Minimum Customer Support Requirements for TIPS Sales Vendor shall provide timely and commercially reasonable support for TIPS Sales or as agreed to in the applicable Supplemental Agreement.
CONTRACT REQUIREMENTS a. NSF will exercise its responsibility for oversight and monitoring of procurements, contracts or other contractual arrangements for the purchase of materials and supplies, equipment or general support services under the award. The procedures set forth below must be followed to ensure that performance, materials and services are obtained in an effective manner and in compliance with the provisions of applicable Federal statutes and executive orders. The awardee must obtain written approval from the cognizant NSF Grants and Agreements Officer prior to entering into a contract if the amount exceeds $250,000 or other amount specifically identified in the agreement. Contracts clearly identified in the NSF award budget are considered approved at the time of award unless approval is withheld by the Grants and Agreements Officer. Contracts must be clearly identified in the NSF award budget on Line G6. Other. The threshold noted above also applies to cumulative increases in the value of the contractual arrangement after initial NSF approval. The awardee must not artificially segregate its procurements to lesser dollar amounts for the purpose of circumventing this requirement. A request to enter into a contract must include, at a minimum:
Minimum Shipping Requirements for TIPS Sales Vendor shall ship, deliver, or provide ordered goods and services within a commercially reasonable time after acceptance of the order. If a delay in delivery is anticipated, Vendor shall notify the TIPS Member as to why delivery is delayed and provide an updated estimated time for completion. The TIPS Member may cancel the order if the delay is not commercially acceptable or not consistent with the Supplemental Agreement applicable to the order.
SPECIAL CONTRACT REQUIREMENTS The Special Contract Requirements are provisions that relate directly to the performance of this contract.
Management Requirements Procedures for managing equipment (including replacement equipment), whether acquired in whole or in part under a Federal award, until disposition takes place will, as a minimum, meet the following requirements:
Support Requirements If there is a dispute between the awarded vendor and TIPS Member, TIPS or its representatives may assist, at TIPS sole discretion, in conflict resolution or third party (mandatory mediation), if requested by either party. TIPS, or its representatives, reserves the right to inspect any project and audit the awarded vendors TIPS project files, documentation and correspondence. Status of TIPS Members as Related to This Agreement TIPS Members stand in the place of TIPS as related to this agreement and have the same access to the proposal information and all related documents. TIPS Members have all the same rights under the awarded Agreement as TIPS.
Procurement Requirements The below listed provisions of State Procurement requirements shall be complied with throughout the contract period:
Operating Requirements Any operating and technical requirements that may be applicable due to Regional Transmission Organization, Independent System Operator, control area, or the Connecting Transmission Owner’s requirements, including those set forth in the Small Generator Interconnection Agreement. Operating Requirements shall include Applicable Reliability Standards.
Subcontract Requirements As required by Section 6.22(e)(5) of the Administrative Code, Contractor shall insert in every subcontract or other arrangement, which it may make for the performance of Covered Services under this Agreement, a provision that said subcontractor shall pay to all persons performing labor in connection with Covered Services under said subcontract or other arrangement not less than the highest general prevailing rate of wages as fixed and determined by the Board of Supervisors for such labor or services.
Developer Operating Requirements (a) Developer must comply with all applicable NYISO tariffs and procedures, as amended from time to time.
