Required Flow definition

Required Flow. As used in this Regulation, shall mean the necessary and/or required rate of water flow which shall be delivered to the area of need at a rate and pressure as prescribed herein. Normally expressed in gpm. “Roofing Kettle” Any container in excess of fifteen (15) gallons capacity used for preheating tar, asphalt, pitch
Sample 1Sample 2Sample 3
Required Flow. Down(s))”. Provisions of this Common Agreement containing Required Flow-Downs are identified in the applicable section/subsection title as “(Required Flow-Down(s)).” For purposes of implementing the Required Flow-Downs, references in such sections/subsections to “Signatory” shall be interpreted to also mean “Participant(s)” and “Subparticipant(s),” as the case may be. References to “Common Agreement” shall be interpreted to mean the applicable Framework Agreement, as the case may be.‌‌
Sample 1
Required Flow. As used in this Regulation, shall mean the necessary and/or required rate of water flow which shall be delivered to the area of need at a rate and pressure as prescribed herein. Normally expressed in gpm.
Sample 1Sample 2

Examples of Required Flow in a sentence

  • Required Flow in Gallons per Minute (GPM) to provide 2.5 feet per second Flushing Velocity Type of PipeNominal Pipe Size(inches)HDPE(SDR 11)PVC(160 psi)Galv.

  • Fire Flow Test from closest existing hydrant* (Required Flow: 1000 gpm @ 20 psi) APPLICANT: Kevin Obarski PETITION NO.: Z-96PRESENT ZONING: R-30, GC PETITION FOR: R-30 * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * PLANNING COMMENTS: The applicant is requesting a rezoning from R-30 and GC to only R-30 for purpose of single family residential.

  • Required Flow in Gallons per Minute (GPM) to provide 2.5 feet per second Flushing Velocity Type of PipeNominal Pipe Size (inches)HDPE (SDR 11)PVC(160 psi)Galv.

  • TABLE 3-5PRESCRIPTIVE INTEGRATED FORCED AIR SUPPLY DUCT SIZING Required Flow (CFM) Per Table 3-2Minimum Smooth Duct DiameterMinimum Flexible Duct Diameter 1.

  • The delay was largely due to the Treasury’s need to finalize the SBLF’s investment decision process with federal banking agencies58 and the need to create separate SBLF regulations for financial institutions established as C corporations, Subchapter S corporations, mutual lending institutions, and Community Development Financial Institutions (CDFIs).A C corporation is a legal entity established under state law and includes shareholders, directors, and officers.

  • For the avoidance of doubt, a reference to a specific section of the Common Agreement in a particular section does not mean that other sections of this Common Agreement that expressly apply to a QHIN (or to a Participant or a Subparticipant pursuant to a Required Flow- Down) are inapplicable.

  • Where higher occupant loadings are known, they shall be used.16 Effective 7/01/07Washington State Ventilation And Indoor Air Quality Code TABLE 3-5PRESCRIPTIVE INTEGRATED FORCED AIR SUPPLY DUCT SIZING Required Flow (CFM) Per Table 3-2Minimum Smooth Duct DiameterMinimum Flexible Duct Diameter 1.

  • The following is an example for dynamically preparing a 25 ppbC standard of propane and benzene: Example Dynamic Dilution: Primary Stock Gas: 512 ppbC propane and 492 ppbC benzene Desired Working Standard Concentration: 25 ppbCMinimum Required Flow Rate: 45 mL/minuteStandard Gas Flow Controller Range: 0 to 100 mL/minute Diluent Gas Flow Controller Range: 0 to 5000 mL/minute 1.

  • Care should be exercised when selecting the species of trees and positioning them in relation to street lights.• In new subdivisions and developments lighting column positions must be located to provide the correct lighting levels in accordance with AS/NZS 1158 and this Code of Practice.

  • For other gases, contact Honeywell Analytics Limited.Flow Through Gas CellHigh Concentration (V/V cell) NozzlesDust Caps Equipment Required: Flow Through Cell Gassing Kit, consisting of:Lengths of plastic tube with In Line Particle Filter.

Related to Required Flow

  • Required Filings shall have the meaning specified in the Pledge and Security Agreement.

  • Required Filing Date has the meaning set forth in Section 3.1.

  • Required form means in the form of mill product, such as bar, billet, wire, slab, plate, or sheet, and in the grade appropriate for the production of—

  • Required Filing Dates has the meaning set forth in Section 4.17.

  • Prepared food means the following:

  • Required Facility Documents means all licenses, permits, authorizations, and agreements necessary for construction, operation, interconnection, and maintenance of the Facility including without limitation those set forth in Exhibit B.

  • Red Flag means a pattern, practice, or specific activity or a combination of patterns, practices or specific activities which may indicate the possible existence of Identity Theft (as defined below) affecting a Registered Owner (as defined below) or a Covered Person.

  • Adult motel means a hotel, motel or similar commercial establishment which:

  • Required Facility Lenders means, as of any date of determination, with respect to one or more Facilities, Lenders having more than 50% of the sum of (a) the Total Outstandings under such Facility or Facilities and (b) the aggregate unused Commitments under such Facility or Facilities; provided that the unused Commitments of, and the portion of the Total Outstandings under such Facility or Facilities held or deemed held by, any Defaulting Lender shall be excluded for purposes of making a determination of the Required Facility Lenders.

  • Private Sewage Disposal System means a system which provides for the treatment or disposal of domestic sewage from four or fewer dwelling units or the equivalent of less than sixteen individuals on a continuing basis.

  • Measured Flow means any method of liquid volume measurement the accuracy of which has been previously demonstrated in engineering practices, or for which a relationship to absolute volume has been obtained.

  • Operational requirements means the need to ensure that the Agency is to be operated as effectively, efficiently and economically as possible.

  • Good Utility Practices mean any of the practices, methods or acts engaged in or approved by a significant portion of the electric energy industry with respect to similar facilities during the relevant time period which in each case, in the exercise of reasonable judgment in light of the facts known or that should have been known at the time a decision was made, could have been expected to accomplish the desired result at reasonable cost consistent with good business practices, reliability, safety, law, regulation, environmental protection and expedition. Good Utility Practices are not intended to be limited to the optimum practices, methods or acts to the exclusion of all others, but rather to delineate the acceptable practices, methods or acts generally accepted in such industry.

  • Safety Requirements means Prudent Electrical Practices, CPUC General Order No. 167, Contractor Safety Program Requirements, and all applicable requirements of Law, PG&E, the Utility Distribution Company, the Transmission Provider, Governmental Approvals, the CAISO, CARB, NERC and WECC.

  • MREL Requirements means the laws, regulations, requirements, guidelines, rules, standards and policies relating to minimum requirements for own funds and eligible liabilities applicable to the Issuer and/or the Group, from time to time, (including any applicable transitional or grandfathering provisions), including, without limitation to the generality of the foregoing, any delegated or implementing acts (such as regulatory technical standards) adopted by the European Commission and any regulations, requirements, guidelines, rules, standards and policies relating to minimum requirements for own funds and eligible liabilities adopted by the Federal Republic of Germany or the Republic of Italy, a relevant resolution authority or the European Banking Authority from time to time (whether or not such requirements, guidelines or policies are applied generally or specifically to the Issuer and/or the Group), as any of the preceding laws, regulations, requirements, guidelines, rules, standards, policies or interpretations may be amended, supplemented, superseded or replaced from time to time.

  • MREL Requirement means the minimum requirement for own funds and eligible liabilities which is or, as the case may be, will be applicable to the Issuer;

  • Permanent foster care placement means the place of residence in which a child resides and in

  • Required Financial Information means, with respect to the applicable Calculation Date, (i) the financial statements of the Consolidated Parties required to be delivered pursuant to Section 7.1(a) or (b) for the fiscal period or quarter ending as of such Calculation Date, and (ii) the certificate of an Executive Officer of the Borrower required by Section 7.1(c) to be delivered with the financial statements described in clause (i) above.

  • Accessibility Standards means accessibility standards and specifications for Texas agency and institution of higher education websites and EIR set forth in 1 TAC Chapter 206 and/or Chapter 213.

  • Safety compliance facility means a licensee that is a commercial entity that receives marihuana from a marihuana facility or registered primary caregiver, tests it for contaminants and for tetrahydrocannabinol and other cannabinoids, returns the test results, and may return the marihuana to the marihuana facility.

  • Technically permissible maximum laden mass means the maximum mass allocated to a vehicle on the basis of its construction features and its design performances.

  • Totally enclosed treatment facility means a facility for the treatment of hazardous waste which is directly connected to an industrial production process and which is constructed and operated in a manner which prevents the release of any hazardous waste or any constituent thereof into the environment during treatment. An example is a pipe in which waste acid is neutralized.

  • Environmental, Health or Safety Requirements of Law means all Requirements of Law derived from or relating to foreign, federal, state and local laws or regulations relating to or addressing pollution or protection of the environment, or protection of worker health or safety, including, but not limited to, the Comprehensive Environmental Response, Compensation and Liability Act, 42 U.S.C. § 9601 et seq., the Occupational Safety and Health Act of 1970, 29 U.S.C. § 651 et seq., and the Resource Conservation and Recovery Act of 1976, 42 U.S.C. § 6901 et seq., in each case including any amendments thereto, any successor statutes, and any regulations or guidance promulgated thereunder, and any state or local equivalent thereof.

  • Adulterated means food or milk to which any of the following apply:

  • Repeat compliance period means any subsequent compliance period after the initial compliance period.

  • Minimum Transaction Size means the minimum value of subsequent subscriptions,