ADDITIONAL PROVISIONS FOR CUSTOM SOLUTIONS. If the Goods listed in the Quotation include any Custom Solutions then these additional terms and conditions shall apply and are included in the definition of “Terms and Conditions” above.
ADDITIONAL PROVISIONS FOR CUSTOM SOLUTIONS Sample Clauses
Related to ADDITIONAL PROVISIONS FOR CUSTOM SOLUTIONS
Attachment C, Standard State Provisions for Contracts and Grants Attachment C is hereby deleted in its entirety and replaced by the Attachment C December 15, 2017 attached to this Amendment. Child Support (Applicable to natural persons only; not applicable to corporations, partnerships or LLCs). Contractor is under no obligation to pay child support or is in good standing with respect to or in full compliance with a plan to pay any and all child support payable under a support order as of the date of this amendment.
Special Provisions for Affected Systems For the re-payment of amounts advanced to Affected System Operator for System Upgrade Facilities or System Deliverability Upgrades, the Developer and Affected System Operator shall enter into an agreement that provides for such re-payment, but only if responsibility for the cost of such System Upgrade Facilities or System Deliverability Upgrades is not to be allocated in accordance with Attachment S to the ISO OATT. The agreement shall specify the terms governing payments to be made by the Developer to the Affected System Operator as well as the re-payment by the Affected System Operator.
Transitional Provisions 24.1. As from the official date of entry into force of the 01 series of amendments to this Regulation, no Contracting Party applying this Regulation shall refuse to grant or refuse to accept type approval under this Regulation as amended by the 01 series of amendments. 24.2. As from 12 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation shall grant approvals only if the type of components to be approved meets the requirements of Part I of this Regulation as amended by the 01 series of amendments to this Regulation. 24.3. Type approvals of components other than fuel rail, as defined in paragraph 4.72., granted according to the original version of this Regulation or of components granted according to the 01 series of amendments, shall remain valid and shall be accepted for the purpose of their installation on vehicles as long as the requirements for the specific component have not changed by any series of amendments. 24.4. As from 18 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation shall grant approvals only if the vehicle type to be approved meets the requirements of Part II of this Regulation as amended by the 01 series of amendments to this Regulation. 24.5. Until 12 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation can continue to grant type approvals for the type of components to the original version of this Regulation without taking into account the provisions of the 01 series of amendments. 24.6. Until 18 months after the date of entry into force of the 01 series of amendments to this Regulation, Contracting Parties applying this Regulation can continue to grant type approvals for the vehicle type to the original version of this Regulation without taking into account the provisions of the 01 series of amendments. 24.7. Notwithstanding the provisions of paragraphs 24.5. and 24.6., Contracting Parties applying this Regulation shall not refuse to grant extensions of type approvals for existing types of component or vehicle types which have been issued according to this Regulation without taking into account the provisions of the 01 series of amendments to this Regulation. 24.8. As from the official date of entry into force of the 02 series of amendments to this Regulation, no Contracting Party applying this Regulation shall refuse to grant or refuse to accept type approval under this Regulation as amended by the 02 series of amendments. 24.9. As from 1 September 2017 Contracting Parties applying this Regulation shall grant approvals only if the type of components to be approved meets the requirements of Part I of this Regulation as amended by the 02 series of amendments to this Regulation. 24.10. As from 1 September 2018 Contracting Parties applying this Regulation shall grant approvals only if the vehicle type to be approved meets the requirements of Part II of this Regulation as amended by the 02 series of amendments to this Regulation. 24.11. As from 1 September 2019 Contracting Parties applying this Regulation may refuse to recognize approvals of a type of vehicle which have not been granted in accordance with Part II of this Regulation as amended by the 02 series of amendments to this Regulation. 24.12. Contracting Parties applying this Regulation shall not refuse to grant extensions of type approvals for existing types of component or vehicle types which have been issued according to this Regulation without taking into account the provisions of the 02 series of amendments to this Regulation. 24.13. Notwithstanding paragraphs 24.11. and 24.12., Contracting Parties applying this Regulation shall continue to accept type approvals granted to the preceding series of amendments, which are not affected by the 02 series of amendments.
Additional Provisions Respecting Insurance (a) All insurance required by this Tenant Agency Compliance Agreement shall be procured and maintained in financially sound and generally recognized responsible insurance companies authorized to write such insurance in the State and selected by the entity required to procure the same. The company issuing the policies required by Section 2.1(a) hereof shall be rated “A” or better by A.M. Best Co., Inc. in Best’s Key Rating Guide. Such insurance may be written with deductible amounts comparable to those on similar policies carried by other companies engaged in businesses similar in size, character and other respects to those in which the procuring entity is engaged. All policies of insurance required by Section 2.1 hereof shall provide for at least thirty (30) days prior written notice to the Agency of the restriction, cancellation or modification thereof. The policy evidencing the insurance required by Section 2.1(c) hereof shall name the Agency as an additional insured. All policies evidencing the insurance required by Section 2.1 (d)(ii) and (iv) shall name the Agency and the Tenant as additional insureds. (b) The certificate of insurance required by Section 2.1(c) hereof shall be delivered to the Agency on or before the date hereof. A copy of the certificates of insurance required by Section 2.1(d)(ii) and (iv) hereof shall be delivered to the Agency on or before the commencement of any construction or renovation of the Demised Premises. The Tenant shall deliver to the Agency before the first Business Day of each calendar year thereafter a certificate dated not earlier than the immediately preceding month reciting that there is in full force and effect, with a term covering the current year of the Tenant’s insurance policy, insurance of the types and in the amounts required by Section 2.1 hereof and complying with the additional requirements of Section 2.2(a) hereof. Prior to the expiration of each such policy or policies, the Tenant shall furnish to the Agency and any other appropriate Person a new policy or policies of insurance or evidence that such policy or policies have been renewed or replaced or are no longer required by this Tenant Agency Compliance Agreement. The Tenant shall provide such further information with respect to the insurance coverage required by this Tenant Agency Compliance Agreement as the Agency may from time to time reasonably require.
Use of Subservicers and Subcontractors (a) The Master Servicer shall cause any Subservicer used by the Master Servicer (or by any Subservicer) for the benefit of the Depositor to comply with the provisions of Section 3.16 and this Article XI to the same extent as if such Subservicer were the Master Servicer (except with respect to the Master Servicer's duties with respect to preparing and filing any Exchange Act Reports or as the Certifying Person). The Master Servicer shall be responsible for obtaining from each Subservicer and delivering to the Depositor any servicer compliance statement required to be delivered by such Subservicer under Section 3.16, any assessment of compliance and attestation required to be delivered by such Subservicer under Section 11.07 and any certification required to be delivered to the Certifying Person under Section 11.05 as and when required to be delivered. As a condition to the succession to any Subservicer as subservicer under this Agreement by any Person (i) into which such Subservicer may be merged or consolidated, or (ii) which may be appointed as a successor to any Subservicer, the Master Servicer shall provide to the Depositor, at least 15 calendar days prior to the effective date of such succession or appointment, (x) written notice to the Depositor of such succession or appointment and (y) in writing and in form and substance reasonably satisfactory to the Depositor, all information reasonably requested by the Depositor in order to comply with its reporting obligation under Item 6.02 of Form 8-K. (b) It shall not be necessary for the Master Servicer, any Subservicer or the Trustee to seek the consent of the Depositor or any other party hereto to the utilization of any Subcontractor. The Master Servicer or the Trustee, as applicable, shall promptly upon request provide to the Depositor (or any designee of the Depositor, such as the Master Servicer or administrator) a written description (in form and substance satisfactory to the Depositor) of the role and function of each Subcontractor utilized by such Person (or in the case of the Master Servicer or any Subservicer), specifying (i) the identity of each such Subcontractor, (ii) which (if any) of such Subcontractors are "participating in the servicing function" within the meaning of Item 1122 of Regulation AB, and (iii) which elements of the Servicing Criteria will be addressed in assessments of compliance provided by each Subcontractor identified pursuant to clause (ii) of this paragraph. As a condition to the utilization of any Subcontractor determined to be a Reporting Subcontractor, the Master Servicer or the Trustee, as applicable, shall cause any such Subcontractor used by such Person (or in the case of the Master Servicer or any Subservicer) for the benefit of the Depositor to comply with the provisions of Sections 11.07 and 11.09 of this Agreement to the same extent as if such Subcontractor were the Master Servicer (except with respect to the Master Servicer's duties with respect to preparing and filing any Exchange Act Reports or as the Certifying Person) or the Trustee, as applicable. The Master Servicer or the Trustee, as applicable, shall be responsible for obtaining from each Subcontractor and delivering to the Depositor and the Master Servicer, any assessment of compliance and attestation required to be delivered by such Subcontractor under Section 11.05 and Section 11.07, in each case as and when required to be delivered.
REQUESTS FOR FLEXIBLE WORKING ARRANGEMENTS 49.1 Employee may request change in working arrangements s.65 of the Act. Note 1: Section 65 of the Act provides for certain Employees to request a change in their working arrangements because of their circumstances, as set out in s.65(1A).
Provisions governing staff and subcontractors A. To require any subcontractor to execute documents that binds the subcontractor to comply with the provisions of this Contract. Subcontractor means an individual or entity to which the Contractor has contracted with or delegated some of its management functions or responsibilities of providing all or a part of the services required of the Contractor under this Contract. B. That it is responsible for the behavior of its staff and subcontractors to ensure a violence-free contractual relationship. The Contractor understands that any remarks, gestures or actions toward HHSC employees, volunteers or clients that carry an implied threat of any kind, even if intended to be in jest, will be taken seriously and may lead to corrective action, up to and including terminating this contractor. C. To comply with the requirements of the Immigration Reform and Control Act of 1986 regarding employment verification and retention of verification forms for an individual hired on or after November 6, 1986, who will perform any labor or services under this Contract. D. To certify and ensure that it utilizes and will continue to utilize, for the term of this Contract, the U. S. Department of Homeland Security's e- Verify system to determine the eligibility of: 1. all people employed during the Contract term to perform duties within Texas; and 2. all people (including subcontractors). E. That representatives of HHSC, AG-MFCU and HHS may conduct interviews of Contractor personnel, subcontractors and their personnel, witnesses, and clients without a Contractor's representative present unless the person interviewed voluntarily requests that the representative be present. The Contractor must not coerce its personnel, subcontractors and their personnel, witnesses, or clients to accept representation by the Contractor, and the Contractor agrees that no retaliation will occur to a person who denies the Contractor's offer of representation. Nothing in the Contract limits a person's right to counsel of his or her choice. Requests for interviews are to be complied with in the form and the manner requested. The Contractor must ensure by contract or other means that its personnel and subcontractors cooperate fully in any investigation conducted by representatives of HHSC, AG-MFCU and HHS. F. That if it is a Home and Community Support Services agency ("HCSSA"), the Contractor will hire Personal Assistance Services and Community Support Services providers chosen by the client or the client's legally authorized representative, if requested, and provided the individual who will provide the services: 1. meets minimum qualifications for the service; 2. is willing to be employed as an attendant by the Contractor; and 3. is willing, and determined competent by the Contractor, to deliver the service(s) according to the client's individual service plan.
Specific Provisions for Access Rights to Software For the avoidance of doubt, the general provisions for Access Rights provided for in this Section 9 are applicable also to Software. Parties’ Access Rights to Software do not include any right to receive source code or object code ported to a certain hardware platform or any right to receive respective Software documentation in any particular form or detail, but only as available from the Party granting the Access Rights.
Additional Provisions The By-Laws may include further provisions for Shareholders' votes and meetings and related matters.
Final Provisions Clause 16
