Aft Fuselage Section Sample Clauses

Aft Fuselage Section. This section includes the structural components located aft of the Center fuselage including the vertical stabilizer and horizontal stabilizer. This section will most likely be delivered in three sub assemblies, the Aft Fuselage, the Vertical Stabilizer, and the Horizontal Stabilizer. However, this may change as the engineering is finalized.
AutoNDA by SimpleDocs

Related to Aft Fuselage Section

  • Wage Scale The wages shown in Appendix A will be part of this Agreement.

  • Reg AB Item 1119 Affiliations and Relationships

  • Primary Frequency Response Developer shall ensure the primary frequency response capability of its Large Generating Facility by installing, maintaining, and operating a functioning governor or equivalent controls. The term “functioning governor or equivalent controls” as used herein shall mean the required hardware and/or software that provides frequency responsive real power control with the ability to sense changes in system frequency and autonomously adjust the Large Generating Facility’s real power output in accordance with the droop and deadband parameters and in the direction needed to correct frequency deviations. Developer is required to install a governor or equivalent controls with the capability of operating: (1) with a maximum 5 percent droop ± 0.036 Hz deadband; or (2) in accordance with the relevant droop, deadband, and timely and sustained response settings from an approved Applicable Reliability Standard providing for equivalent or more stringent parameters. The droop characteristic shall be: (1) based on the nameplate capacity of the Large Generating Facility, and shall be linear in the range of frequencies between 59 and 61 Hz that are outside of the deadband parameter; or (2) based on an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. The deadband parameter shall be: the range of frequencies above and below nominal (60 Hz) in which the governor or equivalent controls is not expected to adjust the Large Generating Facility’s real power output in response to frequency deviations. The deadband shall be implemented: (1) without a step to the droop curve, that is, once the frequency deviation exceeds the deadband parameter, the expected change in the Large Generating Facility’s real power output in response to frequency deviations shall start from zero and then increase (for under-frequency deviations) or decrease (for over-frequency deviations) linearly in proportion to the magnitude of the frequency deviation; or (2) in accordance with an approved Applicable Reliability Standard providing for an equivalent or more stringent parameter. Developer shall notify NYISO that the primary frequency response capability of the Large Generating Facility has been tested and confirmed during commissioning. Once Developer has synchronized the Large Generating Facility with the New York State Transmission System, Developer shall operate the Large Generating Facility consistent with the provisions specified in Articles 9.5.5.1 and 9.5.5.2 of this Agreement. The primary frequency response requirements contained herein shall apply to both synchronous and non-synchronous Large Generating Facilities.

  • Federal Funding Accountability and Transparency Act (FFATA Subrecipient shall comply with the requirements of 2 CFR part 25 Universal Identifier and System for Award Management (XXX). Subrecipient must have an active registration in XXX, xxxxx://xxx.xxx.gov/XXX/ in accordance with 2 CFR part 25, appendix A, and must have a Data Universal Numbering System (DUNS) number xxxxx://xxxxxx.xxx.xxx/webform/ Subrecipient must also comply with provisions of the Federal Funding Accountability and Transparency Act, which includes requirements on executive compensation, 2 CFR part 170 Reporting Subaward and Executive Compensation Information.

  • Reactive Power and Primary Frequency Response 9.6.1 Power Factor Design Criteria

  • SHIPPING AND AIR TRANSPORT 1. Profits of an enterprise of a Contracting State from the operation of ships or aircraft in international traffic shall be taxable only in that State. 2. The provisions of paragraph 1 shall also apply to profits from the participation in a pool, a joint business or an international operating agency.

  • Required Bonding Capacity Letter No response If proposing on Part 2, Vendor is required to upload a Bonding Capacity Letter from its surety, as described herein, at this location. Please see the attachment entitled "Instructions and Sample - Part 2 Required Bonding Capacity Letter" for complete instructions. . On Part 2, Vendor will be scored on the aggregate bonding capacity displayed in the accepted letter. Vendor must provide a current letter (issued on or after the first day of the month preceding the date on which the solicitation was posted) from its surety verifying Vendor’s bonding capacity as described herein. (Ex. if the solicitation/bid posted on February 4, 2022, the letter must be dated on or after January 1 2022. The letter must be issued from Vendor’s Surety companies, on surety company letterhead, must specify the maximum bonding capacity of the Vendor, and must be signed by an authorized representative of the surety company. The issuing surety must be authorized to do business in the State of Texas and must be listed on the Department of the Treasury's Listing of Approved Sureties (Department Circular 570).

  • Agency Response a. OGS will consider all information relevant to the Formal Dispute, and may, in its discretion, suspend, modify, or cancel the disputed procurement/Contract action prior to issuance of a Formal Dispute decision. b. OGS reserves the right to require the filer to meet or participate in a conference call with OGS to discuss the Formal Dispute when, in its sole judgment, circumstances so warrant. c. OGS reserves the right to waive or extend the time requirements for decisions and final determinations on appeals herein prescribed when, in its sole judgment, circumstances so warrant. d. OGS reserves the right to consider or reject the merits of any Formal Dispute.

  • Please see the current Washtenaw Community College catalog for up-to-date program requirements Conditions & Requirements

  • Wall Street Transparency and Accountability Act of 2010 The parties hereby agree that none of (i) Section 739 of the WSTAA, (ii) any similar legal certainty provision included in any legislation enacted, or rule or regulation promulgated, on or after the Trade Date, (iii) the enactment of the WSTAA or any regulation under the WSTAA, (iv) any requirement under the WSTAA or (v) any amendment made by the WSTAA shall limit or otherwise impair either party’s right to terminate, renegotiate, modify, amend or supplement this Confirmation or the Agreement, as applicable, arising from a termination event, force majeure, illegality, increased cost, regulatory change or similar event under this Confirmation, the Equity Definitions or the Agreement (including, but not limited to, any right arising from any Acceleration Event).

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!