Permanent Transfers A. When it is determined by the Employer that a vacancy exists in a classification for which there are excessive employees located in an institution or in counties other than the headquarters county of the vacant position, then the permanent transfer vacancy posting process may be utilized. In this case, only employees in the same classification as the posted vacancy located in the declared areas of excess shall be eligible to apply for the vacancy. Applications shall be listed according to those in the same classification who possess and are proficient in the minimum qualifications of the classification specification and position description of the posted position in descending order of the most senior to the least senior. The applicant who possesses and is proficient in the minimum qualifications of the classification specification and position description and has the most seniority shall be selected.
B. The successful applicant(s) for all permanent transfers shall serve a trial period equivalent to one-half (1/2) the probationary period that corresponds to the classification of the vacancy as listed in Section 6.01. During this trial period, the Employer maintains the right to place the employee back in the previous site prior to the transfer if the employee fails to perform the job requirement of the new position to the Employer’s satisfaction.
C. Each Agency will identify the areas deemed to be in excess and will notify the Union of excesses as soon as practicable. Notices to the Union of a layoff or job abolishment shall be considered adequate notice of an excess. Each Agency, with the Office of Collective Bargaining’s approval, may negotiate with the Union to establish a procedure for the permanent transfer of positions and personnel.
Concurrent Transactions All documents or other deliveries required to be made by Purchaser or Seller at Closing, and all transactions required to be consummated concurrently with Closing, shall be deemed to have been delivered and to have been consummated simultaneously with all other transactions and all other deliveries, and no delivery shall be deemed to have been made, and no transaction shall be deemed to have been consummated, until all deliveries required by Purchaser and Seller shall have been made, and all concurrent or other transactions shall have been consummated.
Subsequent Transfers (a) Subject to the satisfaction of the conditions set forth in paragraph (b) below and pursuant to the terms of each Subsequent Transfer Agreement, in consideration of the Trustee’s delivery, on behalf of the Trust, on the related Subsequent Transfer Date to or upon the order of the Seller of the purchase price therefor, the Seller shall on any Subsequent Transfer Date sell, transfer, assign, set over and otherwise convey without recourse to the Depositor and the Depositor shall sell, transfer, assign, set over and otherwise convey without recourse to the Trust, all right, title and interest of the Seller and Depositor, as applicable, in and to each Subsequent Mortgage Loan transferred pursuant to such Subsequent Transfer Agreement, including (i) the related Principal Balance as of the related Cut-Off Date after giving effect to payments of principal due on or before the Cut-Off Date; (ii) all collections in respect of interest and principal received after the related Cut-Off Date (other than principal and interest due on or before such Cut-off Date); (iii) property which secured such Subsequent Mortgage Loan and which has been acquired by foreclosure or deed in lieu of foreclosure; (iv) its interest in any insurance policies in respect of such Subsequent Mortgage Loan; and (v) all proceeds of any of the foregoing. The transfer by the Seller to the Depositor and by the Depositor to the Trust of the Subsequent Mortgage Loans set forth on the Subsequent Mortgage Loan Schedule shall be absolute and shall be intended by the Seller, the Depositor and all parties hereto to be treated as a sale by the Seller to the Depositor and as a sale by the Depositor to the Trust. If the assignment and transfer of the Mortgage Loans and the other property specified in this Section 2.13 from the Seller to the Depositor and by the Depositor to the Trust pursuant to this Agreement is held or deemed not to be a sale or is held or deemed to be a pledge of security for a loan, both the Seller and the Depositor intend that the rights and obligations of the parties shall be established pursuant to the terms of this Agreement and that, in such event, (i) the Seller shall be deemed to have granted and does hereby grant to the Depositor and the Depositor shall be deemed to have granted and does hereby grant to the Trust as of such Subsequent Transfer Date a first priority security interest in the entire right, title and interest of the Seller and of the Depositor in and to the Subsequent Mortgage Loans and all other property conveyed to the Trust pursuant to this Section 2.13 and all proceeds thereof and (ii) this Agreement shall constitute a security agreement under applicable law. The purchase price shall be one hundred percent (100%) of the Principal Balances of the Subsequent Mortgage Loans as of the related Cut-Off Date. On or before each Subsequent Transfer Date, the Seller shall deliver to, and deposit with the Trustee or the Custodian on behalf of the Trustee, the Related Documents with respect to each Subsequent Mortgage Loan transferred on such Subsequent Transfer Date, and the related Subsequent Mortgage Loan Schedule in computer readable format with respect to such Subsequent Mortgage Loans.
(b) The Seller shall transfer and deliver to the Trustee or the Custodian on behalf of the Trustee the Subsequent Mortgage Loans and the other property and rights related thereto described in paragraph (a) of this Section 2.13 only upon the satisfaction of each of the following conditions on or prior to the applicable Subsequent Transfer Date:
(i) The Seller and the Depositor shall have provided the Servicer, the Trustee and the Rating Agencies with an Addition Notice, which notice shall be given not less than two Business Days prior to the applicable Subsequent Transfer Date and shall designate the Subsequent Mortgage Loans to be sold to the Trust and the aggregate Principal Balance of such Mortgage Loans and the Rating Agencies shall have informed the Seller, the Depositor or the Trustee prior to the applicable Subsequent Transfer Date that the inclusion of such Subsequent Mortgage Loans will not result in the downgrade or withdrawal of the ratings assigned to the Offered Certificates;
(ii) The Seller and the Depositor shall have delivered to the Trustee and the Servicer a duly executed Subsequent Transfer Agreement in substantially the form of Exhibit D;
(iii) The Seller shall have delivered to the Servicer for deposit in the Collection Account all principal collected and interest collected to the extent accrued and due after the related Cut-off Date;
(iv) As of each Subsequent Transfer Date, neither the Seller nor the Depositor was insolvent, neither the Seller nor the Depositor will be made insolvent by such transfer and neither the Seller nor the Depositor is aware of any pending insolvency;
(v) Such addition will not result in a material adverse tax consequence to any REMIC or the Holders of the Certificates;
(vi) The Funding Period shall not have terminated;
(vii) The Seller and the Depositor shall have provided the Trustee and the Rating Agencies with an Opinion of Counsel relating to the sale (i.e., “True Sale Opinion”) of the Subsequent Mortgage Loans to the Trustee, the enforceability of the Subsequent Transfer Agreement and to the effect that the transfer of such Subsequent Mortgage Loans will not adversely affect the status of any REMIC as a REMIC, which matters may be covered in the opinions delivered on the Closing Date;
(viii) The aggregate Principal Balance of Subsequent Mortgage Loans does not exceed the Original Pre-Funded Amount;
(ix) The conditions specified in Exhibit S hereto shall be met; and
(x) On the last Subsequent Transfer Date, the Trustee shall have received an accountant’s letter confirming that the characteristics of the Mortgage Loans (including the Subsequent Mortgage Loans), satisfy the parameters set forth in Exhibit S hereto.
(c) The Seller, the Depositor, the Custodian and the Trustee shall comply with their respective obligations set forth in Sections 2.01, 2.02, 2.04 and 2.05 with respect to the Subsequent Mortgage Loans delivered on each Subsequent Transfer Date. References in such Sections to the Initial Mortgage Loans or Mortgage Loans shall be deemed to refer to the Subsequent Mortgage Loans and references to the Cut-Off Date or the Closing Date, as applicable, shall be deemed to refer to the applicable related Cut-Off Date or Subsequent Transfer Date, respectively, except that references to 360 days after the Closing Date shall remain unchanged as shall representations made with specific reference to the Initial Mortgage Loans.
Shared Transport The Shared Transport Network Element (“Shared Transport”) provides the collective interoffice transmission facilities shared by various Carriers (including Qwest) between end-office switches and between end-office switches and local tandem switches within the Local Calling Area. Shared Transport uses the existing routing tables resident in Qwest switches to carry the End User Customer’s originating and terminating local/extended area service interoffice Local traffic on the Qwest interoffice message trunk network. CLEC traffic will be carried on the same transmission facilities between end- office switches, between end-office switches and tandem switches and between tandem switches on the same network facilities that Qwest uses for its own traffic. Shared Transport does not include use of tandem switches or transport between tandem switches and end-office switches for Local Calls that originate from end users served by non- Qwest Telecommunications Carriers (“Carrier(s)”) which terminate to QLSP End Users.
Negotiated Transaction The provisions of this Agreement were negotiated by the parties hereto, and this Agreement shall be deemed to have been drafted by all of the parties hereto.
Unbundled Copper Loop – Non-Designed (UCL-ND 2.4.3.1 The UCL–ND is provisioned as a dedicated 2-wire metallic transmission facility from BellSouth’s Main Distribution Frame to a customer’s premises (including the NID). The UCL-ND will be a “dry copper” facility in that it will not have any intervening equipment such as load coils, repeaters, or digital access main lines (“DAMLs”), and may have up to 6,000 feet of bridged tap between the end user’s premises and the serving wire center. The UCL-ND typically will be 1300 Ohms resistance and in most cases will not exceed 18,000 feet in length, although the UCL-ND will not have a specific length limitation. For loops less than 18,000 feet and with less than 1300 Ohms resistance, the loop will provide a voice grade transmission channel suitable for loop start signaling and the transport of analog voice grade signals. The UCL-ND will not be designed and will not be provisioned with either a DLR or a test point.
2.4.3.2 The UCL-ND facilities may be mechanically assigned using BellSouth’s assignment systems. Therefore, the Loop Make Up process is not required to order and provision the UCL-ND. However, Lightyear can request Loop Make Up for which additional charges would apply.
2.4.3.3 At an additional charge, BellSouth also will make available Loop Testing so that Lightyear may request further testing on the UCL-ND. Rates for Loop Testing are as set forth in Exhibit B of this Attachment.
2.4.3.4 UCL-ND loops are not intended to support any particular service and may be utilized by Lightyear to provide a wide-range of telecommunications services so long as those services do not adversely affect BellSouth’s network. The UCL-ND will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the loop to the customer’s inside wire.
2.4.3.5 Order Coordination (OC) will be provided as a chargeable option and may be utilized when the UCL-ND provisioning is associated with the reuse of BellSouth facilities. Order Coordination -Time Specific (OC-TS) does not apply to this product.
2.4.3.6 Lightyear may use BellSouth’s Unbundled Loop Modification (ULM) offering to remove bridge tap and/or load coils from any loop within the BellSouth network. Therefore, some loops that would not qualify as UCL-ND could be transformed into loops that do qualify, using the ULM process.
Interested Transactions An Indemnitee shall not be denied indemnification in whole or in part under this Section 7.7 because the Indemnitee had an interest in the transaction with respect to which the indemnification applies if the transaction was otherwise permitted by the terms of this Agreement.
Affiliated Transactions The Company shall cause each of the Initial Stockholders to agree that, in order to minimize potential conflicts of interest which may arise from multiple affiliations, the Initial Stockholders will present to the Company for its consideration, prior to presentation to any other person or company, any suitable opportunity to acquire an operating business, until the earlier of the consummation by the Company of a Business Combination, the liquidation of the Company or until such time as the Initial Stockholders cease to be an officer or director of the Company, subject to any pre-existing fiduciary or contractual obligations the Initial Stockholders might have.
Unbundled Copper Loop – Designed (UCL-D) 2.4.2.1 The UCL-D will be provisioned as a dry copper twisted pair (2- or 4-wire) Loop that is unencumbered by any intervening equipment (e.g., filters, load coils, range extenders, digital loop carrier, or repeaters).
2.4.2.2 A UCL-D will be 18,000 feet or less in length and is provisioned according to Resistance Design parameters, may have up to 6,000 feet of bridged tap and will have up to 1300 Ohms of resistance.
2.4.2.3 The UCL-D is a designed circuit, is provisioned with a test point, and comes standard with a DLR. OC is a chargeable option for a UCL-D; however, OC is always required on UCLs where a reuse of existing facilities has been requested by Telepak Networks.
2.4.2.4 These Loops are not intended to support any particular services and may be utilized by Telepak Networks to provide a wide-range of telecommunications services as long as those services do not adversely affect BellSouth’s network. This facility will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the Loop to the customer’s inside wire.
2.4.2.5 Upon the Effective Date of this Agreement, Unbundled Copper Loop – Long (UCL-L) elements will no longer be offered by BellSouth and no new orders for UCL-L will be accepted. Any existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement will be grandfathered at the rates set forth in the Parties’ interconnection agreement that was in effect immediately prior to the Effective Date of this Agreement. Existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement may remain connected, maintained and repaired according to BellSouth’s TR73600 and may remain connected until such time as they are disconnected by Telepak Networks or BellSouth provides ninety
Unbundled Copper Sub-Loop (UCSL) is a copper facility of any length provided from the cross-box in the field up to and including the end-user’s point of demarcation. If available, this facility will not have any intervening equipment such as load coils between the end-user and the cross-box.
