Measurements and arithmetic conventions. All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down.
Measurements and arithmetic conventions. 1.3.1 All measurements and calculations shall be in metric system and calculations done in 2 decimals places, with the third digit of 5 or above rounded up and below 5 belong down except in Fee calculation which shall be rounded off to nearest Indian Rupee Hundred (100).
Measurements and arithmetic conventions. All measurements and calculations shall be in the metric system and calculations done to two
Measurements and arithmetic conventions. 1.4.1 All measurements and calculations shall be in the metric system and calculations done to two (2) decimal places, with the third digit of five (5) or above being rounded up and below five (5) being rounded down, however all calculations in respect of technical matters shall be in SI/foot pound and second system in accordance with the provision of the Schedule G (Detailed Project Report).
Measurements and arithmetic conventions. All measurements and calculations shall be in metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down. Ambiguities and Discrepancies In case of ambiguities or discrepancies within this Contract, the following shall apply: between two Article of this Contract, the provisions of specific Articles relevant to the issue under consideration shall prevail over those in other Articles; between any value written in numerals and that in words, the latter shall prevail; and between the provisions of this Contract and any other documents forming part of it, the former shall prevail.
Measurements and arithmetic conventions. All measurements and calculations shall be in metric system and calculations done to 2 decimal places, with the third digit of 5 or above being rounded up and below 5 being rounded down. Ambiguities and Discrepancies In case of ambiguities or discrepancies within this Agreement, the following shall apply:
Measurements and arithmetic conventions. All measurements and calculations shall be in the metric system and calculations done to 2 (two) decimal places, with the third digit of 5 (five) or above being rounded up and below 5 (five) being rounded down. The financial figures shall be calculated and rounded off to 50 (fifty) paise with third digit of 5 (five) or above being rounded up and digits below 5 (five) being rounded down.
Measurements and arithmetic conventions. 1.3.1. All measurements and calculations shall be in metric system and calculations done in 2 decimals places, with the third digit of 5 or above rounded up and below 5 rounded down except in Annual lease rental, calculation which shall be rounded off to nearest Rupee Hundred (100).
Measurements and arithmetic conventions. All measurements and cal culations shall be in metric system and calculations done to 2 decimal places, with the third digit of 5 or above being rounded up and below 5 being rounded down.
Measurements and arithmetic conventions. All measurements and calculations shall be in metric system and calculations done to 2 decimal places, with the third digit of 5 or above being rounded up and below 5 being rounded down. Ambiguities and Discrepancies In case of ambiguities or discrepancies within this Agreement, the following shall apply: between two Articles of this Agreement, the provisions of specific Articles relevant to the issue under consideration shall prevail over those in other Articles; between the dimension scaled from the Design and Drawings and its specific written dimension, the latter shall prevail; between any value written in numerals and that in words, the latter shall prevail; and between the provisions of this Agreement and any other documents forming part of this Agreement, the former shall prevail.
