Highest Adjacent Grade (HAG means the highest natural elevation of the ground surface, prior to construction, immediately next to the proposed walls of the structure.
Cubic foot of gas means the amount of gas required to fill a cubic foot of space when the gas is at an absolute pressure of fourteen and seventy-three hundredths (14.73) pounds per square inch at a temperature of sixty (60) degrees Fahrenheit.
Highest adjacent grade means the highest natural elevation of the ground surface prior to construction next to the proposed walls of a structure.
Lowest Adjacent Grade (LAG means the elevation of the ground, sidewalk or patio slab immediately next to the building, or deck support, after completion of the building.
Normal Minimum Generation means the lowest output level of a generating resource under normal operating conditions.
Working face means any place in a mine in which work of extracting coal from its natural deposit in the earth is performed during the mining cycle.
Working voltage means the highest value of an electrical circuit voltage root-mean-square (rms), specified by the manufacturer, which may occur between any conductive parts in open circuit conditions or under normal operating conditions. If the electrical circuit is divided by galvanic isolation, the working voltage is defined for each divided circuit, respectively.
Rate of Gross Profit means the gross profit earned expressed as a percentage of the turnover during the period between the date of the commencement of the business and the date of the incident.
Total Floor Area means, the sum total of the total areas of all floors in a building or structure whether at above or below grade measured between the exterior faces of the exterior walls of the building or structure or from the centre line of a common wall separating two uses or from the outside edge of a floor where the outside edge of the floor does not meet an exterior or common wall, and;
Specified anatomical areas means and includes:
manoeuvring area means that part of an aerodrome to be used for the take-off, landing and taxiing of aircraft, excluding aprons;
Working level (WL) means any combination of short-lived radon daughters in 1 liter of air that will result in the ultimate emission of 1.3E+5 MeV of potential alpha particle energy. The short-lived radon daughters are—for radon-222: polonium-218, lead-214, bismuth-214, and polonium-214; and for radon-220: polonium-216, lead-212, bismuth-212, and polonium-212.
Maximum design heat input means the ability of a unit to combust a stated maximum amount of fuel per hour on a steady state basis, as determined by the physical design and physical characteristics of the unit.
Gross weight means the aggregate weight of a vehicle or combination of vehicles and the load
Critical Test Concentration or "(CTC)" means the specified effluent dilution at which the Permittee is to conduct a single-concentration Aquatic Toxicity Test.
Finished grade means the approved elevation of ground surface of lands upon which fill has been placed in accordance with this By-law;
Working Week means an average of 48 hours each week calculated over a 17-week reference period.
nautical mile means the international nautical mile of 1 852 metres;
Working level month (WLM) means an exposure to 1 working level for 170 hours (2,000 working hours per year divided by 12 months per year is approximately equal to 170 hours per month).
Total Evaluated CRIS MW means the Additional CRIS MW requested plus either (i) if the Installed Capacity Supplier previously received an exemption under Sections 23.4.5.7.2(b), 23.4.5.7.6(b), 23.4.5.7.7 or 23.4.5.7.8, all prior Additional CRIS MW since the facility was last exempted under Sections 23.4.5.7.2(b), 23.4.5.7.6(b), or 23.4.5.7.8, or (ii) for all other Installed Capacity Suppliers, all MW of Capacity for which an Examined Facility obtained CRIS pursuant to the provisions in ISO OATT Sections 25, 30, or 32 (OATT Attachments S, X, or Z). For purposes of Section 23.4.5 of this Attachment H, “UCAP Offer Reference Level” shall mean a dollar value equal to the projected clearing price for each ICAP Spot Market Auction determined by the ISO on the basis of the applicable ICAP Demand Curve and the total quantity of Unforced Capacity from all Installed Capacity Suppliers in a Mitigated Capacity Zone for the period covered by the applicable ICAP Spot Market Auction. For purposes of Section 23.4.5 of this Attachment H, “Unit Net CONE” shall mean localized levelized embedded costs of a specified Installed Capacity Supplier, including interconnection costs, and for an Installed Capacity Supplier located outside a Mitigated Capacity Zone including embedded costs of transmission service, in either case net of likely projected annual Energy and Ancillary Services revenues, and revenues associated with other energy products (such as energy services and renewable energy credits, as determined by the ISO, translated into a seasonally adjusted monthly UCAP value using an appropriate class outage rate. The Unit Net CONE of an Installed Capacity Supplier that has functions beyond the generation or transmission of power shall include only the embedded costs allocated to the production and transmission of power, and shall not net the revenues from functions other than the generation or transmission of power.
Adjusted Total turnover means the turnover in a State or a Union territory, as defined under sub-section (112) of section 2, excluding the value of exempt supplies other than zero-rated supplies, during the relevant period;
Throughput means the measure of production, or factor related to production, used to determine the relationship between the amount of energy used by the target unit and the levels of activity of the target unit, as set out in Schedule 6 to an underlying agreement; “the Tribunal” means the First-tier Tribunal established under the Xxxxxxxx Xxxxxx xxx Xxxxxxxxxxx Xxx 00000;
Normal Maximum Generation means the highest output level of a generating resource under normal operating conditions.
Working pressure means the settled pressure of a compressed gas at a reference temperature of 15 °C in a full pressure receptacle;
Exceedance means a condition that is detected by monitoring that provides data in terms of an emission limitation or standard and that indicates that emissions (or opacity) are greater than the applicable emission limitation or standard (or less than the applicable standard in the case of a percent reduction requirement) consistent with any averaging period specified for averaging the results of the monitoring.
Internally Generated Cash means, with respect to any period, any cash of Borrower and its Subsidiaries generated during such period, excluding Net Asset Sale Proceeds, Net Insurance/Condemnation Proceeds and any cash that is received from an incurrence of Indebtedness, an issuance of Equity Interests or a capital contribution.