Buyer’s Knowledge of Loading Port Facilities; Standard Procedures Sample Clauses

Buyer’s Knowledge of Loading Port Facilities; Standard Procedures. 13.4.1 Buyer hereby acknowledges that it is fully familiar with the facilities and conditions at the Loading Ports, including the loading conditions and procedures and the facilities for the storage and delivery of the Oil. The facilities and conditions at the Loading Ports may be changed at any time. Buyer also acknowledges that standard procedures in effect at the Loading Ports from time to time relating, inter alia, to quality and quantity measurements, safety in loading, and inspection of vessel tanks, shall supplement (but not conflict with) the procedures specified herein. Seller shall supply Buyer with a copy of such procedures upon Buyer’s request. 13.4.2 Seller makes no representations, express or implied, concerning navigational conditions in public channels or waterways to be utilized by the tanker in order to reach or depart the loading point which may require the exercise of special precautions or safety measures; it being understood that the operator of the tanker shall be responsible for making a thorough check of any navigational conditions as are likely to exist at the approaches of the Loading Port about the time of its arrival so as to prevent and avoid any hazards or controllable risks.
AutoNDA by SimpleDocs

Related to Buyer’s Knowledge of Loading Port Facilities; Standard Procedures

  • Violence Policies and Procedures The Employer agrees to have in place explicit policies and procedures to deal with violence. The policy will address the prevention of violence, the management of violent situations, provision of legal counsel and support to employees who have faced violence. The policies and procedures shall be part of the employee's health and safety policy and written copies shall be provided to each employee. Prior to implementing any changes to these policies, the employer agrees to consult with the Association.

  • Sub-Advisor Compliance Policies and Procedures The Sub-Advisor shall promptly provide the Trust CCO with copies of: (i) the Sub-Advisor’s policies and procedures for compliance by the Sub-Advisor with the Federal Securities Laws (together, the “Sub-Advisor Compliance Procedures”), and (ii) any material changes to the Sub-Advisor Compliance Procedures. The Sub-Advisor shall cooperate fully with the Trust CCO so as to facilitate the Trust CCO’s performance of the Trust CCO’s responsibilities under Rule 38a-1 to review, evaluate and report to the Trust’s Board of Trustees on the operation of the Sub-Advisor Compliance Procedures, and shall promptly report to the Trust CCO any Material Compliance Matter arising under the Sub-Advisor Compliance Procedures involving the Sub-Advisor Assets. The Sub-Advisor shall provide to the Trust CCO: (i) quarterly reports confirming the Sub-Advisor’s compliance with the Sub-Advisor Compliance Procedures in managing the Sub-Advisor Assets, and (ii) certifications that there were no Material Compliance Matters involving the Sub-Advisor that arose under the Sub-Advisor Compliance Procedures that affected the Sub-Advisor Assets. At least annually, the Sub-Advisor shall provide a certification to the Trust CCO to the effect that the Sub-Advisor has in place and has implemented policies and procedures that are reasonably designed to ensure compliance by the Sub-Advisor with the Federal Securities Laws.

  • Compliance Policies and Procedures To assist the Fund in complying with Rule 38a-1 of the 1940 Act, BBH&Co. represents that it has adopted written policies and procedures reasonably designed to prevent violation of the federal securities laws in fulfilling its obligations under the Agreement and that it has in place a compliance program to monitor its compliance with those policies and procedures. BBH&Co will upon request provide the Fund with information about our compliance program as mutually agreed.

  • COMPLIANCE WITH GOVERNMENTAL RULES AND REGULATIONS; RECORDS The Trust assumes full responsibility for its compliance with all securities, tax, commodities and other laws, rules and regulations applicable to it.

  • Proposed Policies and Procedures Regarding New Online Content and Functionality By October 31, 2017, the School will submit to OCR for its review and approval proposed policies and procedures (“the Plan for New Content”) to ensure that all new, newly-added, or modified online content and functionality will be accessible to people with disabilities as measured by conformance to the Benchmarks for Measuring Accessibility set forth above, except where doing so would impose a fundamental alteration or undue burden. a) When fundamental alteration or undue burden defenses apply, the Plan for New Content will require the School to provide equally effective alternative access. The Plan for New Content will require the School, in providing equally effective alternate access, to take any actions that do not result in a fundamental alteration or undue financial and administrative burdens, but nevertheless ensure that, to the maximum extent possible, individuals with disabilities receive the same benefits or services as their nondisabled peers. To provide equally effective alternate access, alternates are not required to produce the identical result or level of achievement for persons with and without disabilities, but must afford persons with disabilities equal opportunity to obtain the same result, to gain the same benefit, or to reach the same level of achievement, in the most integrated setting appropriate to the person’s needs. b) The Plan for New Content must include sufficient quality assurance procedures, backed by adequate personnel and financial resources, for full implementation. This provision also applies to the School’s online content and functionality developed by, maintained by, or offered through a third-party vendor or by using open sources. c) Within thirty (30) days of receiving OCR’s approval of the Plan for New Content, the School will officially adopt, and fully implement the amended policies and procedures.

  • Policies and Procedures i) The policies and procedures of the designated employer apply to the employee while working at both sites. ii) Only the designated employer shall have exclusive authority over the employee in regard to discipline, reporting to the College of Nurses of Ontario and/or investigations of family/resident complaints. iii) The designated employer will ensure that the employee is covered by WSIB at all times, regardless of worksite, while in the employ of either home. iv) The designated employer will ensure that the employee is covered by liability insurance at all times, regardless of worksite, while in the employ of either home. v) The designated employer shall have exclusive authority over the employee’s personnel files and health records. These files will be maintained on the site of the designated employer.

  • TECHNOLOGY/KNOWLEDGE TRANSFER ACTIVITIES The goal of this task is to develop a plan to make the knowledge gained, experimental results, and lessons learned available to the public and key decision makers. • Prepare an Initial Fact Sheet at start of the project that describes the project. Use the format provided by the CAM. • Prepare a Final Project Fact Sheet at the project’s conclusion that discusses results. Use the format provided by the CAM. • Prepare a Technology/Knowledge Transfer Plan that includes: o An explanation of how the knowledge gained from the project will be made available to the public, including the targeted market sector and potential outreach to end users, utilities, regulatory agencies, and others. o A description of the intended use(s) for and users of the project results. o Published documents, including date, title, and periodical name. o Copies of documents, fact sheets, journal articles, press releases, and other documents prepared for public dissemination. These documents must include the Legal Notice required in the terms and conditions. Indicate where and when the documents were disseminated. o A discussion of policy development. State if project has been or will be cited in government policy publications, or used to inform regulatory bodies. o The number of website downloads or public requests for project results. o Additional areas as determined by the CAM. • Conduct technology transfer activities in accordance with the Technology/Knowledge Transfer Plan. These activities will be reported in the Progress Reports. • When directed by the CAM, develop Presentation Materials for an Energy Commission- sponsored conference/workshop(s) on the project. • When directed by the CAM, participate in annual EPIC symposium(s) sponsored by the California Energy Commission. • Provide at least (6) six High Quality Digital Photographs (minimum resolution of 1300x500 pixels in landscape ratio) of pre and post technology installation at the project sites or related project photographs. • Prepare a Technology/Knowledge Transfer Report on technology transfer activities conducted during the project. • Initial Fact Sheet (draft and final) • Final Project Fact Sheet (draft and final) • Presentation Materials (draft and final) • High Quality Digital Photographs • Technology/Knowledge Transfer Plan (draft and final) • Technology/Knowledge Transfer Report (draft and final)

  • Policy and Procedures If the resident leaves the facility due to hospitalization or a therapeutic leave, the facility shall not be obligated to hold the resident’s bed available until his or her return, unless prior arrangements have been made for a bed hold pursuant to the facility’s “Bed Reservation Policy and Procedure” and pursuant to applicable law. In the absence of a bed hold, the resident is not guaranteed readmission unless the resident is eligible for Medicaid and requires the services provided by the facility. However, the resident may be placed in any appropriate bed in a semi-private room in the facility at the time of his or her return from hospitalization or therapeutic leave provided a bed is available and the resident’s admission is appropriate and meets the readmission requirements of the facility.

  • Ordering Guidelines and Processes 1.13.1 For information regarding Ordering Guidelines and Processes for various Network Elements, Combinations and Other Services, PLI should refer to the “Guides” section of the BellSouth Interconnection Web site, which is incorporated herein by reference, as amended from time to time. The Web site address is: http//xxx.xxxxxxxxxxxxxxx.xxxxxxxxx.xxx/. 1.13.2 Additional information may also be found in the individual CLEC Information Packages, which are incorporated herein by reference, as amended from time to time, located at the “CLEC UNE Products” Web site address: xxxx://xxx.xxxxxxxxxxxxxxx.xxxxxxxxx.xxx/guides/html/unes.html. 1.13.3 The provisioning of Network Elements, Combinations and Other Services to PLI’s Collocation Space will require cross-connections within the central office to connect the Network Element, Combinations or Other Services to the demarcation point associated with PLI’s Collocation Space. These cross-connects are separate components that are not considered a part of the Network Element, Combinations or Other Services and, thus, have a separate charge pursuant to this Agreement.

  • COMPLIANCE WITH POLICIES AND PROCEDURES During the period that Executive is employed with the Company hereunder, Executive shall adhere to the policies and standards of professionalism set forth in the policies and procedures of the Company and IAC as they may exist from time to time.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!