Aircraft Air conditioning Sample Clauses

Aircraft Air conditioning. The Government shall supply portable 6000 BTU air conditioners. Spot Cool 50 HU or equivalent. The Government shall supply portable Xxxxxx XXX-0000 Model 6T28-600CL or equivalent. The offeror shall supply at least 6 connections for these units using a distribution box with an on/off switch that mates to a quick connect Hubble 460P7W 60 amp 3 phase connector. These connections shall be spaced so that all three heavies can use a portable A/C Unit and two light aircraft can use a portable Hobart GPUs can be connected to two light aircraft simultaneously when 2 light and 3 Heavies are in the Hangar.
AutoNDA by SimpleDocs

Related to Aircraft Air conditioning

  • Air Conditioning If the Apartment has been provided with a ledge for split air conditioning system with suitable provision for keeping outdoor units of the AC system and also the route to take refrigerant piping, which the Allottee shall have to strictly follow while installing AC units

  • Engine A. Any internal repairs or replacement of internal components, or replacement of engine assembly.

  • Private Aircraft Mileage When an employee is authorized by his/her department, reimbursement for the use of the employee’s privately owned aircraft on State business shall be made at the rate of 50 cents per statute mile. Pilot qualifications and insurance requirements will be maintained in accordance with DPA rule 599.628.1 and the State Office of Risk and Insurance Management.

  • Aircraft This peril includes self-propelled missiles and spacecraft.

  • Installation Services 3.1 The Bitstream 2a Service includes a Standard Install as set out below (in each case to the extent that the relevant provisioning works are not already complete for the relevant Service Order).1

  • Technical Specification As enumerated in Special Conditions of Contract/Scope of Work/attached Drawing/ Details/Schedule of Rates.

  • Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)

  • Interconnection Facilities Engineering Procurement and Construction Interconnection Facilities, Network Upgrades, and Distribution Upgrades shall be studied, designed, and constructed pursuant to Good Utility Practice. Such studies, design and construction shall be based on the assumed accuracy and completeness of all technical information received by the Participating TO and the CAISO from the Interconnection Customer associated with interconnecting the Large Generating Facility.

  • House and Riser Cable A two-wire metallic distribution facility in Verizon’s network between the minimum point of entry for a building where a premises of a Customer is located (such a point, an “MPOE”) and the Rate Demarcation Point for such facility (or NID) if the NID is located at such Rate Demarcation Point).

  • Installation Where installation is required, Contractor shall be responsible for placing and installing the product in the required locations at no additional charge, unless otherwise designated on the Contract or purchase order. Contractor’s authorized product and price list shall clearly and separately identify any additional installation charges. All materials used in the installation shall be of good quality and shall be free of defects that would diminish the appearance of the product or render it structurally or operationally unsound. Installation includes the furnishing of any equipment, rigging, and materials required to install or replace the product in the proper location. Contractor shall protect the site from damage and shall repair damages or injury caused during installation by Contractor or its employees or agents. If any alteration, dismantling, excavation, etc., is required to achieve installation, the Contractor shall promptly restore the structure or site to its original condition. Contractor shall perform installation work so as to cause the least inconvenience and interference with Customers and with proper consideration of others on site. Upon completion of the installation, the location and surrounding area of work shall be left clean and in a neat and unobstructed condition, with everything in satisfactory repair and order.

Time is Money Join Law Insider Premium to draft better contracts faster.