TYPES OF CONTRACT MODIFICATIONS In order to expedite processing of a contract modification, where proposed changes involve more than one category below, each change should be submitted to OGS as a separate request.
OGS Centralized Contract Modifications OGS, an Authorized User, or the Contractor may suggest modifications to the Centralized Contract or its Appendices. Except as specifically provided herein, modifications to the terms and conditions set forth herein may only be made with mutual written agreement of the Parties. Modifications may take the form of an update or an amendment. “
CENTRALIZED CONTRACT MODIFICATIONS A. OGS, an Authorized User, or the Contractor may suggest modifications to the Centralized Contract or its Appendices. Except as specifically provided herein, modifications to the terms and conditions set forth herein may only be made with mutual written agreement of the Parties. Modifications may take the form of an update or an amendment. “
INTEGRATIONS & MODIFICATIONS This Agreement constitutes the whole agreement between the parties. Except as identified in this Agreement, there are no other prior written agreements and no prior or contemporaneous oral agreements that are a part of this Agreement. No modification to this Agreement shall be valid, unless in writing and executed by both parties.
Budget Modifications The total Approved Budget and the assignment of costs may be adjusted based on implementation of the Scope of Work, spending patterns, and unexpended funds, but only by an amendment to the Approved Budget. In no event shall an amendment to the Approved Budget result in payments in excess of the aggregate amount specified in Section 2.01 “Award of Monies” or in approved supplemental funding for the Project, if any. The RECIPIENT may make transfers between or among lines within budget categories without prior written approval provided that:
Cost Modifications The parties may agree to a reduction in the cost of the Contract at any time during which the Contract is in effect. Without intending to impose a limitation on the nature of the reduction, the reduction may be to hourly, staffing or unit costs, the total cost of the Contract or the reduction may take such other form as the State deems to be necessary or appropriate.
Contract Modifications It is understood that changes are inherent in operations of the type covered by this contract. The number of changes, the scope of those changes, and the impact they have on the progress of the original operations cannot be defined at this time. The PURCHASER is notified that changes are anticipated and that there will be no compensation made to the PURCHASER directly related to the number of changes made. Each change will be evaluated for extension of contract time and increase or decrease in compensation based on its own merit. STATE reserves the right to make, at any time during the contract, such modifications as are necessary or desirable; provided such modifications shall not change the character of the operations to be done nor increase the cost, unless such operations or cost increase is approved in writing by PURCHASER. Any modifications so made shall not invalidate this contract nor release PURCHASER of obligations under the performance bond. PURCHASER agrees to do the modified operations as if it had been a part of the original contract. If any change under this section causes an increase or decrease in the PURCHASER's cost of, or the time required for the performance of any part of the operations, the PURCHASER must submit a written statement setting forth the nature and specific extent of the claim. Such claim shall include all time and cost impacts against the contract and be submitted as soon as possible, but no later than 30 days after receipt of any written notice of modification of the contract. If the PURCHASER discovers site conditions which differ materially from what was represented in the contract or from conditions that would normally be expected to exist and be inherent to the activities defined in the contract, the PURCHASER shall notify the STATE's Authorized Representative immediately and before the area has been disturbed. The STATE's Authorized Representative will investigate the area and make a determination as to whether or not the conditions differ materially from either the conditions stated in the contract or those which could reasonably be expected in execution of this particular contract. If it is determined that a differing site condition exists, any compensation or credit will be determined based on an analysis by STATE's Authorized Representative. If the PURCHASER does not concur with the decision of the STATE's Authorized Representative and/or believes that it is entitled to additional compensation, the PURCHASER may proceed to file a claim. Claims Review Process. All PURCHASER claims shall be referred to the STATE's Authorized Representative for review. All claims shall be made in writing to the STATE's Authorized Representative not more than ten days from the date of the occurrence of the event which gives rise to the claim or not more than ten days from the date that the PURCHASER knew or should have known of the problem. Unless the claim is made in accordance with these time requirements, it shall be waived. All claims shall be submitted in writing and shall include a detailed, factual statement of the basis of the claim, pertinent dates, contract provisions which support or allow the claim, reference to or copies of any documents which support the claim, the exact dollar value of the claim, and specific time extension requested for the claim. If the claim involves operations to be completed by subcontractors, the PURCHASER will analyze and evaluate the merits of the subcontractor's claim. PURCHASER shall forward the subcontractor's claim and PURCHASER's evaluation of such claim to STATE's Authorized Representative. The STATE's Authorized Representative will not consider direct claims from subcontractors, suppliers, manufacturers, or others not a party to this contract. The decision of the STATE shall be final and binding unless the PURCHASER requests mediation.
Modifications/Add-ons 6.3.1 Licensee shall comply with SAP’s registration procedure prior to making Modifications or Add-ons. All Modifications and all rights associated therewith shall be the exclusive property of SAP, SAP Parent or its or their licensors. All Add-ons developed by SAP (either independently or jointly with Licensee) and all rights associated therewith shall be the exclusive property of SAP, SAP Parent or its or their licensors. Licensee agrees to execute those documents reasonably necessary to secure SAP’s rights in the foregoing Modifications and Add-ons. All Add-ons developed by or on behalf of Licensee without SAP’s participation (“Licensee Add-on”), and all rights associated therewith, shall be the exclusive property of Licensee subject to SAP’s rights in and to the Software and SAP Materials; provided, Licensee shall not commercialize, market, distribute, license, sublicense, transfer, assign or otherwise alienate any such Licensee Add-ons. SAP retains the right to independently develop its own Modifications or Add-ons to the Software, and Licensee agrees not to take any action that would limit SAP’s sale, assignment, licensing or use of its own Software or Modifications or Add-ons thereto.
Drawings Submitted During the Contract Term Where required to develop maintain and deliver diagrams or other technical schematics regarding the scope of work, Contractor shall do so on an ongoing basis at no additional charge, and must, as a condition of payment, update drawings and plans during the Contract term to reflect additions, alterations, and deletions. Such drawings and diagrams shall be delivered to the Authorized User’s representative.
Unbundled Loop Modifications (Line Conditioning 2.5.1 Line Conditioning is defined as routine network modification that BellSouth regularly undertakes to provide xDSL services to its own customers. This may include the removal of any device, from a copper Loop or copper Sub-loop that may diminish the capability of the Loop or Sub-loop to deliver high-speed switched wireline telecommunications capability, including xDSL service. Such devices include, but are not limited to, load coils, excessive bridged taps, low pass filters, and range extenders. Excessive bridged taps are bridged taps that serves no network design purpose and that are beyond the limits set according to industry standards and/or the XxxxXxxxx XX 00000.