Certificate Holder Maintenance Responsibility Sample Clauses

Certificate Holder Maintenance Responsibility. Throughout the process of evaluating an arrangement for the performance of maintenance, it is important to remember that the certificate holder is responsible for the performance and the quality of the maintenance, and cannot delegate this responsibility (refer to §§ 121.363 and 135.413). The maintenance provider’s organization becomes, in effect, an extension of the certificate holder’s maintenance organization. The certificate holder’s contract maintenance program that documents the nature of the arrangement between the certificate holder and the maintenance provider should demonstrate that the certificate holder retains the responsibility and the authority to decide what to do, when to do it, and how to do it. Additionally, §§ 121.368 and 135.426 require that:
AutoNDA by SimpleDocs

Related to Certificate Holder Maintenance Responsibility

  • Maintenance Responsibilities 42. Agency shall, at its own expense, maintain operate, and provide power as needed upon Project completion at a minimum level that is consistent with normal depreciation and/or service demand and throughout the useful life of the Project. The useful life of the Project is defined in the Special Provisions. State may conduct periodic inspections during the life of the Project to verify that the Project is properly maintained and continues to serve the purpose for which federal funds were provided. Maintenance and power responsibilities shall survive any termination of the Project Agreement. In the event the Project will include or affect a state highway, this provision does not address maintenance of that state highway.

  • Certification Regarding Responsibility Matters This provision applies to solicitations where the contract value is expected to exceed the simplified acquisition threshold.

  • Joint Responsibility If the Seller determines that the Interface Problem is attributable partially to the design of a Warranted Part and partially to the design of any Supplier Part, the Seller will, if so requested by the Buyer, seek a solution to the Interface Problem through cooperative efforts of the Seller and any Supplier involved. The Seller will promptly advise the Buyer of such corrective action as may be proposed by the Seller and any such Supplier. Such proposal will be consistent with any then existing obligations of the Seller hereunder and of any such Supplier towards the Buyer. Such corrective action, unless reasonably rejected by the Buyer, will constitute full satisfaction of any claim the Buyer may have against either the Seller or any such Supplier with respect to such Interface Problem.

  • Certification Regarding Debarment, Suspension, and Other Responsibility Matters – Primary Covered Transactions The Firm certifies to the best of its knowledge and belief, that it and its principals:

  • Certification Regarding Debarment, Suspension, and Other Responsibility Matters Primary Covered Transactions

  • Management Responsibility No Limited Partner, as such, shall take part in the management of the business or transact any business for the Partnership.

  • Joint Responsibilities 2.1.1 University and Affiliate each will identify, and notify each other of, a person responsible for serving as its liaison during the course of this affiliation. The appointment of liaisons shall be subject to mutual approval of the parties.

  • Payment Responsibility The payment obligations of each Participating Manufacturer pursuant to this Agreement shall be the several responsibility only of that Participating Manufacturer. The payment obligations of a Participating Manufacturer shall not be the obligation or responsibility of any Affiliate of such Participating Manufacturer. The payment obligations of a Participating Manufacturer shall not be the obligation or responsibility of any other Participating Manufacturer. Provided, however, that no provision of this Agreement shall waive or excuse liability under any state or federal fraudulent conveyance or fraudulent transfer law. Any Participating Manufacturer whose Market Share (or Relative Market Share) in any given year equals zero shall have no payment obligations under this Agreement in the succeeding year.

  • Repair Responsibility Builder will repair only cracks exceeding 1/8 inch in width, one time only, during the first year of the Limited Warranty period.

  • Escrow Agent Not Responsible for Furnished Information The Escrow Agent will have no responsibility for seeking, obtaining, compiling, preparing or determining the accuracy of any information or document, including the representative capacity in which a party purports to act, that the Escrow Agent receives as a condition to a release from escrow or a transfer of escrow securities within escrow under this Agreement.

Time is Money Join Law Insider Premium to draft better contracts faster.