Conclusiveness of Measurements Sample Clauses

Conclusiveness of Measurements. Quantity and temperature measurements made by the independent inspector as provided in this Article 23 shall be final and binding on the parties, except in the case of manifest error. In any event, without prejudice to the right of either party subsequently to demonstrate manifest error in such measurements, the determination of the independent inspector shall govern for purposes of the quantity stated in the xxxx of lading and the obligation of Buyer to make payment in accordance with the provisions of Article 11.
AutoNDA by SimpleDocs
Conclusiveness of Measurements. 58 ARTICLE 24 QUALITY.................................. 58

Related to Conclusiveness of Measurements

  • Measuring DNS parameters Every minute, every DNS probe will make an UDP or TCP “DNS test” to each of the public-­‐DNS registered “IP addresses” of the name servers of the domain name being monitored. If a “DNS test” result is undefined/unanswered, the tested IP will be considered unavailable from that probe until it is time to make a new test.

  • Usage Measurement Usage measurement for calls shall begin when answer supervision or equivalent Signaling System 7 (SS7) message is received from the terminating office and shall end at the time of call disconnect by the calling or called subscriber, whichever occurs first.

  • Conclusiveness of Statements; Survival of Provisions Determinations and statements of any Lender pursuant to Sections 8.1, 8.2, 8.3 or 8.4 shall be conclusive absent demonstrable error. Lenders may use reasonable averaging and attribution methods in determining compensation under Sections 8.1 and 8.4, and the provisions of such Sections shall survive repayment of the Obligations, cancellation of any Notes, expiration or termination of the Letters of Credit and termination of this Agreement.

  • Measurements and arithmetic conventions All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down.

  • Temperature Measurement Temperature will be measured by the nearest automatic Melbourne Bureau of Meteorology Monitoring Station for example (but not limited to): Melbourne, Moorabbin, Dunns Hill, Melbourne Airport, Frankston, and Point Xxxxxx. At the commencement of each project, the onsite management and employee representatives shall agree which is to be the applicable automatic weather monitoring station.

  • Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.

  • Covenants of Performance Measurement No interference. Registry Operator shall not interfere with measurement Probes, including any form of preferential treatment of the requests for the monitored services. Registry Operator shall respond to the measurement tests described in this Specification as it would to any other request from an Internet user (for DNS and RDDS) or registrar (for EPP). ICANN testing registrar. Registry Operator agrees that ICANN will have a testing registrar used for purposes of measuring the SLRs described above. Registry Operator agrees to not provide any differentiated treatment for the testing registrar other than no billing of the transactions. ICANN shall not use the registrar for registering domain names (or other registry objects) for itself or others, except for the purposes of verifying contractual compliance with the conditions described in this Agreement. PUBLIC INTEREST COMMITMENTS Registry Operator will use only ICANN accredited registrars that are party to the Registrar Accreditation Agreement approved by the ICANN Board of Directors on 27 June 2013 in registering domain names. A list of such registrars shall be maintained by ICANN on ICANN’s website. (Intentionally omitted. Registry Operator has not included commitments, statements of intent or business plans provided for in its application to ICANN for the TLD.) Registry Operator agrees to perform the following specific public interest commitments, which commitments shall be enforceable by ICANN and through the Public Interest Commitment Dispute Resolution Process established by ICANN (posted at xxxx://xxx.xxxxx.xxx/en/resources/registries/picdrp), which may be revised in immaterial respects by ICANN from time to time (the “PICDRP”). Registry Operator shall comply with the PICDRP. Registry Operator agrees to implement and adhere to any remedies ICANN imposes (which may include any reasonable remedy, including for the avoidance of doubt, the termination of the Registry Agreement pursuant to Section 4.3(e) of the Agreement) following a determination by any PICDRP panel and to be bound by any such determination. Registry Operator will include a provision in its Registry-Registrar Agreement that requires Registrars to include in their Registration Agreements a provision prohibiting Registered Name Holders from distributing malware, abusively operating botnets, phishing, piracy, trademark or copyright infringement, fraudulent or deceptive practices, counterfeiting or otherwise engaging in activity contrary to applicable law, and providing (consistent with applicable law and any related procedures) consequences for such activities including suspension of the domain name. Registry Operator will periodically conduct a technical analysis to assess whether domains in the TLD are being used to perpetrate security threats, such as pharming, phishing, malware, and botnets. Registry Operator will maintain statistical reports on the number of security threats identified and the actions taken as a result of the periodic security checks. Registry Operator will maintain these reports for the term of the Agreement unless a shorter period is required by law or approved by ICANN, and will provide them to ICANN upon request. Registry Operator will operate the TLD in a transparent manner consistent with general principles of openness and non-discrimination by establishing, publishing and adhering to clear registration policies.

  • Measuring EPP parameters Every 5 minutes, EPP probes will select one “IP address” of the EPP servers of the TLD being monitored and make an “EPP test”; every time they should alternate between the 3 different types of commands and between the commands inside each category. If an “EPP test” result is undefined/unanswered, the EPP service will be considered as unavailable from that probe until it is time to make a new test.

  • Effectiveness of Covenants (a) After the Issue Date, following the first day: (i) the Notes have an Investment Grade Rating from both of the Ratings Agencies; and (ii) no Default has occurred and is continuing under this Indenture; the Company and its Restricted Subsidiaries will not be subject to Sections 4.10, 4.11, 4.13, 4.14, 4.16 and 5.01(a)(ii) of this Indenture (collectively, the “Suspended Covenants”). (b) If at any time the Notes’ credit rating is downgraded from an Investment Grade Rating by any Rating Agency, then the Suspended Covenants will thereafter be reinstated as if such covenants had never been suspended (the “Reinstatement Date”) and be applicable pursuant to the terms of this Indenture (including in connection with performing any calculation or assessment to determine compliance with the terms of this Indenture), unless and until the Notes subsequently attain an Investment Grade Rating and no Default or Event of Default is in existence (in which event the Suspended Covenants shall no longer be in effect for such time that the Notes maintain an Investment Grade Rating); provided, however, that no Default, Event of Default or breach of any kind shall be deemed to exist or have occurred under this Indenture, the Notes or the Guarantees with respect to the Suspended Covenants based on, and none of the Company or any of its Subsidiaries shall bear any liability for, any actions taken or events occurring during the Suspension Period or any actions taken at any time pursuant to any contractual obligation arising prior to the Reinstatement Date, regardless of whether such actions or events would have been permitted if the applicable Suspended Covenants remained in effect during such period. The period of time between the date of suspension of the covenants and the Reinstatement Date is referred to as the “Suspension Period.” (c) On the Reinstatement Date, all Indebtedness Incurred during the Suspension Period will be deemed to have been outstanding on the Issue Date, so that it is classified as permitted under clause (iii) of the definition of “Permitted Indebtedness”. Calculations made after the Reinstatement Date of the amount available to be made as Restricted Payments under Section 4.11 will be made as though Section 4.11 had been in effect since the Issue Date and throughout the Suspension Period. Accordingly, Restricted Payments made during the Suspension Period will reduce the amount available to be made as Restricted Payments under the first paragraph of Section 4.11 to the extent such Restricted Payments were not otherwise permitted to be made pursuant to clauses (i) through (ix) of the third paragraph of Section 4.11, provided that the amount available to be made as Restricted Payments on the Reinstatement Date pursuant to the first paragraph of Section 4.11 shall not be reduced below zero solely as a result of such Restricted Payments under Section 4.11. Additionally, upon any Reinstatement Date, the amount of Available Asset Sale Proceeds will be reset to zero. (d) During any period when the Suspended Covenants are suspended, the Board of Directors of the Company may not designate any of the Company’s Subsidiaries as Unrestricted Subsidiaries pursuant to this Indenture. The Company shall give the Trustee prompt written notification of the beginning of any Suspension Period or any Reinstatement Date.

  • Measurements Units set out in SI (metric) are the governing units for the purposes of this Contract. Units set out in Imperial measurement in parentheses beside their SI (metric) equivalent are for reference only and in the event of a conflict between SI (metric) and Imperial measurement herein, SI (metric) shall prevail.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!