Power Consumption definition

Power Consumption means the power consumption, in watts, of a traffic signal module or a traffic signal lamp.
Sample 1Sample 2Sample 3
Power Consumption means the amount of power consumed by the Hosted Servers during the service period, which shall be determined according to the sum of the reading number of the electric metering devices separately set up for Servers by Party B and the actual line loss. The setting position of the electric metering devices shall be the [inlet end of the transformer high voltage side] and the unit is kWh.
Sample 1Sample 2Sample 3
Power Consumption means the amount of electrical power consumed by the Hosted Servers during the applicable Billing Period, which shall be determined by subtracting the End-Period Meter Reading of the Billing Period immediately preceding the relevant Billing Period from the End-Period Meter Reading of the relevant Billing Period, the unit of which shall be kWh.
Sample 1Sample 2Sample 3

Examples of Power Consumption in a sentence

  • Typical Cycle Compared to Maximum Power Consumption for all Cycles.

  • See the TMS320VC5509A Power Consumption Summary Application Report (literature number SPRAA04).¶ One word of a table of a 16-bit sine value is written to the EMIF every 250 ns (64 Mbps).

  • Borrowing from European Norm 50301 (Reference BSI 03-2001, BS EN 50301:2001, Methods of Measurement for the Power Consumption of Audio, Video, and Related Equipment, Annex A), EPA has established a test procedure where the number of units required for test depends on the test results for the first unit.

  • High Sustained Limit (HSL) for a Load ResourceThe limit calculated by ERCOT, using the Qualified Scheduling Entity (QSE)-established Maximum Power Consumption (MPC).

  • Electrification Futures Study: Scenarios of Electric Technology Adoption and Power Consumption for the United States.

  • Maximum Power Consumption and Low Power Consumption values must be modified to accommodate ADERs, as further provided in this Governing Document.

  • Continuous Power Consumption: 1440 watts Frequency: 45-65 hertz *Note: When using a GFCI outlet the tripping point of the GFCI must be higher than 3.5 milliamps.

  • C2812/C2811/C2810 Typical Power Consumption Over Frequency 96Figure 6−5.

  • The Power Consumption rate category provides for 48 volt DC power used to provide AVOIS to the Customer.

  • In performing these tests, partner agrees to measure a model’s On Mode power consumption using Section 6 of CEA-2022, Digital STB Active Power Consumption Measurement and Sleep Mode power consumption using Annex A of CEA-2013-A, Digital STB Background Power Consumption.


More Definitions of Power Consumption

Power Consumption. Standard Power ** xxxxx includes service channel options installed High Power ** xxxxx includes service channel options installed Section 10: Environment: Temperature Range - Operational: Outdoor Unit -30 degrees C to +60 degrees C Indoor Unit -10 degrees C to +55 degrees C Temperature Range - Storage: -40 degrees C to +70 degrees C for both IDU and ODU Relative Humidity: Outdoor Unit up to 100% for all weather operation Indoor Unit 95% at +55 degrees C Altitude: 4,500 meters (15,000 feet)
Sample 1Sample 2
Power Consumption means the amount of electrical power consumed in connection with the operation of the Co-location Servers during the applicable Billing Period, which shall be determined by subtracting the End-Period Meter Reading of the Billing Period immediately preceding the relevant Billing Period from the End-Period Meter Reading of the relevant Billing Period, the unit of which shall be kWh.
Sample 1Sample 2
Power Consumption xxxxx includes service channel options installed
Sample 1Sample 2
Power Consumption. Standard Power 50 xxxxx includes service channel options installed High Power 55 xxxxx includes service channel options installed Section 10: Environment:
Sample 1

Related to Power Consumption

  • Actual consumption means the measured consumption by a customer of a municipal service;

  • Consumption of a chemical means its conversion into another chemical via a chemical reaction.

  • point of consumption means a point of consumption as defined in the Regulations;

  • cogeneration means the simultaneous generation in one process of thermal energy and electrical or mechanical energy;

  • Biomass means the biodegradable fraction of products, waste and residues from biological origin from agriculture (including vegetal and animal substances), forestry and related industries including fisheries and aquaculture, as well as the biodegradable fraction of industrial and municipal waste;

  • low voltage means the set of nominal voltage levels that are used for the distribution of electricity and whose upper limit is generally accepted to be an a.c. voltage of 1000V ( or a d.c. voltage of 1500 V). [SANS 1019]

  • average consumption means the average consumption by a customer of a municipal service during a specific period, which consumption is calculated by dividing by three the total measured consumption of that service by that customer over the preceding three months;

  • Gasification means the substoichiometric oxidation or steam reformation of a substance to produce a gaseous mixture containing two or more of the following: (i) oxides of carbon; (ii) methane; and (iii) hydrogen;

  • Fuel means any solid, liquid or gaseous combustible material;

  • Supply Point means the point of connection between the licensed network and your apparatus or equipment.

  • Electric power generator means an entity that proposes to

  • Rack means a mechanism for delivering motor vehicle fuel or diesel from a refinery or terminal into a truck, trailer, railroad car, or other means of non-bulk transfer.

  • Delivery Point means the point(s) of connection(s) at which energy is delivered into the Grid System i.e. the Interconnection Point.

  • Power plant means a facility for the generation of

  • Generation Interconnection Customer means an entity that submits an Interconnection Request to interconnect a new generation facility or to increase the capacity of an existing generation facility interconnected with the Transmission System in the PJM Region.

  • Generator means a device that produces electricity.

  • Load means energy consumed by Customers together with allocated losses and unaccounted for energy;

  • Basal area means the effective surface area available to transmit the treated effluent from the filter media in a mound system into the in-situ receiving soils. The perimeter is measured at the interface of the imported fill material and in-situ soil. On sloping sites, only the area down-gradient from the up-slope edge of the distribution media may be included in this calculation.