208,220]}],"samples":[{"uri":"/contracts/8I1kKDYnIWF#consent-and-agreement","label":"Loan and Security Agreement (Axcelis Technologies Inc)","score":21},{"uri":"/contracts/ef30eXHgcuS#consent-and-agreement","label":"Loan and Security Agreement (Axcelis Technologies Inc)","score":21},{"uri":"/contracts/dwF8yXcI2kh#consent-and-agreement","label":"Loan and Security Agreement (Axcelis Technologies Inc)","score":21}],"size":6,"snippet":"means the Consent and Agreement dated as of March 30, 2009 by and among the Bank, SEN, Sumitomo Heavy Industries, Ltd. (solely for purposes of Section 2(b) thereunder), the Borrower and certain of Borrower’s Subsidiaries named therein.","hash":"e15b2264efd3078b83ce802817c2631f","id":8},{"snippetLinks":[{"key":"a-consent","type":"clause","offset":[6,15]},