Roll Test definition

Roll Test means the test conducted in accordance with Annex 7.
Sample 1Sample 2Sample 3

Examples of Roll Test in a sentence

  • The turf fiber must retain a minimum of 75% of its original fibril width after 10,000 cycles on the Lisport Studded Roll Test Machine.

  • Pre 01 May 1975 vessels which are Single and twin boom fishing vessels of 15m and Over subject to the Roll Test Procedure should be roll tested by a consultant and witnessed by an MCA surveyor.

  • Likewise, if it fails on the first attempt but passes on the second attempt, the third attempt is not done (at BISFed sanctioned tournaments, testing will be done on a Roll Test Device that has been confirmed by the HR with an angle finder to be between 24.5 and 25.5 degrees).

  • Roll Test shall be performed when required by City Engineer to determine the structural integrity of the subgrade and street section.

  • The requirements for the Roll Test are set out in 3.9 to 3.11 of this Chapter below.

  • The owner may present MSF1378 Roll Test Measurement Report Form – Owner at the inspection.

  • The requirements for the Roll Test are set out in 3.9 to 3.11 below of this Chapter.

  • After the coin toss, each ball will be tested in the Call Room using a Standard BISFed Roll Test to check that it will roll under the influence of gravity by releasing the ball down an aluminium ramp 290mm in length at an incline of 25 degrees to the horizontal (plus or minus 0.5 degrees).

  • Roll Test Measurement Report – MCA should be used to record the test.

  • Multihull vessels must, conduct a Heel Test instead of a Roll Test.

Related to Roll Test

  • RDDS test Means one query sent to a particular “IP address” of one of the servers of one of the RDDS services. Queries shall be about existing objects in the Registry System and the responses must contain the corresponding information otherwise the query will be considered unanswered. Queries with an RTT 5 times higher than the corresponding SLR will be considered as unanswered. The possible results to an RDDS test are: a number in milliseconds corresponding to the RTT or undefined/unanswered.

  • EPP test Means one EPP command sent to a particular “IP address” for one of the EPP servers. Query and transform commands, with the exception of “create”, shall be about existing objects in the Registry System. The response shall include appropriate data from the Registry System. The possible results to an EPP test are: a number in milliseconds corresponding to the “EPP command RTT” or undefined/unanswered.

  • DNS test Means one non-­‐recursive DNS query sent to a particular “IP address” (via UDP or TCP). If DNSSEC is offered in the queried DNS zone, for a query to be considered answered, the signatures must be positively verified against a corresponding DS record published in the parent zone or, if the parent is not signed, against a statically configured Trust Anchor. The answer to the query must contain the corresponding information from the Registry System, otherwise the query will be considered unanswered. A query with a “DNS resolution RTT” 5 times higher than the corresponding SLR, will be considered unanswered. The possible results to a DNS test are: a number in milliseconds corresponding to the “DNS resolution RTT” or, undefined/unanswered.

  • PRINCIPAL TEST The CONTRACTOR rather than COUNTY has the right to control the manner and means of accomplishing the result contracted for.

  • Fit test means the use of a protocol to qualitatively or quantitatively evaluate the fit of a respirator on an individual.

  • Drug test means a test designed to detect the illegal use of a controlled substance.

  • COVID-19 test means a viral test for SARS-CoV-2 that is:

  • Performance Test means all operational checks and tests required to determine the performance parameters including inter-alia capacity, efficiency and operating characteristics of the Stores as specified in the Contract.

  • Percolation test means a subsurface soil test at the depth of a proposed absorption system or similar component of an OWTS to determine the water absorption capability of the soil, the results of which are normally expressed as the rate at which one inch of water is absorbed. The rate is expressed in minutes per inch.

  • Start-Up Testing means the completion of applicable required factory and start-up tests as set forth in Exhibit C.

  • Acceptance Test is a test of the Features executed by the Customer to prepare the acceptance.

  • Plant Test Date or "PTD" means the date acceptance testing is performed with CLEC. "Point of Interface", "Point of Interconnection," or "POI" is a demarcation between the networks of two (2) LECs (including a LEC and CLEC). The POI is that point where the exchange of traffic takes place.

  • Commissioning test means tests applied to the Generating Facility, after completion of the construction of the Generating Facility, in order to verify that the Generating Facility may be released for Operation.

  • Drug use test means a scientifically substantiated method to test for the presence of illegal or performance-enhancing drugs or the metabolites thereof in a person’s urine.

  • Operational Acceptance Tests means the tests specified in the Technical Requirements and Agreed Project Plan to be carried out to ascertain whether the System, or a specified Sub system, is able to attain the functional and performance requirements specified in the Technical Requirements and Agreed Project Plan, in accordance with the provisions of GCC Clause 27.2 (Operational Acceptance Test).

  • Screening Test means a drug or alcohol test which uses a method of analysis allowed by the Minnesota Drug and Alcohol Testing in the Workplace Act to be used for such purposes.

  • Asset Test means, for an Asset Review, each Test, as defined in the Asset Representations Review Agreement, in Schedule A to the Asset Representations Review Agreement to be performed by the Asset Representations Reviewer on the related Asset Review Receivables.

  • Class C Par Value Test means the test which will be satisfied as of any Measurement Date if, on such Measurement Date, the Class C Par Value Ratio is at least equal to the percentage specified in the definition of "Coverage Test".

  • LCT Test Date shall have the meaning provided in Section 1.12(b).

  • Genetic test means an analysis of human DNA, RNA, chromosomes, proteins, or metabolites, that detect genotypes, mutations, or chromosomal changes. The term “genetic test” does not mean an analysis of proteins or metabolites that does not detect genotypes, mutations, or chromosomal changes; or an analysis of proteins or metabolites that is directly related to a manifested disease, disorder, or pathological condition that could reasonably be detected by a health care professional with appropriate training and expertise in the field of medicine involved.

  • Performance Tests means the tests to be conducted on the equipment at site for checking the performance parameters of the equipment as defined in Technical Specification.

  • Acceptance Testing mean the tests, reviews and other activities that are performed by or on behalf of Agency to determine whether the Deliverables meet the Acceptance Criteria or otherwise satisfy the Agency, as determined by the Agency in its sole discretion.

  • Incurrence Test means the incurrence test set out in Clause 12.1 (Incurrence Test).

  • Class D Par Value Test means the test which will be satisfied as of any Measurement Date if, on such Measurement Date, the Class D Par Value Ratio is at least equal to the percentage specified in the definition of "Coverage Test".

  • Cannabis testing facility means an entity registered by

  • Acceptance Tests means those tests performed during the Performance Period which are intended to determine compliance of Equipment and Software with the specifications and all other Attachments incorporated herein by reference and to determine the reliability of the Equipment.