Cubic Foot means the volume of gas which occupies one cubic foot when such gas is at a temperature of 60 degrees Fahrenheit, and at a pressure of 14.73 pounds per square inch absolute.
Existing Building means a building that (a) was in existence and completely constructed on the date that the Applicant first submitted its Application, or (b) in respect of which the IESO has, in its sole and absolute discretion, issued a written confirmation that the building will be deemed an Existing Building for the purposes of the definition of Rooftop Facility.
car-share parking space means a parking space that is reserved and actively used for car-sharing;
Cubic foot of gas means the amount of gas required to fill a cubic foot of space when the gas is at an absolute pressure of fourteen and seventy-three hundredths (14.73) pounds per square inch at a temperature of sixty (60) degrees Fahrenheit.
parking meter means an apparatus for use on or in the vicinity of a parking place for indicating, as respects a space provided at that parking place for the leaving of vehicles, whether the initial charge has been paid and whether the period for which payment was made by the initial charge has expired;
Ton means a ton of two thousand two hundred and forty (2,240) lbs. net dry weight;
storage vessel means a pressure vessel as defined in the Regulations for Pressure Vessels made under the Occupational Health and Safety Act;
Addition (to an existing building means an extension or increase in the floor area or height of a building or structure.
Psig means pounds per square inch gauge.
Buffer area means an area of natural or established vegetation managed to protect other components of a Resource Protection Area and state waters from significant degradation due to land disturbances.
Fuel burning equipment means any furnace, boiler, apparatus, stack and all associated equipment, used in the process of burning fuel.
tons means the gross tonnage calculated in accordance with the tonnage measurement regulations contained in Annex I of the International Convention on Tonnage Measurement of Ships, 1969; the word “tonnage” shall be construed accordingly.
Vapor tight means equipment that allows no loss of vapors. Compliance with vapor-tight requirements can be determined by checking to ensure that the concentration at a potential leak source is not equal to or greater than 100 percent of the lower explosive limit (LEL) when measured with a combustible gas detector, calibrated with propane, at a distance of 1 inch (2.54 cm) from the source.
Altitude means the vertical distance of a level, a point or an object considered as a point, measured from mean sea level (MSL);
manoeuvring area means that part of an aerodrome to be used for the take-off, landing and taxiing of aircraft, excluding aprons;
chemical tanker means a ship constructed or adapted and used for the carriage in bulk of any liquid product listed in chapter 17 of the International Bulk Chemical Code;
Work area means a room or defined space in a workplace where hazardous chemicals are produced or used, and where employees are present.
On-premise beer retailer means a beer retailer who is:
Plasma arc incinerator means any enclosed device using a high intensity electrical discharge or arc as a source of heat followed by an afterburner using controlled flame combustion and which is not listed as an industrial furnace.
Grave space means a space of ground in a cemetery that is used or intended to be used for an in-ground burial.
Time Block means a time block of 15 minutes, for which specified electrical parameters and quantities are recorded by special energy meter, with first time block starting at 00.00 hrs;
Ethanol blended gasoline means the same as defined in section 214A.1.
Receipt Point(s) means the receipt points set forth in Section 6 of this Toll Schedule.
Maximum contaminant level means the maximum permissible level of a contaminant in water which is delivered to any user of a public water system.
Modular building manufacturer means a person or corporation who owns or operates a
stratigraphic test well means a drilling effort, geologically directed, to obtain information pertaining to a specific geologic condition. Ordinarily, such wells are drilled without the intention of being completed for hydrocarbon production. They include wells for the purpose of core tests and all types of expendable holes related to hydrocarbon exploration. Stratigraphic test wells are classified as (i) "exploratory type" if not drilled into a proved property; or (ii) "development type", if drilled into a proved property. Development type stratigraphic wells are also referred to as "evaluation wells".