Stability control definition

Stability control means any device that complies with national, "Electronic stability control systems".
Stability control means any device that complies with UN ECE R140, “Electronic stability control systems”.
Stability control means any device that complies with UN ECE R140, “Electronic stability control systems”.

Examples of Stability control in a sentence

  • Stability control intervention has the potential to significantly increase the stability of the vehicle in which it is installed.

  • Criteria for a stable measured valueThe Stability control function checks whether the measured values are stable within the monitored time interval.

  • Stability control is not to be deactivated for any Slowly Increasing Steer or Fishhook maneuver.

  • The stability has a considerable impact on the reproduc- ibility of measured values.The measured parameter flashes on the display⚫ as soon as the measured value is outside the stability range⚫ when the automatic Stability control is switched off.

  • Figure 1: Rollover Condition Stability control technologies help a driver maintain directional control and help to reduce roll instability.

  • You can start the Stability control manually at any time, irrespective of the set- ting for automatic Stability control (see section 11.6.3 AUTOMATIC STABILITY CONTROL, page 70) in the System menu.

  • Rollover Anti-lock braking system ABS activity Mandatory -5.0 to 0 sec 2 Faulted, Non-Engaged, Engaged Active, Intervening12 N/A Faulted, Non-Engaged, Engaged Active, Intervening12 Planar VRU Rollover Stability control Mandatory -5.0 to 0 sec 2 Faulted, On, Off, Engaged Intervening12 N/A Faulted, On, Off, Engaged Intervening12 Planar VRU Rollover Steering input Mandatory -5.0 to 0 sec 2 -250 deg CW to + 250 deg CCW.

  • You can prematurely terminate the Stability control function manu- ally with <OK> at any time.

  • Stability control systems include sensors that monitor vehicle dynamics and estimate the stability of a vehicle based on its mass and velocity.

  • Stability control (on, off, engaged) ..If recorded ......................................–5.0 to 0 sec ..................................2Steering input ..................................If recorded ......................................–5.0 to 0 sec ..................................2Safety belt status, right front pas-If recorded ......................................–1.0 sec ..........................................N/Asenger (buckled, not buckled).

Related to Stability control

  • Quality control means the total of all activities performed by the Design-Builder, Designer, Construction Inspection Professional Engineering Firm and the Materials Testing Firm or Laboratory, subcontractors, producers or manufacturers to ensure that the Work performed by the Design-Builder conforms to the Contract requirements. For design, Quality Control activities shall include, but not be limited to, procedures for design quality, checking, design review including reviews for constructability, and review and approval of Working Plans. For construction, Quality Control activities shall include, but not be limited to, procedures for materials handling and construction quality, inspection, sampling and testing of materials both on site and at the plant(s), field testing of materials, obtaining and verifying Materials Certifications, record keeping, and equipment monitoring and calibration, production process control, and monitoring of environmental compliance. Quality Control also includes documentation of all QC design and construction efforts. The Scope of Work to be performed as part of the Quality Control task may be changed after the RFQ Phase.

  • Emission Control Strategy means any device, system, or strategy employed with a diesel-fueled CI engine that is intended to reduce emissions. Examples of emission control strategies include, but are not limited to, particulate filters, diesel oxidation catalysts, selective catalytic reduction systems, alternative fuels, fuel additives used in combination with particulate filters, alternative diesel fuels, and combinations of the above.

  • Security Control means a safeguard or countermeasure prescribed for an information system or an organization designed to protect the confidentiality, integrity, and availability of its information and to meet a set of defined security requirements.

  • Structural pest control means a use requiring a license under Chapter 14 (commencing with Section 8500), Division 3, of the Business and Professions Code.

  • Traffic control signal means a device, whether manually, electrically, or mechanically operated, by which traffic is alternately directed to stop and permitted to proceed.

  • air traffic control service means a service provided for the purpose of:

  • Emission control system means the electronic engine management controller and any emission related component in the exhaust or evaporative system which supplies an input to or receives an output from this controller.

  • Commercial Operation means the condition of operation in which the complete equipment covered under the Contract is officially declared by the Owner to be available for continuous operation at different loads up to and including rated capacity. Such declaration by the Owner, however, shall not relieve or prejudice the Contractor of any of his obligations under the Contract.

  • Site Control means that Seller (a) owns the Site, (b) is the lessee of the Site under a Lease, (c) is the holder of a right-of-way grant or similar instrument with respect to the Site, or (d) is managing partner or other Person authorized to act in all matters relating to the control and Operation of the Site and Generating Facility.

  • Disturbance Control Standard or “DCS” shall mean the reliability standard that sets the time limit following a disturbance within which a balancing authority must return its Area Control Error to within a specified range.

  • New Jersey Stormwater Best Management Practices (BMP) Manual or “BMP Manual” means the manual maintained by the Department providing, in part, design specifications, removal rates, calculation methods, and soil testing procedures approved by the Department as being capable of contributing to the achievement of the stormwater management standards specified in this chapter. The BMP Manual is periodically amended by the Department as necessary to provide design specifications on additional best management practices and new information on already included practices reflecting the best available current information regarding the particular practice and the Department’s determination as to the ability of that best management practice to contribute to compliance with the standards contained in this chapter. Alternative stormwater management measures, removal rates, or calculation methods may be utilized, subject to any limitations specified in this chapter, provided the design engineer demonstrates to the municipality, in accordance with Section IV.F. of this ordinance and N.J.A.C. 7:8-5.2(g), that the proposed measure and its design will contribute to achievement of the design and performance standards established by this chapter.

  • Vapor control system means a system that prevents release to the atmosphere of gasoline vapors in excess of 80 milligrams per liter of gasoline loaded (4.7 grains per liter).

  • Supply Chain means the individuals and organisations who will be responsible for any of the design and/or construction of the Works as set out in the Schedule of Supply Chain Members;

  • waste management means the collection, transport, recovery and disposal of waste, including the supervision of such operations and the after-care of disposal sites, and including actions taken as a dealer or broker;

  • Pretreatment coating means a coating which contains no more than 12% solids by weight, and at least 0.5% acid by weight, is used to provide surface etching, and is applied directly to metal surfaces to provide corrosion resistance, adhesion, and ease of stripping.

  • Radiopharmaceutical quality assurance means, but is not limited to, the performance of appropriate chemical, biological, and physical tests on potential radiopharmaceuticals and the interpretation of the resulting data to determine their suitability for use in humans and animals, including internal test assessment, authentication of product history, and the keeping of proper records.

  • Access control means a system for allowing only approved individuals to have unescorted access to the security zone and for ensuring that all other individuals are subject to escorted access.

  • aerodrome control service means air traffic control service for aerodrome traffic;

  • Traffic control device means a flagger, sign, signal, marking, or other device used to regulate, warn or guide traffic, placed on, over, or adjacent to a street, highway, private road open to public travel, pedestrian facility, or shared-use path by authority of a public agency or official having jurisdiction, or, in the case of a private road open to public travel, by authority of the private owner or private official having jurisdiction.

  • Control system means the combination of capture and control devices used to reduce emissions to the atmosphere.

  • Controlled substance analog means a substance the chemical structure of which is substantially